Search

The paper presents a static analysis of the buckling and post-buckling state of thin-walled cold-formed steel (TWCFS) lipped channel section beam-columns subjected to eccentric compression. Eccentricity is taken into consideration relative to both major and minor principal axes. An analytical–numerical solution to the buckling and post-buckling problems is described. The solution is based on the theory of thin plates. Equations of equilibrium of section walls are derived from the principle of stationary energy. Then, to solve the problem, the finite difference (FDM) and Newton–Raphson methods are applied. Linear (buckling) and nonlinear (post-buckling) analyses are performed. As a result, pre- and post-buckling equilibrium paths are determined. Comparisons of the obtained numerical results, FE simulation results, and experimental test results are carried out and presented in comparative load-shortening diagrams. Additionally, a comparison of the buckling forces and buckling modes obtained from theoretical analysis and experiments is presented. [ABSTRACT FROM AUTHOR]

The work includes the results of numerical, analytical-numerical and experimental study into the influence of load eccentricities with regard to major axis on post-buckling behaviour and load-carrying capacity of thin-walled cold-formed steel lipped channel section columns. The study was solved by using the finite element method (code Ansys) with taking into consideration a full material characteristics in logarithmic strain system and geometric nonlinearities. The analytical-numerical solution was based on Koiter's theory with an application of finite difference method (FDM). Some chosen results of numerical simulations have been compared to experimental results. The deformations of columns were registered by means of Digital Image Correlation Aramis System (DICAS) to observe the maps and the magnitude of displacements for adequate point of a load. The analyses showed that the decrease in maximum load in a dependency on the eccentricity value can be even 3 times minor in a comparison to the load-carrying capacity of axially loaded column. [ABSTRACT FROM AUTHOR]

Flexible polyurethane foams are commonly used materials in automotive applications, especially for internal cockpit parts and seats. During accidental impact, passenger's head has to be stopped by the headrest. Because padding material of a headrest has a significant influence on a head deceleration, mechanical properties of two types of polyurethane foams with a certain range of densities and components proportion have been studied. Dynamic impact tests have been carried out. Results are presented below. Analytical constitutive model of compression has been proposed, which assumes that density, components proportion and strain rate are separable functions. The model has been verified by experimental results of static tests. Impact tests have been conducted due to two objectives: to investigate impact behavior of examined material and to validate numerical solution based on the method of lumped mass.

Copyright of Maintenance & Reliability / Eksploatacja i Niezawodność is the property of Polish Scientific & Technical Society Consumables, Polish Maintenance Society and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)