Search

This paper considers a method for improving physical layer security of wireless networks with full-duplex radio. In particular, fast algorithms are developed to compute power allocations in subcarriers, subject to power and rate constraints, to maximize the secrecy capacity of a three-node network consisting of a source, a full-duplex destination, and an eavesdropper. A residual level of radio self-interference channel is considered. The optimal power allocation at the destination is found to be significant especially when its power budget is high. Also studied in this paper are a network with multiple full-duplex destinations and another network with multiple sources. Using the algorithms developed in this paper, we are able to show that a multiuser strategy that optimizes the power distributions among the users (in terms of either the sources or the destinations) can yield a substantial gain of secrecy capacity over a single-user strategy. [ABSTRACT FROM PUBLISHER]

One of the key challenges in wireless networking is allocating the available radio resources to maximize key service delivery parameters such as the aggregate throughput and the multimedia quality of experience (QoE). We propose a novel and effective scheduling policy that allocates resource blocks, such that interference power is shifted toward capacity-saturated users, while improving the throughput of unsaturated users. The highlight of this paper is that the proposed scheme can dramatically improve the performance of cells that have a high discrepancy in its signal-to-noise ratio (SNR) distribution, which is typical in urban areas. The results show that a free-lunch (FL) solution is possible, whereby for negligible performance degradation in the saturated users, a large improvement in the nonsaturated users can be obtained. However, on average, the number of FL user pairings is low. By relaxing the degradation constraints, the non-FL (NFL) solution can yield a greater multiuser throughput gain. Motivated by a surge in mobile multimedia traffic, we further demonstrate that the proposed scheduling may have a profound impact on both energy efficiency and QoE of multimedia service delivery. [ABSTRACT FROM PUBLISHER]

We present in this paper a novel proactive interference avoidance scheme for mobile-to-mobile (M2M) communication as an underlay in Long-Term Evolution (LTE) downlink networks. The proposed scheme introduces an intelligent user-selective resource allocation algorithm that aims to proactively avoid interference between M2M pairs and LTE regular users while achieving a satisfactory link budget for both M2M and LTE regular links. The proposed resource allocation algorithm is based on a novel low-complexity interference estimation approach that requires only channel quality indicator (CQI) information (CSI). Since the CQI reporting mechanism has been already implemented in current LTE systems, the proposed algorithm is indeed practical and standard compatible, compared with the existing works that require perfect knowledge of the channel state information (CSI). In this research, achievable data throughput with LTE-compliant adaptive modulation and coding has been adopted as the optimization measurement, rather than the information-theoretic capacity. Therefore, the performance of the proposed scheme is practically realizable in LTE communication systems. Since the performance of the proposed scheme highly relies on the accuracy of CQI feedback, we also carry out performance analysis to evaluate the impact of CQI estimation error and delay. The simulation results show that the total achievable data throughput for LTE networks is dramatically enhanced by M2M communication with this proposed interference avoidance resource allocation scheme. [ABSTRACT FROM PUBLISHER]

The cross-layer utility maximization problem, which is subject to stability constraints for a multicommodity wireless network where all links share the same number of orthogonal channels, is considered in this paper. We assume a time-slotted network, where the channel gains randomly change from one slot to another. The optimal cross-layer network control policy can be decomposed into the folloing three subproblems: 1) flow control; 2) next-hop routing and in -node scheduling; and 3) power and rate control, which is also known as resource allocation (RA). These subproblems span the layers from the physical layer to the transport layer. In every time slot, a network controller decides the amount of each commodity data admitted to the network layer, schedules different commodities over the network's links, and controls the power and rate allocated to every link in every channel. To fully exploit the available multichannel diversity, we consider the general case, where multiple links can be activated in the same channel during the same time slot, and the interference is controlled solely through power and rate control. Unfortunately, the RA subproblem is not yet amendable to a convex formulation, and in fact, it is NP-hard. The main contribution of this paper is to develop efficient RA algorithms for multicommodity multichannel wireless networks by applying complementary geometric programming and homotopy methods to analyze the quantitative impact of gains that can be achieved at the network layer in terms of end-to-end rates and network congestion by incorporating different RA algorithms. Although the global optimality of the solution cannot be guaranteed, the numerical results show that the proposed algorithms perform close to the (exponentially complex) optimal solution methods. Moreover, they efficiently exploit the available multichannel diversity, which provides significant gains at the network layer in terms of end-to-end rates and network congestion. In addition, the assessment of the improvement in performance due to the use of multiuser detectors at the receivers is provided. [ABSTRACT FROM PUBLISHER]

In this paper, we consider a wireless amplify-and-forward relay network with one relay node and multiple source-destination pairs/users and propose a pricing framework that enables the relay to set prices to maximize either its revenue or any desirable system utility. Specifically, depending on the quality of the received signals, the relay sets prices and correspondingly charges the users utilizing its resources for their transmissions. The price is determined in such a way that the relay's revenue or system utility is maximized. Given the specified price, the users competitively employ the relay node to forward their signals. We model each user as a rational player, which aims at maximizing its own net utility through power allocation, and analyze the competition among the users within the framework of noncooperative game theory. It is shown that, in the game played by the users, there always exists a unique pure Nash equilibrium point that can be achieved through distributed iterations. Next, subject to the availability of complete information about the users at the relay, we propose a low-complexity uniform pricing algorithm and an optimal differentiated pricing algorithm, in which the relay either charges the users at a suboptimal uniform price or charges different users at different prices. We also show that, by applying the differentiated pricing algorithm that enforces the users to transmit at certain power levels, any system utility can be maximized. Extensive simulations are conducted to quantify the performance of the proposed methods. [ABSTRACT FROM AUTHOR]

We develop a distributed throughput-optimal power allocation algorithm in wireless networks. The study of this problem has been limited due to the nonconvexity of the underlying optimization problems that prohibits an efficient solution even in a centralized setting. By generalizing the randomization framework originally proposed for input queued switches to SINR rate-based interference model, we characterize the throughput-optimality conditions that enable efficient and distributed implementation. Using gossiping algorithm, we develop a distributed power allocation algorithm that satisfies the optimality conditions, thereby achieving (nearly) 100 percent throughput. We illustrate the performance of our power allocation solution through numerical simulation. [ABSTRACT FROM PUBLISHER]