Search

The effects of xanthan gum on the structural modifications of myofibrillar proteins (0.3 M NaCl, pH 6) induced by high pressure (200, 400, and 600 MPa, 6 min) were investigated. The changes in the secondary and tertiary structures of myofibrillar proteins were analyzed by circular dichroism. The protein denaturation was also evaluated by differential scanning calorimetry. Likewise, the protein surface hydrophobicity and the solubility of myofibrillar proteins were measured. High pressure (600 MPa) induced the loss of α-helix structures and an increase of β-sheet structures. However, the presence of xanthan gum hindered the former mechanism of protein denaturation by high pressure. In fact, changes in the secondary (600 MPa) and the tertiary structure fingerprint of high-pressure-treated myofibrillar proteins (400 to 600 MPa) were observed in the presence of xanthan gum. These modifications were confirmed by the thermal analysis, the thermal transitions of high-pressure (400 to 600 MPa)-treated myofibrillar proteins were modified in systems containing xanthan gum. As consequence, the high-pressure-treated myofibrillar proteins with xanthan gum showed increased solubility from 400 MPa, in contrast to high-pressure treatment (600 MPa) without xanthan gum. Moreover, the surface hydrophobicity of high-pressure-treated myofibrillar proteins was enhanced in the presence of xanthan gum. These effects could be due to the unfolding of myofibrillar proteins at high-pressure levels, which exposed sites that most likely interacted with the anionic polysaccharide. This study suggests that the role of food additives could be considered for the development of meat products produced by high-pressure processing., (© 2015 Institute of Food Technologists®)

The interaction of salt (0%, 1.5%, and 3% in the final product) and a high-pressure treatment (500 MPa, 20 °C, 6 min) was investigated using pork biceps femoris muscle. The Warner-Bratzler shear force and the water holding capacity (WHC) were assessed and linked to the microstructure evaluation by environmental scanning electronic microscopy (ESEM). Pressure-treated and cooked samples showed a high Warner-Bratzler shear force with a low WHC compared to control cooked samples. These negative effects could be linked to the general shrinkage of the structure as observed by ESEM. The addition of 1.5% salt was sufficient to improve the technological properties of the high-pressure-treated samples and to counteract the negative effect of high pressure on texture and WHC. This phenomenon could be linked to the breakdown in structure observed by ESEM. This study states that it is possible to produce pressurized pork products of good eating quality by adding limited salt levels., (© 2012 Institute of Food Technologists®)

The effect of calcium and high-pressure (HP) treatment on the heat gelation of soybean proteins was investigated. In the presence of calcium (2 to 25 mM), the gelation of dispersions of soybean protein isolate (SPI), a beta-conglycinin-enriched fraction (7SEF), and a glycinin-enriched fraction (11SEF) started with protein having a lower degree of denaturation. The gels from these dispersions had greater stiffness than the samples without added calcium. HP treatment had different effects on heat-induced gelation depending on the presence of calcium and on the nature of the proteins. In the absence of calcium, gels with low stiffness were formed after HP treatment, compared with untreated samples, and regardless of the sample type (SPI, 7SEF, 11SEF). In the presence of calcium, gel stiffness was increased after HP treatment of dispersions containing beta-conglycinin (SPI and 7SEF), while the opposite effect was observed for 11SEF. In the presence of calcium, HP treatment promoted a greater contribution of hydrophobic interactions in SPI and 7SEF. In the dispersions containing beta-conglycinin, these conditions also promoted the appearance of a heterogeneous distribution of molecular sizes, from enormous aggregates to dissociated species. Our results suggest that, in the presence of calcium, HP treatment has an opposite effect on the ability of glycinin and beta-conglycinin to participate in the formation of a 3-dimensional network upon heating.

The formulation of gluten-free bread, which will be suitable for patients with coeliac disease, was optimized to provide bread similar to French bread. The effects of the presence of hydrocolloids and the substitution of the flour basis by flour or proteins from different sources were studied. The added ingredients were (1) hydrocolloids (carboxymethylcellulose [CMC], guar gum, hydroxypropylmethylcellulose [HPMC], and xanthan gum), and (2) substitutes (buckwheat flour, whole egg powder, and whey proteins). The bread quality parameters measured were specific volume, dry matter of bread, crust color, crumb hardness, and gas cell size distribution. Specific volume was increased by guar gum and HPMC. Breads with guar gum had color characteristics similar to French bread. Hardness decreased with the addition of hydrocolloids, especially HPMC and guar. Breads with guar gum had the most heterogeneous cell size distribution, and guar gum was therefore selected for further formulations. Bread prepared with buckwheat flour had improved quality: an increased specific volume, a softer texture, color characteristics, and gas-cell size distribution similar to French bread. Bread with 1.9% guar gum (w/w, total flour basis) and 5% buckwheat flour (of all flours and substitutes) mimicked French bread quality attributes.

Effects of pressure-shift freezing and/or pressure-assisted thawing on the quality of sea bass muscle were evaluated and compared with conventional (air-blast) frozen and thawed samples. Microstructural analysis showed a marked decrease of muscle cell damage for pressure-assisted frozen samples. According to differential scanning calorimetry (DSC), protein extractability, and SDS-PAGE results, high-pressure treatment (200 MPa) produced a partial denaturation with aggregation and insolubilization of the myosin, as well as alterations of the sarcoplasmic proteins. Only small differences between high-pressure processes (freezing or/and thawing) were registered. High-pressure-treated systems led to a decrease of water holding capacity but differences between high-pressure and conventional methods disappeared after cooking. Muscle color showed important alterations due to high-pressure treatments (increasing L* and b*).

Calpains (calcium-activated neutral proteases) of sea bass (Dicentrarchus labrax L.) muscle may participate in the degradation of muscle tissue during postmortem storage. These enzymes are regulated by calpastatin, their endogenous specific inhibitor. The objective of this study was to evaluate the changes encountered by the calpain system during the postmortem storage of fish muscle after high-pressure treatment. From 100 MPa, high-pressure treatment of purified calpains results in a loss of their activity as well as in the dissociation of the heterodimeric form. In muscle, the high-pressure processing decreases the initial activity of calpain. This loss in activity may be due to an inactivation by a change of structure. Initial calpastatin activity is not modified by the high-pressure treatment, but it decreases during the storage from the beginning for a treatment at 300 MPa after which calpastatin is stable during 2 d. Therefore, this study also suggests that high-pressure treatment could be a useful way to improve fish flesh quality.

High-pressure processing is finding a growing interest in the food industry. Among the advantages of this emerging process is the ability to favorably freeze and thaw food. This study aims at comparing the effect of different freezing and thawing processes on the quality of Atlantic salmon fillets. Atlantic salmon (Salmo salar) samples were frozen by Pressure-Shift Freezing (PSF, 200 MPa, -18 degrees C) and Air-Blast Freezing (ABF, -30 degrees C, 4 m/s). Samples were stored 1 mo at -20 degrees C and then subjected to different thawing treatments: Air-Blast Thawing (ABT, 4 degrees C, 4 m/s), Immersion Thawing (IMT, 20 degrees C), and Pressure-Assisted Thawing (PAT, 200 MPa, 20 degrees C). Changes in texture, color, and drip loss were investigated. The toughness of the PSF samples was higher than that of the ABF sample. The modification of color was more important during high-pressure process than during the conventional process. The PSF process reduced thawing drip compared with ABF. The presence of small ice crystals in the pressure-shift frozen sample is probably the major reason leading to the reduced drip volumes. The freezing process was generally much more influent on quality parameters than the thawing process. These results show the interaction between freezing and thawing processes on selected quality parameters.