Search

We had already obtained the analytical solutions for the compression wave and steady-state oscillating flow in a pipe with a circular cross section [Sato Y, Kanki H. Formulas for compression wave and oscillating flow in circular pipe. To be published in Appl Acoust [accepted 11 Sept. 2006]]. This work contains three key-components. The first key is to simplify the formulas using the unique mathematic technique without losing the accuracy. Simplifying the formulas is the one of the most important factors for formulas used in engineering use. The results will enable us to greatly reduce the work and computation costs. The second is to verify the flow distribution calculated by our formulas. The third is to study the possibility of application of our method to the analysis in turbulent flow region. Kawata et al. have represented the validity of one-dimensional quasi-analysis in turbulent flow region, using the method of D’Souza et al. and the shear viscosity. Therefore, in this paper the validity of the analysis in a turbulence region was verified by proving theoretically that the methods of D’Souza et al. and ours are intrinsically equivalent. The proof of equivalence was accomplished using the formulas simplified in this paper.

The effectiveness of squeeze-film dampers in controlling vibrations in rotating machinery may be limited by the nonlinear interactions between large rotor imbalance forces with fluid-film forces induced by dampers operating in cavitated conditions. From a practical point of view, the occurrence of nonsynchronous and chaotic motion in rotating machinery is undesirable and should be avoided as they introduce cyclic stresses in the rotor, which in turn may rapidly induce fatigue failure. The bifurcations in the response of a rigid rotor supported by cavitated squeeze-film dampers resulting from such interactions are presented in this paper. The effects of design and operating parameters, namely the bearing parameter (B), gravity parameter (W), spring parameter (S) and unbalance parameter (U), on the bifurcations of the rotor response are investigated. Spring parameter (S) values between 0 and 1 are considered. A spring parameter value of S=0 represents the special case of dampers without centering springs. With the exception of the case S=1, jump phenomena appeared to be a common bifurcation that occurred at certain combinations of B, W and U irrespective of the value of S. Period-doubling and secondary Hopf bifurcations which occurred for low values of S (⩽0.3) were not observed for the higher values S⩾0.5. For very low stiffness values (S