Search

Abstract Background The focus of triticale breeding in the southern Great Plains of the United States has been to increase forage yield for autumn–winter seasons when most other forage species are dormant. This study aims to estimate the trends of seasonal yield changes over time. Methods Yield trials had been conducted in a randomized complete block design for up to two decades. Seasonal yield changes over time were estimated using linear regression analysis. Results The analysis revealed a significant positive relation between autumn forage yield (relative to common checks) and calendar years when the trials were conducted. The estimated improvement of autumn forage yield was about 1.9% per year on medium and heavy soil at Ardmore, Oklahoma, and about 5.4% per year on light soil at Burneyville, Oklahoma. However, winter forage yield change was minimal and the spring forage yield increase was negative, although this decline was not significant. Total forage yield improvements were about 0.6% and 0.7% per year at Ardmore and Burneyville, respectively. Similar results were also observed when years of cultivars' introduction were used instead. Conclusions The results indicate a significant gain in autumn forage yield, but a minor gain in the total forage yield due to the yield tradeoff between the autumn and spring seasons.

It is crucial to develop functional electronic materials that can be processed from green solvents to achieve environmentally sustainable and cost‐efficient printing fabrication of organic electronic devices. Here, the design and cost‐efficient synthesis of two hydrophilic and emissive conjugated polymers, TQ‐OEG and TQ2F‐OEG, are presented, which are rendered hydrophilic through the grafting of oligo(ethylene glycol) (OEG) solubilizing groups onto the thiophene‐quinoxaline conjugated backbone and thereby can be processed from a water:ethanol solvent mixture. The results show that the introduction of the OEG groups enables for a direct dissolution of salts by the neat polymer for the attainment of solid‐state ion mobility. These properties are utilized for the design and development of light‐emitting electrochemical cells (LECs), the active materials of which can be solution cast from a water:ethanol‐based ink. It is specifically shown that such an LEC device, comprising an optimized blend of the TQ2F‐OEG emitter and a Li salt as the active material positioned between two air‐stabile electrodes, delivers deep‐red emission (peak wavelength = 670 nm) with a radiance of 185 µW m−2 at a low drive voltage of 2.3 V. This study contributes relevant information as to how polymers and LEC devices can be designed and fabricated to combine functionality with sustainability. [ABSTRACT FROM AUTHOR]

Heat stress during the seedling stage of early-planted winter wheat (Triticum aestivum L.) is one of the most abiotic stresses of the crop restricting forage and grain production in the Southern Plains of the United States. To map quantitative trait loci (QTLs) and identify single-nucleotide polymorphism (SNP) markers associated with seedling heat tolerance, a genome-wide association mapping study (GWAS) was conducted using 200 diverse representative lines of the hard red winter wheat association mapping panel, which was established by the Triticeae Coordinated Agricultural Project (TCAP) and genotyped with the wheat iSelect 90K SNP array. The plants were initially planted under optimal temperature conditions in two growth chambers. At the three-leaf stage, one chamber was set to 40/35°C day/night as heat stress treatment, while the other chamber was kept at optimal temperature (25/20°C day/night) as control for 14 days. Data were collected on leaf chlorophyll content, shoot length, number of leaves per seedling, and seedling recovery after removal of heat stress treatment. Phenotypic variability for seedling heat tolerance among wheat lines was observed in this study. Using the mixed linear model (MLM), we detected multiple significant QTLs for seedling heat tolerance on different chromosomes. Some of the QTLs were detected on chromosomes that were previously reported to harbor QTLs for heat tolerance during the flowering stage of wheat. These results suggest that some heat tolerance QTLs are effective from the seedling to reproductive stages in wheat. However, new QTLs that have never been reported at the reproductive stage were found responding to seedling heat stress in the present study. Candidate gene analysis revealed high sequence similarities of some significant loci with candidate genes involved in plant stress responses including heat, drought, and salt stress. This study provides valuable information about the genetic basis of seedling heat tolerance in wheat. To the best of our knowledge, this is the first GWAS to map QTLs associated with seedling heat tolerance targeting early planting of dual-purpose winter wheat. The SNP markers identified in this study will be used for marker-assisted selection (MAS) of seedling heat tolerance during dual-purpose wheat breeding.

Triticale (×Triticosecale Wittmack) is a man-made species developed by crossing wheat (Triticum spp.) and rye (Secale cereale L.). It incorporates favorable alleles from both progenitor species (wheat and rye), enabling adaptation to environments that are less favorable for wheat yet providing better biomass yield and forage quality. Triticale has huge potential for both grain and forage production, though research to improve the crop for better adaptation and grain quality is lagging behind that of other small grains. It is also gaining popularity as a cover crop to improve soil health and reduce nutrient leaching. Because of its genetic and flower structure, triticale is suitable for both line and hybrid breeding methods. Advances in the areas of molecular biology and the wealth of genomic resources from both wheat and rye can be exploited for triticale improvement. Gene mapping and genomic selection will facilitate triticale breeding by increasing selection precision and reducing time and cost. The objectives of this review are to summarize current triticale production status, breeding, and genetics research achievements and to highlight gaps for future research.

