Search

In this paper, a nonlinear autoregressive with exogenous inputs (NARX) digital pre-distortion scheme to linearize power amplifiers is proposed. The proposed NARX digital pre-distortion gives better accuracy and spectral leakage suppression compared with other commonly used Volterra-based techniques. The stability criterion of the NARX digital pre-distortion is derived from the frequency domain analysis. Simulation is carried out with a 20 MHz single carrier long-term evolution signal and two-carrier long-term evolution signal and instantaneous to average ratio of 6.2 dB at 0.01% complementary cumulative distribution function (CCDF). The results of simulation analysis show a slight improvement in adjacent channel leakage ratio performance with 30% reduction in the number of floating point operations compared with conventional pre-distortion techniques. Copyright © 2016 John Wiley & Sons, Ltd. [ABSTRACT FROM AUTHOR]

For adaptive improvement of linearity above a 12 dB PAPR for 64QAM WiMAX, a complementary feedback loop in a differential amplifier is adopted as a pre-distorter that is realized using an NMOS cell operating in the triode region in order to compensate the gm3, the third order transconductance, of the differential amplifier. The power amplifier has been implemented in 0.18 μm CMOS technology, and the chip size is 870 μm × 1050 μm. The proposed PA obtains the 42% efficiency at P1dB while improving the IMD by more than 10 dB above 15 dBm output power levels. It shows a gain of as much as 14.5 dB, and a return loss below -12 dB for 2.3–2.4 GHz operation. Finally, the fabricated PA complies with the spurious emission of WiMAX standards up to 22 dBm. © 2010 Wiley Periodicals, Inc. Microwave Opt Technol Lett 52:833–836, 2010; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.25062 [ABSTRACT FROM AUTHOR]

In this paper, we consider the optimization of the performance of QPSK and 16-QAM coded orthogonal frequency division multiplexing (COFDM) signals over the non-linear and mobile satellite channel. A high power amplifier and Rician flat fading channel produces non-linear and linear distortions; an adaptive predistortion technique combined with turbo codes will reduce both types of distortion. The predistorter is based on a feedforward neural network, with the coefficients being derived using an extended Kalman filter (EKF). The conventional turbo code is used to mitigate Rician flat fading distortion and Gaussian noise. The performance over a non-linear satellite channel indicates that QPSK COFDM followed by a predistorter provides a gain of about 1.7 dB at a BER of 3×10-3 when compared to QPSK COFDM without the predistortion scheme and 16-QAM COFDM provides a gain of 0.5 dB output back-off and 1.2 dB signal to noise ratio at a BER of 3×10-5 when compared with an adaptive predistorter based on the Harmmerstein model. We also investigate the influence of the guard time interval and Doppler frequency effect on the BER performance. When the guard interval increases from 0 to 0.125T samples and the normalized Doppler frequency is 0.001, there is a gain of 0.7 and 1 dB signal to noise ratio at a BER of 6×10-4 for QPSK and 16-QAM COFDM, respectively. Copyright © 2003 John Wiley & Sons, Ltd. [ABSTRACT FROM AUTHOR]