Search

ispartof: VADOSE ZONE JOURNAL vol:21 issue:1 status: published

Multiannual data (2016–2018) from 12 weighed lysimeters (four soil types with textures ranging from sandy loam to silt loam, three replicates) of the TERENO SOILCan network were used to evaluate if evaporation (E) rates could be predicted from weather data using the FAO Penman–Monteith (PM) method combined with soil water flow simulations using the Richards equation. Soil hydraulic properties (SHPs) were estimated either from soil texture using the ROSETTA pedotransfer functions, from in situ measured water retention curves, or from soil surface water contents using inverse modeling. In all years, E was water limited and the measured evaporation rates (Em) surprisingly did not vary significantly among the four different soil types. When SHPs derived from pedotransfer functions were used, simulated evaporation rates of the finer textured soils overestimated the measured ones considerably. Better agreement was obtained when simulations were based on in situ measured or inversely estimated SHPs. The SHPs estimated from pedotransfer functions represented unrealistically large characteristic lengths of evaporation (Lc), and Lc was found to be a useful characteristic to constrain estimates of SHPs. Also, when soil evaporation was water limited and Em rates were below Epot (PM evaporation scaled by an empirical coefficient), the diurnal dynamics of Em followed those of Epot. The Richards equation that considers only isothermal liquid water flow did not reproduce these dynamics caused by temperature dependent vapor transport in the soil.

© 2019 The Author(s). Roots are known to use biopores as preferential growth pathways to overcome hard soil layers and access subsoil water resources. This study evaluates root- biopore interactions at the root-system scale under different soil physical and environmental conditions using a mechanistic simulation model and extensive experimental field data. In a field experiment, spring wheat (Triticum aestivum L.) was grown on silt loam with a large biopore density. X-ray computed tomography scans of soil columns from the field site were used to provide a realistic biopore network as input for the three-dimensional numerical R-SWMS model, which was then applied to simulate root architecture as well as water flow in the root-biopore-soil continuum. The model was calibrated against observed root length densities in both the bulk soil and biopores by optimizing root growth model input parameters. By implementing known interactions between root growth and soil penetration resistance into our model, we could simulate root systems whose response to biopores in the soil corresponded well to experimental observations described in the literature, such as increased total root length and increased rooting depth. For all considered soil physical (soil texture and bulk density) and environmental conditions (years of varying dryness), we found biopores to substantially mitigate transpiration deficits in times of drought by allowing roots to take up water from wetter and deeper soil layers. This was even the case when assuming reduced root water uptake in biopores due to limited root-soil contact. The beneficial impact of biopores on root water uptake was larger for more compact and less conductive soils. ispartof: VADOSE ZONE JOURNAL vol:18 issue:1 status: published

Evaporation from bare soil surfaces can be restrained to a great extent with the development of a dry layer at the soil surface where capillary hydraulic conductance ceases and water flow proceeds only by gas phase transport. Model calculations and preliminary experiments with model porous media have shown that this surface layer can be very thin. An accurate characterization of these processes is required, which is provided by noninvasive magnetic resonance (MR) methods. The evaporative drying of a silt loam and a sandy loam was monitored at high spatial resolution in laboratory experiments. The MR data were used to assess the performance of two numerical models: (i) the Richards equation, which considers isothermal liquid water flow, and (ii) a coupled soil water, heat, and vapor flow numerical model. The experimental results reveal two distinct drying regimes for both soil types where, at the onset of the second evaporation stage, a dry surface zone developed with increasing thickness over time. This layer revealed that water loss inside the soil coincided with a relatively low evaporation rate as the liquid continuity to the soil surface vanished. The modeling results clearly demonstrated the need to consider heat and vapor flow. It was shown, as a proof of principle, that MR relaxation time spectra may serve as a proxy to follow desaturation processes where spatially resolved transverse relaxation can reveal a secondary evaporation front.

This special section of Vadose Zone Journal (VZJ) contains 15 contributions focusing on the physical, biological, and chemical aspects of water and solute transport into and through the soil root zone, including root water and solute uptake. The papers stem from presentations at the 2016 Kirkham Conference, “The Root Zone: Soil Physics and Beyond,” which took place at the Sede Boqer campus of Ben-Gurion University of the Negev, Israel, during 10 to 14 April (https://www.soils.org/membership/divisions/soil-physics-and-hydrology/kirkham-conferences). Much consensus existed at the conference for a special VZJ section to reflect the importance of the soil root zone from many disciplinary perspectives (soil, environmental, agricultural, hydrologic, and atmospheric) and the complexity of the basic processes involved. The contributions deal with root zone processes at different scales and from different disciplinary viewpoints, while covering a broad range of topics from the very theoretical to important practical applications. Special emphasis is on novel measurement and modeling tools at various scales and the need for interdisciplinary research.

Soil, through its various functions, plays a vital role in the Earth's ecosystems and provides multiple ecosystem services to humanity. Pedotransfer functions (PTFs) are simple to complex knowledge rules that relate available soil information to soil properties and variables that are needed to parameterize soil processes. In this paper, we review the existing PTFs and document the new generation of PTFs developed in the different disciplines of Earth system science. To meet the methodological challenges for a successful application in Earth system modeling, we emphasize that PTF development has to go hand in hand with suitable extrapolation and upscaling techniques such that the PTFs correctly represent the spatial heterogeneity of soils. PTFs should encompass the variability of the estimated soil property or process, in such a way that the estimation of parameters allows for validation and can also confidently provide for extrapolation and upscaling purposes capturing the spatial variation in soils. Most actively pursued recent developments are related to parameterizations of solute transport, heat exchange, soil respiration, and organic carbon content, root density, and vegetation water uptake. Further challenges are to be addressed in parameterization of soil erosivity and land use change impacts at multiple scales. We argue that a comprehensive set of PTFs can be applied throughout a wide range of disciplines of Earth system science, with emphasis on land surface models. Novel sensing techniques provide a true breakthrough for this, yet further improvements are necessary for methods to deal with uncertainty and to validate applications at global scale.

Limited knowledge about the spatial distribution of aquifer properties typically constrains our ability to predict subsurface flow and transport. Here we investigate the value of using high resolution full-waveform inversion of cross-borehole ground penetrating radar (GPR) data for aquifer characterization. By stitching together GPR tomograms from multiple adjacent crosshole planes, we are able to image, with a decimeter scale resolution, the dielectric permittivity and electrical conductivity of an alluvial aquifer along cross sections of 50 m length and 10 m depth. A logistic regression model is employed to predict the spatial distribution of lithological facies on the basis of the GPR results. Vertical profiles of porosity and hydraulic conductivity from direct-push, flowmeter and grain size data suggest that the GPR predicted facies classification is meaningful with regard to porosity and hydraulic conductivity, even though the distributions of individual facies show some overlap and the absolute hydraulic conductivities from the different methods (direct-push, flowmeter, grain size) differ up to approximately one order of magnitude. Comparison of the GPR predicted facies architecture with tracer test data suggests that the plume splitting observed in a tracer experiment was caused by a hydraulically low-conductive sand layer with a thickness of only a few decimeters. Because this sand layer is identified by GPR full-waveform inversion but not by conventional GPR ray-based inversion we conclude that the improvement in spatial resolution due to full-waveform inversion is crucial to detect small-scale aquifer structures that are highly relevant for solute transport.