Search

Biocompatible and blood-compatible surface modification is urgently needed for stainless steel (SUS)-based human implant devices to avoid inflammation and biofouling. To this end, the use of polymeric surface modifiers, whose surface properties are specifically tailored, is a promising approach since this approach minimizes the impact on device's mechanical properties. However, adhesion between the device and surface modifier is relatively weak, since van der Waals forces are employed, leading to low device durability. To address this issue, this work functionalized poly(ɛ-caprolactone)-b-[poly(α-chloride-ɛ-caprolactone)-b-poly(2-methacryloyloxyethyl phosphorylcholine)]2 (PCL-b-(PCL-Cl-b-PMPC)2) with catechol groups via a nucleophilic substitution, whereby the catechol functionalization was optimized. The resultant surface modifier showed strong adhesion toward SUS surfaces, forming a smooth and uniform hydrophilic polymeric film that reduced SUS fouling (i.e., protein). Notably, no significant changes of adhesion between the SUS and thin films (thin film) were observed after immersion for 45 days in a pH 7.4 phosphate buffer solution. © 2017 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2018, 56, 38–49

The effect of molecular weight on the molecular aggregation structure of polymers bearing a pendant perylenediimide (PDI) side chain, designated PAc12PDI, was investigated using synchrotron radiation X-ray diffraction measurements. It was found that depending on molecular weight, either the main chain axis or the side chain axis behaves as the longitudinal axis in fiber samples and was aligned parallel to the fiber axis. A similar phenomenon is present in thin film samples, but was complicated by the additional influence of the interfacial free energy of the side chain group. Even in the case of the polymer with lower molecular weight, the face plane of PDI was found to show both parallel and perpendicular orientations to the substrate (i.e., flat-on and edge-on orientations). On the other hand, if the length of the main chain is sufficiently long with respect to the length of the side chain, the face plane of PDI was oriented perpendicular to the substrate, leading to an edge-on orientation in the thin film. © 2016 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2016, 54, 2275–2283

We report the self-assembly of organic-inorganic block copolymers (BCP) in thin-films by simple solvent annealing on unmodified substrates. The resulting vertically oriented lamellae and cylinders are converted to a hard silica mask by a single step highly selective oxygen plasma etching. The size of the resulting nanostructures in the case of cylinders is less than 10 nm.

As a polymer interfacial modifier, poly(methyl methacrylate) (PMMA) terminated with elemental blocks of polyhedral oligomeric silsesquioxane (POSS) has been exploited through the phenomenon of preferential segregation in PMMA films. The modifier synthesized by living anionic polymerization using a bifunctional initiator is segregated at the surface in the mixture of PMMA due to a “buoy” effect of the POSS blocks. This further results in the surface wettability of PMMA being regulated on the basis of the amount of the modifier fed into the matrix. Finally, it is shown that the amount of the modifier in the PMMA films affects the cell proliferation behavior via the wettability.