Search

We report Global Positioning System (GPS) measurements of postseismic deformation following the 2015 Mw7.8 Gorkha (Nepal) earthquake, including previously unpublished data from 13 continuous GPS stations installed in southern Tibet shortly after the earthquake. We use variational Bayesian Independent Component Analysis (vbICA) to extract the signal of postseismic deformation from the GPS time series, revealing a broad displacement field extending >150 km northward from the rupture. Kinematic inversions and dynamic forward models show that these displacements could have been produced solely by afterslip on the Main Himalayan Thrust (MHT) but would require a broad distribution of afterslip extending similarly far north. This would require the constitutive parameter (a − b)σ to decrease northward on the MHT to ≤0.05 MPa (an extreme sensitivity of creep rate to stress change) and seems unlikely in light of the low interseismic coupling and high midcrustal temperatures beneath southern Tibet. We conclude that the northward reach of postseismic deformation more likely results from distributed viscoelastic relaxation, possibly in a midcrustal shear zone extending northward from the seismogenic MHT. Assuming a shear zone 5–20 km thick, we estimate an effective shear‐zone viscosity of ~3·1016–3·1017 Pa·s over the first 1.12 postseismic years. Near‐field deformation can be more plausibly explained by afterslip itself and implies (a − b)σ ~ 0.5–1 MPa, consistent with other afterslip studies. This near‐field afterslip by itself would have re‐increased the Coulomb stress by ≥0.05 MPa over >30% of the Gorkha rupture zone in the first postseismic year, and deformation further north would have compounded this reloading. Key Points: New GPS data show that postseismic deformation of the 2015 Mw7.8 Gorkha (Nepal) earthquake extended far northward into southern TibetKinematic and dynamic models suggest that the northward reach of deformation likely reflects the influence of viscoelastic relaxationAfterslip likely dominated postseismic deformation in the near field, transferring stress back to the (relocked) Gorkha rupture zone [ABSTRACT FROM AUTHOR]

The Haiyuan fault is a major left‐lateral strike‐slip fault at the boundary between northeast Tibet and the Gobi platform. Combining measurements of offset alluvial terraces with 10Be‐26Al cosmogenic radionuclides dating, we bracket the late Quaternary slip rate along the Hasi Shan fault section (37°00′N, 104°25′E) of the Haiyuan fault. At our reference site, terrace‐riser offsets for five successive terraces range from ~5 to ~200 m, and associated cosmogenic radionuclide ages range from 9 ± 3 to 44 ± 7 kyr. These measurements yield a geological slip rate between 2.7 and 3.0 mm/year. Extending the offset measurements to the entire Hasi Shan front, it yields a slip rate of 3.2 ± 0.2 mm/year over the last ~50 kyr. Our rate is consistent with the lower estimates of other long‐term rates of 4 to 5 mm/year, as well as with geodetic rates of 3 to 5 mm/year, determined in the same area. About 150 km farther west, however, Holocene terraces and moraines offsets have suggested higher slip rate values, between 6 and 15 mm/year. We interpret such discrepancy between rates determined along the western section of the Haiyuan fault and rates determined in the Hasi Shan section as being related to the complex geometry of the Haiyuan fault system along its eastern part, with several active strands moving at the same time and resulting in distributed slip among several sections of the fault system. Key Points: Slip rate along the Hasi Shan section of the Haiyuan fault is determined from numerous offsets and cosmogenic exposure dates over a period of 50,000 yearsThe Hasi Shan fault strand horizontal slip rate is about 3.2 mm/year; this rate is stable over 50,000 years; the uplift rate is about 0.5 mm/yearCombining slip rate for the Hasi Shan strand and all subparallel stands yields a slip rate of 5 to 7 mm/year for the Haiyuan fault system [ABSTRACT FROM AUTHOR]

