Search

Sol–gel processed zinc oxide (ZnO) is one of the most widely used electron transport layers (ETLs) in inverted organic solar cells (OSCs). The high annealing temperature (≈200 °C) required for sintering to ensure a high electron mobility however results in severe damage to flexible substrates. Thus, flexible organic solar cells based on sol–gel processed ZnO exhibit significantly lower efficiency than rigid devices. In this paper, an indium‐doping approach is developed to improve the optoelectronic properties of ZnO layers and reduce the required annealing temperature. Inverted OSCs based on In‐doped ZnO (IZO) exhibit a higher efficiency than those based on ZnO for a range of different active layer systems. For the PM6:L8‐BO system, the efficiency increases from 17.0% for the pristine ZnO‐based device to 17.8% for the IZO‐based device. The IZO‐based device with an active layer of PM6:L8‐BO:BTP‐eC9 exhibits an even higher efficiency of up to 18.1%. In addition, a 1.2‐micrometer‐thick inverted ultrathin flexible organic solar cell is fabricated based on the IZO ETL that achieves an efficiency of 17.0% with a power‐per‐weight ratio of 40.4 W g−1, which is one of the highest efficiency for ultrathin (less than 10 micrometers) flexible organic solar cells. [ABSTRACT FROM AUTHOR]

Ultrathin flexible organic solar cells (OSCs) have garnered widespread attention in wearable electronic devices for their lightweight and excellent conformability. Silver nanowires (AgNWs) are one of the most widely used bottom electrodes because of their high conductivity and transmittance. However, the high roughness of AgNWs on the flexible substrate exerts adverse effects on device performance. To address this critical issue, a bilayer electron‐transport‐materials (ETMs) strategy consisting of an indium‐doped zinc oxide (IZO) and a pristine ZnO is developed. The IZO is utilized as the first layer of ETM, which can effectively fill voids in AgNWs to form a high‐conductive composite electrode. The ZnO is used as the second layer of ETM, facilitating charge extraction. The ultrathin flexible OSCs prepared based on the gradient bilayer ETMs can achieve a power conversion efficiency (PCE) of 16.1%, associated with improved mechanical stability, showing a PCE retention of 93% after 10 000 bending cycles (R = 1 mm) and 82% under 1000 compression (30%)‐release cycling test. To the best of knowledge, it's one of the highest efficiency for ultrathin (less than 10 μm) flexible OSCs based on the solution‐processed electrodes. This work will provide a new avenue for fabricating high‐performance and mechanically robust ultraflexible ITO‐free OSCs. [ABSTRACT FROM AUTHOR]