Search

Rice straw is used as livestock feed and compost. Ferimzone and tricyclazole, common fungicides for rice blast control, can be found in high concentrations in rice straw after unmanned aerial vehicle (UAV) spraying, potentially affecting livestock and human health through pesticide residues. In this study, an optimized method for the analysis of the two fungicides in rice straw was developed using the improved QuEChERS method. After the optimization of water and solvent volume, extraction conditions including ethyl acetate (EtOAc), acetonitrile (MeCN), a mixed solvent, and MeCN containing 1% acetic acid were compared. Different salts, including unbuffered sodium chloride, citrate, and acetate buffer salts, were compared for partitioning. Among the preparation methods, the MeCN/EtOAc mixture with unbuffered salts showed the highest recovery rates (88.1–97.9%, RSD ≤ 5.1%). To address the severe matrix effect (%ME) of rice straw, which is characterized by low moisture content and cellulose-based complex matrices, samples were purified using 25 mg each of primary–secondary amine (PSA) and octadecylsilane (C18), without pesticide loss. The developed method was validated with a limit of quantification (LOQ) of 0.005 mg/kg for target pesticides, and recovery rates at levels of 0.01, 0.1, and 2 mg/kg met the permissible range (82.3–98.9%, RSD ≤ 8.3%). The %ME ranged from −17.6% to −0.3%, indicating a negligible effect. This optimized method was subsequently applied to residue studies following multi-rotor spraying. Fungicides from all fields and treatment groups during harvest season did not exceed the maximum residue limits (MRLs) for livestock feed. This confirms that UAV spraying can be safely managed without causing excessive residues. [ABSTRACT FROM AUTHOR]

Off-target pesticide drift in paddy fields following unmanned aerial vehicle (UAV) spraying was evaluated using cellulose deposition samplers (CDSs). An analytical method for quantifying ferimzone Z and E isomers deposited on CDSs was developed using LC-MS/MS. The suitability of the CDS method was confirmed by comparing deposition patterns on CDSs with residue levels in rice plant samples. To assess pesticide deposition in paddy fields, CDSs were strategically placed at varying distances from target areas, followed by UAV spraying. The fungicide agrochemicals were applied with and without adjuvants, and wind direction affected the drift trajectory for all treatment groups. Adjuvants, particularly soy lecithin as the major component, significantly enhanced pesticide deposition within the spray pathway while reducing drift rates relatively by 47.9–68.0 %. Higher wind speeds were found to exacerbate drift, but adjuvant-treated sprays showed less variability in deposition patterns under these conditions. Pesticide residues in harvested brown rice were found to be below the maximum residue limits (MRLs), ensuring safety for consumption. These findings highlight the importance of selecting appropriate adjuvants in UAV-based pesticide applications to optimize deposition efficiency and minimize environmental contamination.

Rice straw is used as livestock feed and compost. Ferimzone and tricyclazole, common fungicides for rice blast control, can be found in high concentrations in rice straw after unmanned aerial vehicle (UAV) spraying, potentially affecting livestock and human health through pesticide residues. In this study, an optimized method for the analysis of the two fungicides in rice straw was developed using the improved QuEChERS method. After the optimization of water and solvent volume, extraction conditions including ethyl acetate (EtOAc), acetonitrile (MeCN), a mixed solvent, and MeCN containing 1% acetic acid were compared. Different salts, including unbuffered sodium chloride, citrate, and acetate buffer salts, were compared for partitioning. Among the preparation methods, the MeCN/EtOAc mixture with unbuffered salts showed the highest recovery rates (88.1–97.9%, RSD ≤ 5.1%). To address the severe matrix effect (%ME) of rice straw, which is characterized by low moisture content and cellulose-based complex matrices, samples were purified using 25 mg each of primary–secondary amine (PSA) and octadecylsilane (C18), without pesticide loss. The developed method was validated with a limit of quantification (LOQ) of 0.005 mg/kg for target pesticides, and recovery rates at levels of 0.01, 0.1, and 2 mg/kg met the permissible range (82.3–98.9%, RSD ≤ 8.3%). The %ME ranged from −17.6% to −0.3%, indicating a negligible effect. This optimized method was subsequently applied to residue studies following multi-rotor spraying. Fungicides from all fields and treatment groups during harvest season did not exceed the maximum residue limits (MRLs) for livestock feed. This confirms that UAV spraying can be safely managed without causing excessive residues.

