Search

Thallium-based cuprates are known to exhibit high critical temperatures and currents. Usually, partial substitution of copper by transition elements leads to the suppression of superconducting properties. This contribution reports on the studies of Tl2Ba2Ca2Cu3-xCoxOy. All specimens were found to be superconductors with critical temperatures of 102.4 K, 112.9 K, 112.2 K, 113.5 K, 112.8 K, and 94.8 K for x = 0.005, 0.010, 0.020, 0.030, 0.040, and 0.050, respectively. The samples were characterised by scanning electron microscopy, X-ray diffraction, AC susceptibility, resistance, and vibrating sample magnetometry.

In this study the layered double hydroxide (LDH) with Mg:Al molar ratio of 2:1 synthesized using co-precipitation method was impregnated with iron oxide particles (10 and 25 wt% loading). The calcined and uncalcined composites application for As(V) removal from aqueous solutions was studied. The XRD, Mossbauer spectroscopy, SEM and vibrating sample magnetometry studies confirmed the presence of superparamagnetic maghemite (γ-Fe2O3) particles having the size of ∼30 nm on the LDH surface. The FTIR studies revealed co-intercalation of carbonates and sulfates in the interlayer space of LDH. The composites showed outstanding As(V) adsorption properties. For the calcined composites a slightly higher adsorption capacity was observed which was connected with incorporation of As(V) anions into interlayer space during LDH structure reconstruction. Moreover the experiments of As(V) removal at low concentrations (3.75–0.37 mg/L) showed high selectivity and efficiency in As(V) removal, when LDH was impregnated with iron oxide particles (

Halloysite containing composites impregnated with Fe oxide particles (10 and 25% loading) were synthesized by co-precipitation method. The obtained uncalcined and calcined materials were tested for aqueous As(V) removal in different experimental conditions. The experiments were designed to test both the material’s adsorption capacity and the mechanisms responsible for As(V) removal. The XRD, Mossbauer spectroscopy, FTIR and SEM results revealed that Fe oxides formed during the synthesis were superparamagnetic maghemite (γ-Fe 2 O 3 ) nanoparticles with approximate size of 20 nm. Their presence as well as their homogenous distribution induced a strong response of the composites to the applied magnetic field, enabling magnetic separation of the adsorbents. The impregnation with Fe oxide particles resulted in an increase of surface area and changes of porosity. The As(V) adsorption studies revealed, that the material impregnated with Fe oxide exhibited higher adsorption capacity, than the starting mineral sample. Moreover the highest adsorption capacity of 180 mmol/kg was noticed for calcined composites. In order to better understand the As(V) adsorption mechanisms, the effect of pH and ionic strength was investigated as well as desorption, and the XPS studies were applied. The results revealed the formation of inner-sphere complexes between As(V) and composites surface as well as As(V) reduction coupled with Fe(II) oxidation as the main removal mechanisms. The chemisorption had a significant impact on the mineral support structure by increasing its stiffness as indicated by Mossbauer spectroscopy. The studied composites showed high stability in a broad pH range, measured as As, Si, Al and Fe release, which enables their use in environmental applications.

This article details the solid-state synthesis of high-temperature superconducting YBa2Cu3O7−x. Tests were carried out on samples formed at different pressures (200, 400, 600 and 800 MPa) before being annealed under pure oxygen. The X-ray diffraction method showed that, regardless of the forming pressure, the samples contain about 97 wt.% of Y-123 phase. SEM images showed a polycrystalline structure of samples of similar grain size and number of pores (intergranular spaces). The values of critical temperatures (Tc0), determined from magnetoresistance measurements, are about 91.5 K for all samples, and the Tc0 temperatures do not depend on sample-forming pressure. Magnetoresistance measurements have shown that samples formed with higher pressures exhibit smaller changes in Tc0 and superconducting transition width ΔT due to the influence of the HDC magnetic field, than the samples formed with lower pressures. Values of specific resistance determined by the use of van der Pauw method at 300 K is about 2 mΩcm for all samples. The critical temperatures (T cintra) of grains and critical current densities at 77 K were determined from AC magnetic susceptibility measurements, and they are about 91.6 K and 400 A cm−2, respectively.

The temperature dependencies of the magnetoresistance of Bi 1.6 Pb 0.4 Sr 2 Ca 2 Cu 3 O x bulk superconductor were measured within the transition from normal to the superconducting state. The critical temperature of the sample was found to be T c50% = 107.1 K. The thermal fluctuations were studied using the following formula of conductance: Δ σ = K e − λ where e = ( T − T c )/ T c , λ is the critical exponent and K is a constant. The critical exponents in the transition region were determined and their magnetic field dependencies were analysed. The crossovers from 1D to 3D and from 3D to 1D dimensional fluctuations were found within the regions of transition from the normal to the superconducting state.

The magnetoresistance and irreversibility fields of commercial bismuth-based 1G tape were studied on the basis of the temperature dependencies of the magnetoresistance at the two relative orientations of magnetic field and superconductor plane. The critical temperatures of this tape are the following: T c50 % = 110.3 K and T c0 = 109.9 K, and the width of superconducting transition is ΔT = 0.5 K. The widths of the transition to the superconducting state versus applied magnetic fields were derived for both orientations. The experimental data were fitted using the formula ΔT = C H m + ΔT 0. The irreversibility field values were obtained and successfully fitted as a function of temperature. At 77 K, they were found to amount to H i r r = 72.8 kOe and H i r r = 5.5 kOe for the parallel and perpendicular directions, respectively.

