Search

Active cancellation of disturbing signals is a common method in electromagnetic compatibility (EMC) of power electronic systems. In this paper, a new method of suppressing periodic disturbances is extended and applied. In this method, the disturbing harmonics are suppressed by a synthesized cancellation signal that is synchronized with the converter's operation. Here, the cancellation signal is synthesized from a number of destructive sine waves. The appropriate amplitudes and phases are found via a convenient and robust adaptive approach. As a special feature of this method, many troublesome effects, like delays or complex frequency characteristics, can be compensated easily. Therefore, this method does not suffer from the same limitations as previous active techniques. Until now, the method has only been proven for a small number of harmonics. In this study, it is applied to a wide frequency range of 150 kHz to 30 MHz of a 48-/12-V dc/dc converter, e.g., for automotive applications. An optimization strategy is developed from a causal model of the system. A test setup is realized, and the sensor's and injector's performances are discussed regarding the automotive EMC standard CISPR 25. Measurement results for the artificial network and the antenna are presented. The additional power losses are estimated.

Active cancellation of disturbing signals is a common method in EMC. In this paper, a specialized strategy is presented to minimize the disturbing harmonics of stationary clocked systems by injecting an appropriate harmonic cancellation signal with an adjustable signal synthesizer. The optimum cancellation signal is found via a convenient and robust adaptive approach. Each destructive harmonic is generated individually, and the cancelation signal is the superposition of a set of sinusoidal signals. As a special feature of this method, many troublesome effects, like delays or complex frequency characteristics, can be compensated easily. Several implementation variants can be derived from this general approach. Here, the variant, continuously adapted harmonics cancellation (CAHC), is considered. The system's limitations due to the ADC, the DAC, and the synchronization are described. An FPGA-implementation of CAHC is presented and applied to a dc/dc converter in an automotive component measurement setup to demonstrate the effectivity of the method.

This paper deals with the application of spread spectrum techniques on power electronic converters to reduce electromagnetic disturbances. These techniques aim for a spreading of the harmonics in a frequency domain in order to distribute the power over a wider frequency range. By doing so, the levels of the harmonics drop. In this paper, both peak and average detector measurements are considered. It is shown that different parameters are required to minimize either peak or average emissions. The reduction of peak and/or average emissions is mathematically described for a sine wave as a harmonic of pulse width modulation signals. These spread harmonics overlap for high orders and/or high-frequency variations. It is shown that this effect is a limiting factor for spread spectrum in practical applications. The resulting maximum achievable reduction is analyzed. From these results, parametrization strategies are derived to fulfill specific requirements. In test setups, the precision of the proposed parametrization strategies is demonstrated. Additionally, it is shown that the results for peak measurements can also be applied to quasi-peak measurements.