Search

In the current research, the effect of Ag on the mechanical properties of Ti5Al2.5Fe alloy was investigated. The Ti5Al2.5Fe alloy, with different amounts of Ag ranged from 1 to 5 wt. % was prepared by mechanical mixing and then fabricated by hot pressing at 950 oC for 15 min under 50 MPa. Three holding steps were applied to the powder compacts to restrain the liquid phases inside graphite die before reaching the maximum sintering temperature. The sintered samples were subjected to hardness, bending and wear tests to study the effect Ag on the mechanical properties of Ti5Al2.5Fe alloy. The microstructural characterization was carried out by means of optical and scanning electron microscope. The results showed that Ag played a differential role on the mechanical properties supported by microstructural constituents. The bending strength and hardness of the produced samples increased with the addition of Ag, the hardness of the alloys then tended to decrease with increasing Ag content but still remained above the hardness of Ti5Al2.5Fe alloy. Wear test also showed similar trends with hardness test results. Finally, the optimum Ag content for the Ti5Al2.5Fe alloy was determined as 1 wt.%. XRD analysis showed that undissolved Ag content was the main reason for the decrease in the mechanical properties. [ABSTRACT FROM AUTHOR]

This study presents two analytical models for the laser powder bed fusion (LPBF) process. To begin, the single layer's dimensions were measured using principal operating conditions, including laser power, laser scanning speed, powder layer thickness, and hatch distance. The single-layer printing dimensions were transformed into multi-layer printing using the hatch distance. The thermal history of the printed layers was used as an input to the Johnson–Mehl–Avrami-Kolmogorov model to estimate the average dendrite grain size. LPBF experiments were conducted for a Cobalt–chromium (Co–Cr) alloy to validate the developed model. The average dendrite grain size was estimated using a scanning electron microscope (SEM) combined with "Image J" software. The Vickers hardness test was performed to correlate the average dendrite grain size and operating conditions. A 10–15% mean absolute deviation was presented between experiments and simulation results. In all samples, a Co-based γ-FCC structure was identified. An inverse correlation was established between the laser power and smaller average dendrite grain, while a direct relationship has been determined between laser scanning speed and average dendrite grain size. A similar trend was identified between hatch distance and average dendrite grain size. A direct link has been determined between the average dendrite grain size and hardness value. Furthermore, a direct relationship has connected the laser volume energy density and hardness value. This study will help experimentalists to design operating conditions based on the required grain size and corresponding mechanical characteristics. [ABSTRACT FROM AUTHOR]