Results of X-ray absorption spectroscopy study on Gd doped (Tl 0.5 Pb 0.5 )Sr 2 (Ca 1− x Gd x )Cu 2 O z . ( x =0.1, 0.2 and 0.3) superconductors are reported. The Gd L 3 absorption edges were studied in the XANES (near-edge) region and in the EXAFS (extended X-ray absorption) region. The XANES spectra are typical for Gd in oxide compounds with the absorption edge followed by a strong “white line” peak which slightly decreases its intensity with increasing Gd content x . The Fourier transformed EXAFS spectra reveal two well resolved peaks corresponding to the oxygen nearest neighbours and the cation next neighbour shell, respectively. From simulations and of the EXAFS spectra to the structure of the host 1212 compound the location site of gadolinium is determined and its possible influence on the local structural environment of the site is analyzed.

The magnetic eld penetration depth into YBa2Cu3Ox lm on polycrystalline Ag substrate with the critical temperature of 90.4 K was determined from the AC susceptibility measurements. The 95 μm thick YBCO lm was deposited directly on Ag substrate by the sedimentation process. When the sample is in the Meissner state, the dispersive component of the AC susceptibility as well as its temperature dependence re ects the changes of the penetration depth with the temperature. The penetration depth of this lm is found to be 5.4 μm.

The critical currents of commercial bismuth based superconducting tape were determined in the two ways. In the rst one the transport critical current density was measured by the four points method using the dc current power supply at the liquid nitrogen temperature. In the second one the critical current densities were obtained from the absorption part of ac susceptibility measurements using the Bean model near the critical temperature. The temperature dependence of the critical current densities was tted to take advantage of the Ginzburg Landau strong-coupling limit approach. Using the t parameters the critical current density at 77 K was calculated. The critical temperature of this tape (Tc = 110.5 K) was determined from the ac susceptibility measurements.

Superconducting (Tl 0.5 Pb 0.5 )(Sr 0.85 Ba 0.15 ) 2 Ca 2 Cu 3 O 2 films were prepared on highly polished, untextured silver substrates. A superconducting transition temperature (T c ) of 114.9 ± 0.1 K was obtained from the resistivity versus temperature measurements for different applied ac currents. The temperature dependence of the critical current was fitted with a power law: J c (T) = J c (0)[1-T/T c ] n with n = 2. The critical current in self-field at 77 K was found to be 8 x 10 3 A/cm 2 . The temperature dependence of the real and imaginary parts of ac susceptibility was measured for different amplitudes of ac magnetic field. Only a small differences of the ac susceptibility for parallel and perpendicular fields with respect to the film surface were observed.

Polycrystalline samples of YBa2Cu3O7 were studied by the microwave absorption technique at the low magnetic fields in the temperature range from 5 to 80 K. The direct microwave absorption and the field modulated microwave absorption were measured at 77 K. Analysis of the microwave absorption curves indicates that the field penetration into the sample starts from the lowest values of applied magnetic field within the whole temperature range.

The YBa2Cu3Oδ lms were obtained directly on silver substrates by the sedimentation processes. The thicknesses of these lms are of the order of several tens μ. The temperature dependences of the AC susceptibility of the lms were measured and analyzed. The critical temperatures of these specimens obtained from the dispersion part of AC susceptibility vary from 89.2 K to 92.5 K. The critical currents were calculated from the absorption part of AC susceptibility using the Bean model. The temperature dependences of the critical currents were tted using the Ginzburg Landau strong coupling limit approach.

M. Chrobak, W.M. Woch, G. Szwachta, R. Zalecki, Š. Gondek, A. Koaodziejczyk and J. Kusi«ski Solid State Physics Department, Faculty of Physics and Applied Computer Science, AGH University of Science and Technology, al. A. Mickiewicza 30, 30-059 Krakow, Poland Department of Surface Engineering and Materials Characterization, Faculty of Metals Engineering and Industrial Computer Science, AGH University of Science and Technology, al. A. Mickiewicza 30, 30-059 Krakow, Poland Academic Centre for Materials and Nanotechnology, AGH University of Science and Technology, al. A. Mickiewicza 30, 30-059 Krakow, Poland

The magnetoresistance, irreversibility fields, and critical current density were studied for a commercial 2G tape at the two relative orientations of magnetic field and superconductor plane. The critical temperatures of this tape of T c50 % = 91.5 K and T c0 = 90 K and the width of superconducting transition of ΔT = 1.5 K were obtained. The widths of the transition from the normal to the superconducting state do not increase at the applied magnetic field up to 90 kOe and do not depend on the orientation of the magnetic field with respect to the tape plane. The irreversibility field values were obtained and successfully fitted as a function of temperature using the formula: $H_{\text {irr}} =H_{\text {irr0}} \left ({1-\frac {T}{T_{\text {c0}} }} \right )^{n}$ . The irreversibility fields show an anisotropy, and at the liquid nitrogen temperature, they reach H irr = 430 kOe and H irr = 106 kOe for the parallel and perpendicular directions, respectively. The anisotropy ratio amounts to γ = 4 at 77 K and is small in comparison with other high-temperature superconducting materials. The critical current density of this tape was found to be of the order of 106 A cm−2 at 77 K in the self-magnetic field.