Search

Al-Si-coated boron-alloyed steels are the most widely used press-hardened steels (PHSs), which offers good oxidation resistance during hot forming due to the presence of the near eutectic Al-Si coating. In this study, a recently developed novel un-coated oxidation resistant PHS, called coating-free PHS (CF-PHS), is introduced as an alternative to the commercial Al-Si coated PHSs. With tailored additions of Cr, Mn, and Si, the new steel demonstrates superior oxidation resistance with a sub-micron oxide layer after the conventional hot stamping process. Hence, it does not require shot blasting before the subsequent welding and E-coating process. Two CF-PHS grades have been developed with ultimate tensile strengths of approximately 1.2 and 1.7 GPa, respectively. Both grades have a total elongation of 8–9%, exceeding the corresponding Al-Si-coated PHS grades (1.0 GPa/6–7%, 1.5 GPa/6–7%). Furthermore, the bendability of CF-PHS was similar to the corresponding Al-Si PHS grades. On the other hand, performance evaluations relevant to automotive applications, such as weldability, the E-coat adhesion, and tailor-welded hot stamp door ring, were also conducted on the CF-PHS steel to satisfy the requirements of manufacturing. [ABSTRACT FROM AUTHOR]

The effect of testing temperatures on wear-induced austenite-martensite transformation and the resultant wear resistance in metastable austenite-containing steels remains unclear. This issue is addressed in the current study, wherein the wear behavior of medium Mn steel was studied using a ball-on-disk sliding test at 20 °C, 0 °C, −50 °C, and −120 °C. The results demonstrate that the strain hardening and toughness enhancement produced by metastable austenite in austenite-rich steel greatly reduce wear volume at low temperatures. The dominant wear mechanism thereby changes from grooving and ploughing to cutting compared with martensitic steel. The wear resistance of austenite-rich steel depends significantly on the thermal and mechanical stabilities of metastable austenite. This study provides the basis for the development of novel wear resistant steels with relatively low initial hardness applicated at low temperatures. • Effect of testing temperatures on austenite-martensite transformation and resultant abrasion behavior are presented. • Austenite transforms into martensite during wear, and the wear-induced transformation is highly dependent on temperatures. • The enhanced strain hardening and toughening lead to the decreased wear volume at low temperatures inaustenite-rich steel. • Thermal and mechanical stabilities of austenite significantly affect the wear resistance of austenite-rich steel. [ABSTRACT FROM AUTHOR]