Antifungals support modern medical and agricultural practices, and extensive screening environmental data are missing. This work aims to survey antifungals for medical and agricultural purposes in surface- and groundwater in Portugal. A passive sampling technique and a high-resolution chromatographic system were used. Antifungals applied in medical practice were not detected as only antifungals for agricultural purposes (fungicides). Thirty-nine different fungicide molecules were found; its detection frequency in surface- and groundwater was dominated by rabenzazole (61%, 92%) and ethoxyquin (54%, 77%); among the five fungicides with similar surface- and groundwater catching rates, ferimzone was the most polluting (54%, 54%); oxadixyl (61%), kresoxim-methyl (61%) and fenamidone (46%) were primarily designated surface water contaminants; for azoles, the occurrence in surface water ranged from a residual (10%) to a moderate detection rate for two compounds (31%—propiconazole and tebuconazole). Surprisingly, only 51% of detected fungicides are authorised. The frequently detected fungicides that are either not authorised (ethoxyquin and its impurity, furmecyclox, oxadixyl), without data in the EU (rabenzazole, ferimzone), or authorised at the national level (fenamidone), should be included in environmental monitoring programmes and followed as emerging (micro)contaminants. Policy makers should gather their efforts to allow the implementation of proper risk management and effective contamination control strategies to achieve Sustainable Development Goals. [ABSTRACT FROM AUTHOR]

Off-target pesticide drift in paddy fields following unmanned aerial vehicle (UAV) spraying was evaluated using cellulose deposition samplers (CDSs). An analytical method for quantifying ferimzone Z and E isomers deposited on CDSs was developed using LC-MS/MS. The suitability of the CDS method was confirmed by comparing deposition patterns on CDSs with residue levels in rice plant samples. To assess pesticide deposition in paddy fields, CDSs were strategically placed at varying distances from target areas, followed by UAV spraying. The fungicide agrochemicals were applied with and without adjuvants, and wind direction affected the drift trajectory for all treatment groups. Adjuvants, particularly soy lecithin as the major component, significantly enhanced pesticide deposition within the spray pathway while reducing drift rates relatively by 47.9–68.0 %. Higher wind speeds were found to exacerbate drift, but adjuvant-treated sprays showed less variability in deposition patterns under these conditions. Pesticide residues in harvested brown rice were found to be below the maximum residue limits (MRLs), ensuring safety for consumption. These findings highlight the importance of selecting appropriate adjuvants in UAV-based pesticide applications to optimize deposition efficiency and minimize environmental contamination. [Display omitted] • Development of a sensitive LC-MS/MS method for ferimzone analysis in CDS. • Adjuvants significantly enhanced pesticide deposition in UAV target areas. • Wind speed and direction critically impacted pesticide drift patterns. • Adjuvants reduced pesticide drift rate effectively during UAV spraying. • Ferimzone residues in brown rice remained below maximum residue limits. [ABSTRACT FROM AUTHOR]

We compared the risk of reselecting melanin biosynthesis dehydratase inhibitor (MBI-D)-resistant Pyricularia oryzae isolates between two treatment programs, a nursery box application of diclocymet and a rotational program in which nursery boxes received a non-MBI-D fungicide application and then later, in the field, a foliar application of a diclocymet and ferimzone mixture. Both were effective against panicle blast. However, the latter prevented the reselection of MBI-D-resistant isolates more effectively than the former. [ABSTRACT FROM AUTHOR]

We compared the risk of reselecting melanin biosynthesis dehydratase inhibitor (MBI-D)-resistant Pyricularia oryzae isolates between two treatment programs, a nursery box application of diclocymet and a rotational program in which nursery boxes received a non-MBI-D fungicide application and then later, in the field, a foliar application of a diclocymet and ferimzone mixture. Both were effective against panicle blast. However, the latter prevented the reselection of MBI-D-resistant isolates more effectively than the former.