Search

The formation and properties of silver and iron nanoscale components in the Ag-Fe bimetallic system deposited on mordenite depend on several parameters during their preparation. Previously, it was shown that an important condition for optimizing nano-center properties in a bimetallic catalyst is to change the order of sequential deposition of components; the order “first Ag+, then Fe2+” was chosen as optimal. In this work, the influence of exact Ag/Fe atomic proportion on the system’s physicochemical properties was studied. This ratio has been confirmed to affect the stoichiometry of the reduction–oxidation processes involving Ag+ and Fe2+, as shown by XRD, DR UV-Vis, XPS, and XAFS data, while HRTEM, SBET and TPD-NH3 show little change. However, it was found the correlation between the occurrence and amount of the Fe3+ ions incorporated into the zeolite’s framework and the experimentally determined catalytic activities towards the model de-NOx reaction along the series of nanomaterials elucidated in this present paper.

A comprehensive study of the catalytic properties of the copper-iron binary system supported on mordenite, depending on the iron valence—CuFe2MOR and CuFe3MOR—was carried out, and redox ability has been considered as a decisive factor in determining catalytic efficiency. Acidity was studied by TPD-NH3, DRIFT-OH, and DRT methods. The total acidity of both samples was high. The Brönsted acidity is similar for both bimetallic samples and is explained by the acidity of zeolite; Lewis acidity varies greatly and depends on the exchange cations. A screening DRIFT study of CO and NO has shown redox capacity and demonstrated a potential for using these materials as catalysts for ambient protection. CuFe2MOR demonstrated stable Cu and Fe species, while CuFe3MOR showed redox dynamic species. As expected, CuFe3MOR displayed higher catalytic performance in NO reduction via CO oxidation, because of the easily reduced intermediate NO-complex adsorbed on the metallic Cu and Fe sites, which were observed through in situ DRIFT study.

In the present work, various experimental and theoretical methods were combined to study in detail the modifying effect of differences in the order of deposition of components on the state of silver in bimetallic iron–silver samples based on mordenite. In each of the silver-containing samples, the formation of large (≥2 nm in diameter) varieties of silver was observed, which differed from the varieties in the other samples, and in varying degrees. The formation of large Ag NPs on the outer surface of mordenite is explained by the redox interaction of Ag+-Fe2+ and the selectivity of ion exchange. The local surrounding of Ag in the studied samples is different: for AgMOR—monatomic species dominate, FeAgMOR—silver dimers and AgFeMOR—metal particles. In all investigated samples, the partially charged intra-channel Agnδ+ clusters (~0.7 nm in size) were formed due to partial Ag+ reduction and subsequent Ag0 agglomeration into the mordenite channel. Most of the silver in the bulk of the zeolite is represented in the cationic state attached to the mordenite framework by differently coordinated electrostatic forces, which can be Ag-O, Ag-Si or Ag-Al, with variations in interatomic distances and do not depend on the order of metal deposition. In addition, the arrangement of the cations in the side pockets means that the transport channels of mordenite are free, which is favorable for the application of the materials under study in catalysis and adsorption.

This article reviews the current state and development of thermal catalytic processes using transition metals (TM) supported on zeolites (TM/Z), as well as the contribution of theoretical studies to understand the details of the catalytic processes. Structural features inherent to zeolites, and their corresponding properties such as ion exchange capacity, stable and very regular microporosity, the ability to create additional mesoporosity, as well as the potential chemical modification of their properties by isomorphic substitution of tetrahedral atoms in the crystal framework, make them unique catalyst carriers. New methods that modify zeolites, including sequential ion exchange, multiple isomorphic substitution, and the creation of hierarchically porous structures both during synthesis and in subsequent stages of post-synthetic processing, continue to be discovered. TM/Z catalysts can be applied to new processes such as CO2 capture/conversion, methane activation/conversion, selective catalytic NOx reduction (SCR-deNOx), catalytic depolymerization, biomass conversion and H2 production/storage.

