Search

The XY model of oil‐paper insulation connects the dielectric properties of oil, paper and oil‐paper system. Its equivalent circuit is the basis of the application of dielectric response technology in the state diagnosis of transformer oil‐paper insulation. To better apply the XY model to the study of the dielectric properties of oil‐paper insulation, the dielectric properties of the coaxial oil‐paper insulation system built in the laboratory, XY model and its equivalent circuits are compared. Then an improved circuit of XY model which can reflect the properties of the oil‐paper insulation more truly is proposed. The results show that there is no difference between the XY model and the coaxial model, and both can well characterize the oil‐paper insulation system. The two equivalent circuits of XY model, "Series to Parallel" circuit and "Parallel to Series" circuit, ignore the current tangential component and the electric field distortion in oil‐paper insulation, respectively, resulting in deviations from the XY model. By introducing a new branch C*XY, the improved circuit can reflect the tangential current and electric field distortion in oil‐paper insulation, which can be completely equivalent to XY model. In addition, there is a characteristic frequency point in the oil‐paper insulation system, where the dielectric loss factor tan δ of oil, paper and oil‐paper system are the same. There is no difference between the XY model and its two equivalent circuits at this point. The characteristic frequency is determined by the dielectric properties of oil and paper, and not affected by the insulation structure. © 2022 Institute of Electrical Engineers of Japan. Published by Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]

The transformer is a core device of the power system, and it is generally considered that the aging of insulating paper is important to the transformer. The aging process of insulating paper is the degradation process of cellulose. If it can be detected regularly, the aging of oil–paper insulating systems can be monitored conveniently. 5‐hydroxymethylfurfural is an important chemical substance produced by cellulose decomposition. It has broad prospects because of its many advantages. The oil–paper insulation system was thermally aged at 80, 90, 100, and 110 °C to measure the concentration of 5‐hydroxymethylfurfural on insulating paper and in transformer oil. In this paper, the concentration of 5‐hydroxymethylfurfural is detected by high‐performance liquid chromatography. The linear correlation coefficient of this method can reach 0.99, and the minimum detected concentration can be reduced to 10 µg/l. Experiments show that the concentration of 5‐hydroxymethylfurfural increases with the aging time, and when degree of polymerization (DP) decreased, the concentration of 5‐hydroxymethylfurfural increased. The correlation coefficient is greater than 0.92, which shows that there is an experimental relationship between the concentration of 5‐hydroxymethylfurfural and DP. The parameters of regression curves are different at different temperatures, but in actual operation, the temperature is low and remains stable. Therefore, 5‐hydroxymethylfurfural is expected to be a new indicator of the aging degree of oil–paper insulation system. © 2020 Institute of Electrical Engineers of Japan. Published by John Wiley & Sons, Inc. [ABSTRACT FROM AUTHOR]

The frequency‐domain dielectric spectroscopy (FDS) of humid insulating paper has been measured at different temperatures. The data show three independent dielectric processes: electrode polarization, hopping conductivity and interfacial polarization. The dielectric properties of humid insulating paper are composed of hopping conductivity and interfacial polarization, and its equivalent dielectric model can be represented by a Havriliak‐Negami (HN) relaxation branch parallel hopping conductivity. At high temperatures and low frequencies, the measured dielectric spectroscopy bends downward, which is caused by the electrode polarization. In this case, the equivalent dielectric model is composed of the body impedance of insulating paper and the electrode polarization in series. According to the equivalent dielectric model, the components of electrode polarization, hopping conductivity, and interface polarization can be separated, thereby eliminating the parasitic effect of electrode polarization on the dielectric properties of insulating paper. Both of hopping conductivity and interface polarization of insulating paper move toward high‐frequency direction with temperature increasing. For humid insulating paper with a moisture content of 5.9%, the activation energies of hopping conductivity and interface polarization are 1.18 and 0.99 eV, respectively. This difference in activation energies results in the inability of the spectrums of insulating paper to overlap with each other at different temperatures. Based on the insulating paper without oil immersion, the results obtained in this article are not affected by oil or oil‐immersion operations. This provides a reference for exploring the dielectric properties and physical mechanisms of oil‐paper composite insulation materials widely used in high‐voltage equipment. © 2023 Institute of Electrical Engineer of Japan and Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]

