Search

Model predictive control has been wildly used in the modern power electronic converter with the advantages of the multi‐objective optimization, no additional modulator is required and small grid current harmonic. However, the switching operation is not constant and higher sampling frequency must be required. A novel direct power control using model predictive control (DPC‐MPC) strategy is presented in this paper, which achieve the optimal vector prediction scheme with constant switching frequency operation. The calculation process is greatly simplified due to the optimal voltage vector generated directly, then, it applied to the control of a three‐phase three‐level T‐type grid converter. A cost function is first built to balance the neutral‐point‐potential voltage. After then, the cost function is updated by considering the delay caused by the calculation, sampling and gate driver. Finally, a comprehensive comparative study with the conventional DPC‐MPC strategy is introduced to verify the superiority of the presented DPC‐MPC. The simulation and experimental results show that the steady and the transient performance of the grid current with the proposed DPC‐MPC control strategy are effectively improved. © 2021 Institute of Electrical Engineers of Japan. Published by Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]

Virtual vector is applied in neutral‐point‐clamped (NPC) three‐level converter finite control set model predictive control (FCS‐MPC) strategy due to its good performance of less current ripples and high power efficiency. However, in the process of adding virtual vectors, some redundant virtual vectors will be selected. Excessive virtual vector will increase the computational burden and affect grid‐tied current performance. A virtual vector optimal selection strategy for model predictive control to determine the vectors is proposed. The strategy calculates the fluctuation of grid‐tied current through theoretical analysis. Based on the analysis of amplitude fluctuation of grid‐tied current, the graphics of coverage angle visualization can be obtained under different virtual vector. The angle of the required virtual vectors is obtained through the graphics of coverage angle visualization. The number of virtual vector can be determined when the error current angle range covers the entire vector graph. The proposed control strategy was compared with the conventional control strategies, including excessive virtual vectors or with no any virtual vector. Experimental results show that the proposed control strategy can significantly reduce THD, grid‐tied current error and computational burden. © 2022 Institute of Electrical Engineers of Japan. Published by Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]