Au and Ag were deposited on TiO2 modified with Ce, La, Fe or Mg in order to obtain bimetallic catalysts to be used for liquid-phase oxidation of 1-octanol. The effects of the deposition order of gold and silver, and the nature of the support modifying additives and redox pretreatments on the catalytic properties of the bimetallic Au-Ag catalysts were studied. Catalysts were characterized by low-temperature nitrogen adsorption–desorption, energy dispersive spectroscopy, X-ray diffraction, X-ray photoelectron spectroscopy, high-resolution transmission electron microscopy and ultraviolet-visible diffuse reflectance spectroscopy. It was found that pretreatments with hydrogen and oxygen at 300 °C significantly decreased the activity of AuAg catalysts (silver was deposited first) and had little effect on the catalytic properties of AgAu samples (gold was deposited first). The density functional theory method demonstrated that the adsorption energy of 1-octanol increased for all positively charged AuxAgyq (x + y = 10, with a charge of q = 0 or +1) clusters compared with the neutral counterparts. Lanthanum oxide was a very effective promoter for both monometallic and bimetallic gold and silver catalysts in the studied process.

A series of mono and bimetallic catalysts based on a Fe-Ag mixture deposited on mordenite was prepared by ion-exchange and evaluated in the catalytic activity test of the de-NOx reaction in the presence of CO/C3H6. The activity results showed that the most active samples were the Fe-containing ones, and at high temperatures, a co-promoter effect of Ag on the activity of Fe catalysts was also observed. The influence of the order of cation deposition on catalysts formation and their physicochemical properties was studied by FTIR (Fourier Transform Infrared Spectroscopy) of adsorbed NO, XANES (X-ray Absorption Near-Edge Structure), and EXAFS (Extended X-ray Absorption Fine Structure) and discussed in terms of the state of iron. Results of Fe K-edge XANES oscillations showed that, in FeMOR catalysts, iron was present in a disordered state as Fe3+ and Fe2+. In FeAgMOR, the prevailing species was Fe3+, while in the AgFeMOR catalyst, the state of iron was intermediate or mixed between FeMOR and FeAgMOR. The Fe K-edge EXAFS results were characteristic of a disordered phase, the first coordination sphere being asymmetric with two different Fe-O distances. In FeAgMOR and AgFeMOR, coordination of Fe-O was similar to Fe2O3 with a few amount of Fe2+ species. We may conclude that, in the bimetallic FeAgMOR and AgFeMOR samples, a certain amount of tetrahedral Al3+ ions in the mordenite framework is replaced by Fe3+ ions, confirming the previous reports that these species are active sites for the de-NOx reaction. Based on the thermodynamic analysis and experimental data, also, it was confirmed that the order of deposition of the components influenced the mechanism of active sites’ formation during the two steps ion-exchange synthesis.

This study aims to identify the role of the various electronic states of gold in the catalytic behavior of Au/MxOy/TiO2 (where MxOy are Fe2O3 or MgO) for the liquid phase oxidation of n-octanol, under mild conditions. For this purpose, Au/MxOy/TiO2 catalysts were prepared by deposition-precipitation with urea, varying the gold content (0.5 or 4 wt.%) and pretreatment conditions (H2 or O2), and characterized by low temperature nitrogen adsorption-desorption, X-ray powder diffraction (XRD), energy dispersive spectroscopy (EDX), scanning transmission electron microscopy-high angle annular dark field (STEM HAADF), diffuse reflectance Fourier transform infrared (DRIFT) spectroscopy of CO adsorption, temperature-programmable desorption (TPD) of ammonia and carbon dioxide, and X-ray photoelectron spectroscopy (XPS). Three states of gold were identified on the surface of the catalysts, Au0, Au1+ and Au3+, and their ratio determined the catalysts performance. Based on a comparison of catalytic and spectroscopic results, it may be concluded that Au+ was the active site state, while Au0 had negative effect, due to a partial blocking of Au0 by solvent. Au3+ also inhibited the oxidation process, due to the strong adsorption of the solvent and/or water formed during the reaction. Density functional theory (DFT) simulations confirmed these suggestions. The dependence of selectivity on the ratio of Brønsted acid centers to Brønsted basic centers was revealed.

