Search

This research paper focuses on the use of solid biomass waste, specifically a combination of Polyalthia longifolia seed (PLSF) and graphite (GH) powder, as reinforcements in vinyl ester (VE) composites. The composites were produced via the hand layup method, with the filler concentration varying from 0 to 15 wt% of PLSF and 0–9 wt% of graphite. The objective was to examine the influence of the hybrid filler on the mechanical characteristics of the composites. The mechanical properties of composites prepared from P. longifolia seeds and graphite powder were experimentally characterized. These properties included tensile strength, flexural strength, impact resistance, and hardness. The hybrid composite had a maximum tensile strength of 48.4 MPa, and its tensile modulus was 1.66 GPa. The hybrid filler at 15% wt% of PLSF and 6% of graphite has the highest flexural strength, which is around 148 MPa. The ultimate impact strength and hardness were measured to be 41.3 kJ/m2 and 44.5, respectively, after the addition of 15 and 6 wt% of hybrid filler. In comparison to neat vinyl ester resin, the PLSF/GH‐VE composites exhibited an increase in tensile, flexural, impact, and hardness of 2.69, 1.82, 3.03, and 1.59 times, respectively. Hybrid composite surfaces were analyzed using scanning electron microscopes to determine surface characteristics and fractured surfaces. In addition, the PLSF/GH‐VE composites have been utilized in the production of components for four‐wheelers. Highlights: Investigated the impact of hybrid filler‐reinforced vinyl ester composites.Mechanical and thermal properties were experimentally characterized.Surface characteristics and fractured surfaces were examined.PLSF/GH‐VE composites are used in producing components for four‐wheelers. [ABSTRACT FROM AUTHOR]

The need for eco‐friendly materials has been attracted due to renewability, abundance availability, low cost, and so on. Therefore, the search for bio fillers for the fabrication of bio‐based composite materials is gaining more and more attention in both academic and industry circles because it promotes sustainability. The present study represents the utilization of biomass solid waste in the hybrid form of Tamarind Seed and Date Seed Filler (TSF/DSF) into polymer reinforced composite which has been explored for the first time by a compression molding technique. These fillers are bio‐waste that can be obtained at a minimal cost from renewable sources. An attempt has been made to use these hybrid fillers to reinforce the matrix ranging from 0 to 50 wt%, and their physical, mechanical, and thermal properties were investigated. In general, the inclusion of hybrid fillers increases mechanical properties, although the addition of hybrid fillers had only a minor impact on thermal properties. When compared to the pure vinyl ester resin, the hybrid fillers reinforced composites revealed a significant enhancement in tensile, flexural, impact, and hardness properties, with improvements of 1.51 times, 1.44 times, 1.87 times, and 1.46 times respectively, at 10 wt% filler loading. Filler matrix interaction of fractured mechanical testing samples was evaluated by scanning electron microscope. Based on the findings, hybrid filler reinforced composites may be suitable for applications where cost is a consideration and where minor compromises in thermal qualities are acceptable. [ABSTRACT FROM AUTHOR]