Oat (Avena sativa L.) is one of the most important forage crops in the Southern Great Plains of the United States. However, it is more sensitive to cold stress than other small grains. In this study, diverse oat germplasm was evaluated for winter survival across multiple years and locations in the region. Field screening started with an observation trial of 1,861 diverse genotypes in the 2012–2013 season and was followed by four seasons of replicated trials from 2013 to 2017. Selection of good winter survivors was started in 2014–2015 season. All trials were laid out in randomized complete blocks with replications of two in 2013–2014 and 2014–2015, four in 2015–2016, and three in 2016–2017. Winter survival was scored in a 1‐to‐9 scale. Data were analysed for each year and location separately. Additive main effects and multiplicative interaction (AMMI) analysis were carried out on combined data of 35 genotypes that were commonly grown in each year and location. Highly significant (p < 0.001) variations were observed among genotypes, environments and genotype‐by‐environment interaction (GEI). The first three interaction principal components (IPCs) were highly significant (p < 0.001), explaining 96% of GEI. Broad sense heritability ranged from 46% to 93%, while heritability for all environments combined was relatively low (24.6%). At the end of the two cycles (2014/2015‐to‐2016/2017) of selection, mean winter survival was improved by more than 38% per cycle compared with the base population mean. Genotypes CIav 4390, CIav 6909 and CIav 7618 showed significantly higher winter survival than the standard checks Okay and Dallas. Genotypes CIav 4390 showed 20% and 35% improvement over the standard checks Okay and Dallas, respectively. Winter survival improvement in oat will remain a difficult task because of high GEI and low heritability. The identified superior genotypes will be used as crossing parents to transfer cold tolerance genes to other elite lines. [ABSTRACT FROM AUTHOR]

Heat stress during the seedling stage of early-planted winter wheat (Triticum aestivum L.) is one of the most abiotic stresses of the crop restricting forage and grain production in the Southern Plains of the United States. To map quantitative trait loci (QTLs) and identify single-nucleotide polymorphism (SNP) markers associated with seedling heat tolerance, a genome-wide association mapping study (GWAS) was conducted using 200 diverse representative lines of the hard red winter wheat association mapping panel, which was established by the Triticeae Coordinated Agricultural Project (TCAP) and genotyped with the wheat iSelect 90K SNP array. The plants were initially planted under optimal temperature conditions in two growth chambers. At the three-leaf stage, one chamber was set to 40/35°C day/night as heat stress treatment, while the other chamber was kept at optimal temperature (25/20°C day/night) as control for 14 days. Data were collected on leaf chlorophyll content, shoot length, number of leaves per seedling, and seedling recovery after removal of heat stress treatment. Phenotypic variability for seedling heat tolerance among wheat lines was observed in this study. Using the mixed linear model (MLM), we detected multiple significant QTLs for seedling heat tolerance on different chromosomes. Some of the QTLs were detected on chromosomes that were previously reported to harbor QTLs for heat tolerance during the flowering stage of wheat. These results suggest that some heat tolerance QTLs are effective from the seedling to reproductive stages in wheat. However, new QTLs that have never been reported at the reproductive stage were found responding to seedling heat stress in the present study. Candidate gene analysis revealed high sequence similarities of some significant loci with candidate genes involved in plant stress responses including heat, drought, and salt stress. This study provides valuable information about the genetic basis of seedling heat tolerance in wheat. To the best of our knowledge, this is the first GWAS to map QTLs associated with seedling heat tolerance targeting early planting of dual-purpose winter wheat. The SNP markers identified in this study will be used for marker-assisted selection (MAS) of seedling heat tolerance during dual-purpose wheat breeding. [ABSTRACT FROM AUTHOR]

Triticale (× Triticosecale Wittmack) is a man-made species developed by crossing wheat (Triticum spp.) and rye (Secale cereale L.). It incorporates favorable alleles from both progenitor species (wheat and rye), enabling adaptation to environments that are less favorable for wheat yet providing better biomass yield and forage quality. Triticale has huge potential for both grain and forage production, though research to improve the crop for better adaptation and grain quality is lagging behind that of other small grains. It is also gaining popularity as a cover crop to improve soil health and reduce nutrient leaching. Because of its genetic and flower structure, triticale is suitable for both line and hybrid breeding methods. Advances in the areas of molecular biology and the wealth of genomic resources from both wheat and rye can be exploited for triticale improvement. Gene mapping and genomic selection will facilitate triticale breeding by increasing selection precision and reducing time and cost. The objectives of this review are to summarize current triticale production status, breeding, and genetics research achievements and to highlight gaps for future research. [ABSTRACT FROM AUTHOR]

Wheat (Triticum spp.) stem rust, caused by Puccinia graminis f. sp. tritici Eriks. and E. Henn. (Pgt), re-emerged as a devastating disease of wheat because of virulent race Ug99 (TTKSK). Many bread wheat (T. aestivum L.) cultivars grown in North America are susceptible to Ug99 or its derivative races that carry additional virulence. 'Gage' was released in 1963 mainly for its excellent field resistance to leaf rust (caused by Puccinia triticina Eriks) and stem rust. However, Gage's resistance has not been genetically characterized, which would facilitate its use in breeding programs. To better define the nature of the resistance in Gage, we created an F2 population and the corresponding F2:3 and F4:5 families from crosses between Gage and stem rust susceptible cultivar 'Bill Brown'. Inheritance of resistance to Pgt race QFCSC and molecular marker analysis indicated that Sr2 and additional genes explain the stem rust resistance of Gage. Using seedling plant infection types from the F2, F2:3, and F4:5 families, we found that at least one dominant and, most likely, one recessive gene are involved in Gage's resistance. Seedling resistance genes acted independently of Sr2 since Sr2 is effective only at the adult plant stage. [ABSTRACT FROM AUTHOR]