Search

Satellite-based measurements of the column CH2O/NO2 ratio have previously been used to estimate near-surface ozone (O3) sensitivity (i.e., NOx or VOC limited), and the forthcoming launch of air quality-focused geostationary satellites provides a catalyst for reevaluating the ability of satellite-measured CH2O/NO2 to be used in this manner. In this study, we use a 0-D photochemical box model to evaluate O3 sensitivity and find that the relative rate of radical termination from radical-radical interactions to radical-NOx interactions (referred to as LROx/LNOx) provides a good indicator of maximum O3 production along NOx ridgelines. Using airborne measurements from NASA's Deriving Information on Surface Conditions from Column and Vertically Resolved Observations Relative to Air Quality (DISCOVER-AQ) deployments in Colorado, Maryland, and Houston, we show that in situ measurements of CH2O/NO2 can be used to indicate O3 sensitivity, but there is an important “transition/ambiguous” range whereby CH2O/NO2 fails to categorize O3 sensitivity, and the range and span of this transition/ambiguous range varies regionally. Then, we apply these findings to aircraft-derived column density measurements from DISCOVER-AQ and find that inhomogeneities in vertical mixing in the lower troposphere further degrades the ability of column CH2O/NO2 to indicate near-surface O3 sensitivity (i.e., the transition/ambiguous range is much larger than indicated by in situ data alone), and we hypothesize that the global transition/ambiguous range is sufficiently large to make the column CH2O/NO2 ratio unuseful for classifying near-surface O3 sensitivity. Lastly, we present a case study from DISCOVER-AQ-Houston that suggests that O3 sensitivity on exceedance days may be substantially different than on nonexceedance days (which may be observable from space) and explore the diurnal evolution of O3 sensitivity, O3 production, and the column CH2O/NO2 ratio. The results of these studies suggest that although satellite measurements of CH2O/NO2 alone may not be sufficient for accurately classifying near-surface O3 sensitivity, new techniques offered by geostationary platforms may nonetheless provide methods for using space-based measurements to develop O3 mitigation strategies.

Bulk aerosol composition and aerosol size distributions measured aboard the DC-8 aircraft during the Deep Convective Clouds and Chemistry Experiment mission in May/June 2012 were used to investigate the transport of mineral dust through nine storms encountered over Colorado and Oklahoma. Measurements made at low altitudes ( 9 km MSL). Storm mean outflow Ca2+ mass concentrations and total coarse (1 μm < diameter < 5 μm) aerosol volume (Vc) were comparable to mean inflow values as demonstrated by average outflow/inflow ratios greater than 0.5. A positive relationship between Ca2+, Vc, ice water content, and large (diameter > 50 μm) ice particle number concentrations was not evident; thus, the influence of ice shatter on these measurements was assumed small. Mean inflow aerosol number concentrations calculated over a diameter range (0.5 μm < diameter < 5.0 μm) relevant for proxy ice nuclei (NPIN) were ~15–300 times higher than ice particle concentrations for all storms. Ratios of predicted interstitial NPIN (calculated as the difference between inflow NPIN and ice particle concentrations) and inflow NPIN were consistent with those calculated for Ca2+ and Vc and indicated that on average less than 10% of the ingested NPIN were activated as ice nuclei during anvil formation. Deep convection may therefore represent an efficient transport mechanism for dust to the upper troposphere where these particles can function as ice nuclei cirrus forming in situ.

During the SEAC4RS campaign in 2013, inflight measurements of light-absorption by aerosol in biomass burning and agriculture fire plumes were collected along with concomitant measurements of aerosol extinction, scattering, and black carbon mass concentration. Here, we compare three measurements of aerosol absorption coefficients: from a photoacoustic spectrometer (PAS), a particle soot absorption photometer (PSAP), and a continuous light absorption photometer (CLAP). Each of these absorption measurements was collected in three visible spectral regions: red, green, and blue (although the precise wavelength and bandwidth vary with each instrument). The absorption measurements were compared during the plumes, in the boundary layer, and in the free troposphere. The slopes from the comparison ranged from 0.6 to 1.24. For biomass burning plumes, the uncertainty in the absorption measurements translates into a range in single scattering albedos of 0.93-0.94 at a wavelength of 660 nm, 0.94-0.95 at 532 nm and 0.92-0.95 at 405 nm. Overall, the aerosol absorption instruments agreed within their stated accuracies. Comparisons with simultaneous measurements of refractive black carbon mass concentration (collected by a single particle soot photometer), were used to derive the mass absorption coefficients (MAC). For all wavelengths, the MAC was high by greater than a factor of three compared to the expected MAC for black carbon. © 2018 American Association for Aerosol Research [ABSTRACT FROM AUTHOR]

During the NASA DISCOVER-AQ campaign over the Washington D.C., - Baltimore, MD, metropolitan region in July 2011, the NASA P-3B aircraft performed extensive profiling of aerosol optical, chemical, and microphysical properties. These in-situ profiles were coincident with ground based remote sensing (AERONET) and in-situ (PM2.5) measurements. Here, we use this data set to study the correlation between the PM2.5 observations at the surface and the column integrated measurements. Aerosol optical depth (AOD) calculated with the extinction (532 nm) measured during the in-situ profiles was found to be strongly correlated with the volume of aerosols present in the boundary layer (BL). Despite the strong correlation, some variability remains, and we find that the presence of aerosol layers above the BL (in the buffer layer -- BuL) introduces a significant uncertainties in PM2.5 estimates based on column-integrated measurements. This motivates the use of active remote sensing techniques to dramatically improve air quality retrievals. Since more than a quarter of the AOD values observed during DISCOVER-AQ are dominated by aerosol water uptake, the f (RH)amb (obtained from two nephelometers at different relative humidities -- RHs) is used to study the impact of the aerosol hygroscopicity. The results indicate that PM2.5 can be predicted within a factor of 1.6 even when the vertical variability of the f (RH)amb is assumed to be negligible. [ABSTRACT FROM AUTHOR]