Search

INTRODUCTION: The COVID-19 pandemic and the associated restrictions may have modified the activities of the Swiss population and thus altered trauma patterns. MATERIALS AND PATIENTS: All adult patients with major trauma admitted to our institution in 2019 and 2020 were assessed using the Injury Severity Score (ISS), by body region involved, type of injury, age, admission to an intensive care unit and 30-day mortality. RESULTS: In 2020, 454 patients with major trauma were admitted to our institution, 17% fewer than in the previous year. The drop in the number of major trauma patients proceeded with and overlapped both the first and second peaks in incidence of the pandemic and the associated restrictions. The median ISS was higher in 2020 (25, interquartile range [IQR] 17—26.5) than in 2019 (22, IQR 16—26, p = 0.04). There were no significant differences in body region involved, type of injury or age (p >0.05). In 2020, a higher percentage of patients were admitted to an intensive care unit (86.5% vs 77.7%, p

Recent years have witnessed a dynamic development of mammary gland imaging techniques, particularly ultrasonography and magnetic resonance imaging. A challenge related to these studies is the increase in the precision of the anatomical assessment of breast, particularly for early detection of subclinical lesions, performance of ultrasound-guided biopsy procedures, and accurate preoperative location of pathological lesions so as to optimize the surgical treatment. Ultrasound imaging is a primary and baseline diagnostic procedure the patient with suspected pathological lesions within breast is referred to by the surgeon. Lesions visualized in ultrasound scans are classifi ed according to the BI-RADS US assessment categories. The successive categories (2 through 6) encompass individual pathological lesions, estimating the risk of malignancy and provide guidelines for further diagnostic and therapeutic management. This article described the important aspects of ultrasonographic imaging of focal lesions within the breasts as signifi cant from the standpoint of surgical treatment of patients falling within BI-RADS US categories 3, 4, 5, and 6. Attention is drawn to the importance of ultrasound scans in the assessment of axillary fossa lymph nodes before the decision regarding the surgical treatment.

Burnishing of metal surfaces can affect positively tribological and mechanical properties such as fatigue strength, wear resistance, contact stiffness and bearing capacity. Burnishing affects the entire surface topography, including surface roughness, radii of curvature of peaks and valleys, slope angles and more. We have studied A1Mg1SiCu (6xxx series) aluminum matrix composites with a reinforcing phase of Al2O3 which exhibits good workability but poor machinability. The second series studied was based on an AlSi alloy (A-390) reinforced with SiC – this one characterized by poor workability but good machinability. Materials have been prepared by mixing metal powders with the reinforcement, cold pressing, sintering, hot extrusion and heat treatment. We have determined surface roughness with a Hommel tester; the arithmetical mean for A1Mg1SiCu (A6061 + Al2O3) was ~1 µm before burnishing and ~0.15 mm after burnishing. We have also determined the bearing capacity at 50 % with the same tester: before burnishing 2.30 µm and 0.47 µm afterwards for A6061 + Al2O3; before 2.30 µm, afterwards 0.37 µm for A390 + SiC. Vickers microhardness at the surface with respect to the core increases 30 % for the Al2O3 containing composite and 50 % for the SiC containing composite.DOI: http://dx.doi.org/10.5755/j01.ms.19.4.2404