Search

Surfactant losses by adsorption to rock surfaces make surfactant-based enhanced oil recovery economically less feasible. We investigated polyacrylate (PA) as a sacrificial agent in the reduction of anionic surfactant adsorption with focus on calcite surfaces by using quartz crystal microbalance with dissipation monitoring. It was found that the adsorption of the anionic surfactant alcohol alkoxy sulfate (AAS) followed a Langmuir adsorption isotherm, and the adsorbed amount reached saturation above its critical micellar concentration. Adsorption of PA was a much slower process compared to AAS adsorption. Increasing the calcium ion concentration also increased the amount of AAS adsorbed as well as the mass increase rate of PA adsorption. Experimental results combined with density functional theory calculations indicated that calcium cation bridging was important for anionic surfactant AAS and PA adsorption to calcite surfaces. To effectively reduce the amount of surfactant adsorption, it was needed to preflush with PA, rather than by a simultaneous injection. Preflushing with 30 ppm of PA gave a reduction of AAS adsorption of 30% under high salinity (HS, 31,800 ppm) conditions, compared to 8% reduction under low salinity (LS, 3180 ppm) conditions. In the absence of PA, the amount of adsorbed AAS was reduced by already 50% upon changing from HS to LS conditions. Lower calcium ion concentrations, as under LS conditions, contributed to this observation. On different mineral surfaces, PA reduced the AAS adsorption in the order of alumina > calcite > silica. These results offer important insights into mitigating surfactant adsorption using PA polyelectrolyte as sacrificial agent and contribute to improved flooding strategies with reduced surfactant loss., ChemE/Advanced Soft Matter, OLD ChemE/Organic Materials and Interfaces, Micro and Nano Engineering

We have investigated the conditions of colloidal stability of silica nanoparticles smaller than 100 nm for their applications in enhanced oil recovery (EOR), especially pertaining to chemical flooding processes. Using zeta sizer and dynamic light scattering techniques, the stability of silica nanoparticle (SNP) dispersions has been investigated by variation of the pH, composition of salt solutions, addition of surfactants and polyelectrolytes. Such conditions can be encountered in oil reservoirs. It was found that changing pH from 5 to 10 had a negligible effect on the size of SNPs, whereas its zeta potential increased with increasing pH. Aggregation of SNPs is a partially reversible process for low degrees of aggregation in 500 mM NaCl, whereas observed strong aggregation in 1000 mM NaCl was irreversible. A critical aggregation concentration (CAC) was defined for the different salts investigated, above which the SNP dispersion became unstable at a fixed pH of 9.5. The CAC for NaCl was approximately 200 times higher than for CaCl2 and MgCl2. Our observations could not be explained completely by the Derjaguin-Landau-Verwey-Overbeek (DLVO) theory. Therefore, we have included non-DLVO interactions such as cation bridging, hydration forces, and steric effects. The additional presence of anionic alcohol alkoxy sulfate (AAS) surfactant slightly destabilized the SNP solution, but by the addition of polyacrylate (PA) was effectively stabilized. With increasing PA concentration, the CAC for both CaCl2 and MgCl2 increased. Upon addition of 100 ppm PA, the CAC increased by a factor of five compared to the situation in the absence of PA. Reducing the solution pH below 8.5, SNP can be stabilized in higher salinity in the presence of PA. The obtained results contribute to a better fundamental understanding of the SNP stability mechanism and a guide to optimize the SNP injection process with EOR chemicals., ChemE/Advanced Soft Matter, OLD ChemE/Organic Materials and Interfaces