Assessment of the aging of oil‐paper insulation is analyzed in this article, based on an improved fractional Poynting‐Thomson model, which includes dc and hopping conductivity (P‐T model2). Based on samples of oil paper produced in laboratories with different thermal aging times, it has been found that the proposed improved model provides a better fit and a higher index of coincidence concerning the measured values than the traditional P‐T model and the model that only incorporates the effect of dc conductivity (P‐T model1). Nevertheless, comparing the proposed improved P‐T model with the traditional Cole–Cole (C‐C), Davidson–Cole (D‐C), and Havriliak–Negami (H‐N) models, the improved P‐T model2 also demonstrated a superior fit for the measured value and a higher coincidence index than another model. In addition, there was an excellent exponential relationship between the quantities εa, εb and τ of the improved model and the furfural content of the samples. Consequently, these characteristic quantities could be utilized to estimate the furfural content in the oil‐paper insulation and evaluate the insulation's condition. © 2023 Institute of Electrical Engineer of Japan and Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]

In the production of facial oil blotting papers, a certain number of papers must be counted before packaging. Currently, the papers are counted by hand, and this is hard work. Also, there are risks of adhesion of dust and wrinkles. In order to solve these problems, we propose a vision‐based approach. After the papers, which are arranged by shifting, are captured, the proposed image processing steps detect the boundaries of the papers. By counting the detected boundaries, the number of papers can be counted. Since the parameters for the proposed image processing are optimized by genetic algorithm, prior setting by a user is not necessary. For the experiments, an image dataset was constructed with six types of facial oil blotting papers. The proposed method achieved higher F‐measure than in other related works. © 2019 Institute of Electrical Engineers of Japan. Published by John Wiley & Sons, Inc. [ABSTRACT FROM AUTHOR]

The partial discharge in the converter transformer will cause the carbonization of the insulating paper. The high concentration of free carbon particles generated from the insulating paper during the operation of the converter transformer will cause partial discharge, which will aggravate the insulation performance deterioration. For the bi‐directional interaction of carbon particles and partial discharge, the mechanism of insulating paper carbonization caused by partial discharge and the effect of carbon particles on the dielectric strength of oil paper are studied. In this paper, we construct a simulation system of amorphous cellulose to study the carbonization mechanism of insulating paper from the microscopic level. Furthermore, we build a DC voltage experimental platform to carry out partial discharge damage tests of oil‐paper insulation models and to measure the changes in the breakdown voltage with different carbon particle concentrations and diameters. The results show that partial discharge speeds up the cleavage rate of cellulose, generates low molecular hydrocarbon gas and water molecules, and the carbon atoms rearrange into PAH‐like molecules with aliphatic side chains. The surface of the insulating paper will carbonize, then form free carbon particles after peeling off. Afterward, the carbon particles in insulating oil accumulate in the high electric field area and attach to the insulating paper, which will cause electric field distortion and reduce the dielectric strength of oil‐paper insulation. With the increase of carbon particle concentration and diameter, the breakdown voltage of oil‐paper insulation decreases gradually. © 2023 Institute of Electrical Engineer of Japan and Wiley Periodicals LLC. [ABSTRACT FROM AUTHOR]

Since deep low‐frequency tremors are considered to be associated with large earthquakes that occur adjacently on the same subducting plate interface, it is important to investigate tremors that occurred before the establishment of modern seismograph networks such as the High Sensitivity Seismograph Network (Hi‐net). We propose a deep‐learning solution to detect evidence of tremors in scanned images of paper seismogram records from over 50 years ago. In this study, we fine‐tuned a convolutional neural network (CNN) based on the Residual Network, which was pre‐trained using images of synthetic waveforms from our previous study, using a data set comprised of images generated from real seismic data recorded digitally by Hi‐net to facilitate a supervised analysis. The fine‐tuned CNN was able to predict the presence or absence of tremors in the Hi‐net images with an accuracy of 98.64%. Gradient‐weighted Class Activation Mapping heatmaps created to visualize model predictions indicated that the CNN's ability to detect tremors is not degraded by the presence of teleseisms. Once validated using the Hi‐net images, the CNN was applied to paper seismograms recorded from 1966 to 1977 at the Kumano observatory in southwest Japan, operated by Earthquake Research Institute, The University of Tokyo. The CNN showed potential for detecting tremors in scanned images of paper seismogram records from the past, facilitating downstream tasks such as the creation of new tremor catalogs. However, further training using an augmented data set to control for variables such as inconsistent plotting pen thickness is required to develop a universally applicable model. Plain Language Summary: In 2002, deep low‐frequency tremors, which periodically occur with much smaller amplitudes and longer durations than common earthquakes, were discovered owing to the establishment of dense seismic arrays in Japan. These tremors are considered to be associated with megathrust earthquakes because they occur in deeper regions of plate boundaries compared with common earthquakes. Investigating tremors that occurred before the establishment of dense seismic arrays is important since megathrust earthquakes recur on intervals of 100–200 years, and digital records from modern seismic arrays cover only a fraction of that time. In this study, we developed a convolutional neural network based on the Residual Network (ResNet) that extracts tremors from images of waveforms recorded more than 50 years ago, when seismometers drew waveforms directly on drum‐rolled paper using a pen. The proposed ResNet, which was trained on seismogram images generated from synthetic waveforms and real data recorded digitally by modern seismic arrays, was applied to scanned images of paper seismograms recorded from 1966 to 1977 at an observatory in southwest Japan. A list of tremors was successfully obtained; however, further training using data that accounts for variables such as inconsistent plotting pen thickness is required to develop a universally applicable model. Key Points: Convolutional neural network model for detection of deep low‐frequency tremors from seismogram images is proposedThe model trained with seismogram images converted from real seismic data successfully detects tremorsThe detection performances of the trained model for the paper records at the Kumano observatory in southwest Japan are discussed [ABSTRACT FROM AUTHOR]

