Search

The microstructure evolution, tensile properties and work-hardening behavior of AA2219 alloy reinforced by in situ nanosized TiB2 particles were studied in this paper. The observation indicated an impeded recrystallization of the matrix alloy by nanosized TiB2 particles, and the hybrids of nanosized TiB2 particles and Al2Cu phases located at the grain boundary hindered the grain growth. Meanwhile, a large amount fiber textures of <111>//RD (Rolling direction), <110>//RD, <100>//RD <111>//ND (Normal direction), <110>//ND and <100>//ND were detected in nanosized TiB2/AA2219 composite. Tensile test results exhibited a combination of good strength and ductility of the present composite whose yield strength and tensile strength were 11.4% and 5.8% higher than those of the alloy, while its fracture strain increased slightly. Meanwhile, the correlation between this modified microstructure of nanosized TiB2 particles and comprehensive mechanical properties was established. This study provides a new insight into the fabrication and strengthening behaviors of Al matrix composites reinforced by in situ nanoparticles. [ABSTRACT FROM AUTHOR]

The modified cold metal transfer (CMT) heat sources by adjusting the characteristic processing parameters were conducted in wire-arc additive manufacturing (WAAM) of AZ31 magnesium alloy for thin-wall component. The processing, microstructure, and mechanical behaviour were investigated. The CMT characteristic deposited a wide and shallow weld bead coupled with good wettability and low equivalent heat input was selected for CMT-WAAM process. The microstructure of thin-wall component showed obvious layer characteristics, which consisted of the deposited layers with fine columnar dendrite grains and the HAZ interlayers with coarse equiaxed grains and some pores. The thin-wall component exhibited anisotropic tensile properties with lower yield strength, higher elongation, and higher ultimate tensile strength in the deposition direction than in the build direction. CMT-WAAM component of AZ31 magnesium alloy has an accepted mechanical property compared with the as-forged and as-cast components. To improve the component strength, minimizing the softening effect of the HAZ interlayers by preventing grain coarsening and suppressing porosity is essential. [ABSTRACT FROM AUTHOR]