Mono- and bimetallic systems of Ag, Fe, and Ag–Fe exchanged in sodium mordenite zeolite were studied in the reaction of NO reduction. The transition metal cations Ag and Fe were introduced by ion exchange method both at room temperature and 60 °C; modifying the order of component deposition in bimetallic systems. These materials were characterized by Inductively Coupled Plasma-Optical Emission Spectroscopy (ICP-OES), ultraviolet-visible spectroscopy (UV-Vis), X-Ray photoelectron Spectroscopy (XPS) and High-resolution transmission electron microscopy (HR-TEM). The XPS and UV–Vis spectra of bimetallic samples revealed that under certain preparation conditions Ag+ is reduced with the participation of the Fe2+/Fe3+ ions transition and is present in the form of a Ag reduced state in different proportions of Agm clusters and Ag0 NPs, influenced by the cation deposition order. The catalytic results in the NO reduction reaction using C3H6/CO under an oxidizing atmosphere show also that the order of exchange of Ag and Fe cations in mordenite has a strong effect on catalytic active sites for the reduction of NO.

The catalytic properties of modified Au/TiO2 catalysts for low-temperature CO oxidation are affected by deactivation and reactivation after long-term storage and by redox treatments. The effect of these phenomena on the catalysts was studied by HRTEM, BET, SEM, FTIR CO, XPS and H2 TPR methods. The main cause for the deactivation and reactivation of catalytic properties is the variation in the electronic state of the supported gold, mainly, the proportion of singly charged ions Au+. The most active samples are those with the highest proportion of singly charged gold ions, while catalysts with a high content of trivalent gold ions are inactive at low-temperatures. Active states of gold, resistant to changes caused by the reaction process and storage conditions, can be stabilized by modification of the titanium oxide support with transition metals oxides. The catalyst modified with lanthanum oxide shows the highest stability and activity.

The nature and size of the real active species of nanoparticulated metal supported catalysts is still an unresolved question. The technique of choice to measure particle sizes at the nanoscale, HRTEM, has a practical limit of 1 nm. This work is aimed to identify the catalytic role of subnanometer species and methods to detect and characterize them. In this frame, we investigated the sensitivity to redox pretreatments of Ag/Fe/TiO2, Ag/Mg/TiO2 and Ag/Ce/TiO2 catalysts in CO oxidation. The joint application of HRTEM, SR-XRD, DRS, XPS, EXAFS and XANES methods indicated that most of the silver in all samples is in the form of Ag species with size

In this paper, the effect of modifiers and pretreatments on the electronic states of 1 nm gold nanoparticles (AuNPs) supported on silica was systematically studied. AuNPs deposited on silica (particle size of 2–4 nm) modified with Ce, La and Fe oxides, were studied by FTIR of adsorbed CO after different redox treatments at 100, 300 and 500 °C. This study was conducted at room temperature to allow detecting the electronic states of gold, which is more likely involved in CO oxidation at the same temperature. AuNP size distribution was measured by HRTEM. It is shown that the electronic state of gold species (Aunδ−, Au0, Aunδ+, Au+) in 1 nm AuNPs is sensitive to the modifier as well as to the temperatures of redox pretreatments. Supports modified with the same additives but containing larger AuNPs (~3, 4, 5, and 7 nm) were also studied. They showed that Au0 remains stable irrespective of additives and redox pretreatments, indicating no significant effect of such treatments on the electronic properties of larger AuNPs. Samples with a predominant AuNP size of 2 nm are an intermediate case between these two groups of materials.

In this paper, the effect of modifiers and pretreatments on the electronic states of 1 nm gold nanoparticles (AuNPs) supported on silica was systematically studied. AuNPs deposited on silica (particle size of 2-4 nm) modified with Ce, La and Fe oxides, were studied by FTIR of adsorbed CO after different redox treatments at 100, 300 and 500 °C. This study was conducted at room temperature to allow detecting the electronic states of gold, which is more likely involved in CO oxidation at the same temperature. AuNP size distribution was measured by HRTEM. It is shown that the electronic state of gold species (Aunδ , Au0, Aunδ+, Au+) in 1 nm AuNPs is sensitive to the modifier as well as to the temperatures of redox pretreatments. Supports modified with the same additives but containing larger AuNPs (~3, 4, 5, and 7 nm) were also studied. They showed that Au0 remains stable irrespective of additives and redox pretreatments, indicating no significant effect of such treatments on the electronic properties of larger AuNPs. Samples with a predominant AuNP size of 2 nm are an intermediate case between these two groups of materials. [ABSTRACT FROM AUTHOR]