Abstract: The M s 8.0, Wenchuan earthquake, which devastated the mountainous western rim of the Sichuan basin in central China, produced a surface rupture over 200 km-long with oblique thrust/dextral slip and maximum scarp heights of ~10 m. It thus ranks as one of the world''s largest continental mega-thrust events in the last 150 yrs. Field investigation shows clear surface breaks along two of the main branches of the NE-trending Longmen Shan thrust fault system. The principal rupture, on the NW-dipping Beichuan fault, displays nearly equal amounts of thrust and right-lateral slip. Basin-ward of this rupture, another continuous surface break is observed for over 70 km on the parallel, more shallowly NW-dipping Pengguan fault. Slip on this latter fault was pure thrusting, with a maximum scarp height of ~3.5 m. This is one of the very few reported instances of crustal-scale co-seismic slip partitioning on parallel thrusts. This out-of-sequence event, with distributed surface breaks on crustal mega-thrusts, highlights regional, ~EW-directed, present day crustal shortening oblique to the Longmen Shan margin of Tibet. The long rupture and large offsets with strong horizontal shortening that characterize the Wenchuan earthquake herald a re-evaluation of tectonic models anticipating little or no active shortening of the upper crust along this edge of the plateau, and require a re-assessment of seismic hazard along potentially under-rated active faults across the densely populated western Sichuan basin and mountains. [Copyright &y& Elsevier]

Fluvial erosion of small mountain belts is widely represented as a wave of upstream migration of knickpoints, starting from a stationary boundary of a high topography created by increased rock uplift rates. However, fluvial erosion remains poorly constrained when orogens expand in width with their boundaries continuously advancing towards the foreland. Here we propose a simple analytical solution for a laterally expanding orogen dominated by fluvial erosion, and apply it to the propagation of Eastern Tibet where the plateau margin is characterized by widespread low-relief surfaces incised by steep river valleys. Our analytical solution is based on the assumption that the topography of Eastern Tibet was built by high uplift rates located in a belt along the plateau margins migrating outwards during plateau growth, as well as carved by erosion of large rivers originating from the interior of the plateau. We validate our analytical solution by comparing it to numerical models and various types of data from five large rivers in Eastern Tibet (Salween, Mekong, Yangtze, Yalong, and Dadu Rivers). The results show that the models with optimized parameter values are generally consistent with the observed river-profile morphologies, exhumation magnitudes, and low-temperature thermochronometric ages. Our results show that the long-term fluvial erosion in Eastern Tibet features mainly a downstream migration of high erosion rates, which is fundamentally different from the headward erosion of most of small mountain rivers. The analytical solutions also predict a characteristic maximum plateau size set by the balance between the horizontal propagating velocity of plateau growth and the bedrock erodibility. The characteristics described by our simple analytical solution may represent a common pattern of outward growing mountains and plateaus in tectonically active regions on Earth. • A new analytical solution for laterally growth orogen dominated by fluvial erosion. • We validate analytical solution by comparing it to observations in Eastern Tibet. • Erosion in Eastern Tibet features mainly downstream migration of high erosion rates. • Plateau erosion is different from headward erosion of most small mountain rivers. • The analytical solution also predicts a characteristic maximum plateau size. [ABSTRACT FROM AUTHOR]

High-elevation, low-relief surfaces are widespread in many mountain belts. However, the origin of these surfaces has long been debated. In particular, the southeast Tibetan Plateau has extensive low-relief surfaces perched above deep valleys and in the headwaters of three of the world's largest rivers (Salween, Mekong, and Yangtze Rivers). Various geologic data and geodynamic models show that many mountain belts grow first to a certain height and then laterally in an outward propagation sequence. By translating this information into a kinematic propagating uplift function in a landscape evolution model, we propose that the high-elevation, low-relief surfaces in the southeast Tibetan Plateau are simply a consequence of mountain growth and do not require a special process to form. The propagating uplift forms an elongated river network geometry with broad high-elevation, low-relief headwaters and interfluves that persist for tens of millions of years, consistent with the observed geochronology. We suggest that the low-relief interfluves can be long-lived because they lack the drainage networks necessary to keep pace with the rapid incision of the large main-stem rivers. The propagating uplift also produces spatial and temporal exhumation patterns and river profile morphologies that match observations. Our modeling therefore reconciles geomorphic observations with geodynamic models of uplift of the southeast Tibetan Plateau, and it provides a simple mechanism to explain the low-relief surfaces observed in several mountain belts on Earth. [ABSTRACT FROM AUTHOR]