Aromatic sensitizers and related compounds (SRCs) originating from thermal recording material as impurities in waste paper have been detected in aquatic environments near cities where the paper industry is flourishing. In the present study, the levels of exposure to such SRCs and the stable isotope ratios (δ13C and δ15N) in different fish species ( Konosirus punctatus, Takifugu niphobles, and Tribolodon hakonensis) were analyzed. These fish species were collected from the vicinity of waste paper recycling plants in Japan. Eleven SRCs were identified in fish muscle at total concentration levels (ΣSRCs) of 64 to 818 ng/g wet weight (mean 181 ng/L wet wt). The dominant SRCs in the fish samples were 1,1-di(4-methylphenyl)ethane, 1,2-bis(3-methylphenoxy)ethane, and 1,4-dibenzyloxybenzene. Stable isotope ratios showed that, although three species feed on the same trophic level, K. punctatus and T. niphobles live in waters farther offshore than those in which T. hakonensis live. The contributions of various factors to the accumulation were also assessed. The lipid content ( r2 = 0.512, p < 0.001) was found to be the significant factor that influenced accumulation of SRCs in fish. The results also revealed significant positive correlation between the accumulation patterns and SRC components in water ( r2 = 0.512-0.658, all p values <0.05), but they showed negative correlations between the SRCs in fish and log KOW values. This suggests that the aqueous route is the predominant route for the accumulation of SRCs in fish. This is the first study on the accumulation of aromatic sensitizers in aquatic biota. Environ. Toxicol. Chem. 2012;31:1202-1208. © 2012 SETAC [ABSTRACT FROM AUTHOR]

Aim: To explore the health beliefs of clinical and academic nurses from Japan, Australia and China regarding wearing paper masks to protect themselves and others, and to identify differences in participants' health beliefs regarding masks. Background: The correct use of face masks and consensus among health professionals across the globe is essential for containing pandemics, and nurses need to act according to policy to protect themselves, educate the public and preserve resources for frontline health workers. Paper masks are worn by health professionals and the general public to avoid the transmission of respiratory infections, such as COVID‐19, but there appear to be differences in health beliefs of nurses within and between countries regarding these. Methods: This qualitative descriptive study used content analysis with a framework approach. Findings: There were major differences in nurse participants' beliefs between and within countries, including how nurses use paper masks and their understanding of their efficacy. In addition, there were cultural differences in the way that nurses use masks in their daily lives and nursing practice contexts. Conclusion: Nurses from different working environments, countries and areas of practice hold a variety of health beliefs about mask wearing at the personal and professional level. Implications for nursing policy and health policy: The COVID‐19 pandemic has sparked much discussion about the critical importance of masks for the safety of health professionals, and there has been considerable discussion and disagreement about health policies regarding mask use by the general public. Improper use of masks may have a role in creating mask shortages or transmitting infections. An evidence‐based global policy on mask use for respiratory illnesses for health professionals, including nurses, and the general public needs to be adopted and supported by a wide‐reaching education campaign. [ABSTRACT FROM AUTHOR]

In Polistes paper wasps, haploid early males can mate with early emerging females and leave viable offspring. In contrast, diploid early males are eventually sterile because they contribute triploid offspring via diploid sperm. Clarifying the ploidy of early males is important for determining whether early male production is a reproductive strategy for the species. We examined the mating behavior and the ploidy of early males in the Japanese paper wasp, Polistes rothneyi iwatai van der Vecht. Thirteen early males from four colonies were all diploid. Two of the nine early males (22.2%) attempted to mate with females, but only one individual (11.1%) was successful (the female's spermatheca contained spermatozoa). These results suggest that although most early males of P. rothneyi iwatai do not produce offspring, their mating may be linked to the occasional production of triploid females. [ABSTRACT FROM AUTHOR]