Search

Fine powders synthesized via sol-gel route were employed to fabricate Sr(2-x)(Na0.5Bi0.5)(x)Bi4Ti5O18 (SNBT, where x = 0, 0.1, 0.25, 0.3, 0.4, and 0.5) ceramics. The composition (x)-dependent structural changes associated with SNBT ceramics were analyzed using X-ray powder diffraction, transmission electron microscopy, and Raman spectroscopic techniques. Average grain size analyses carried out on the SNBT ceramics by scanning electron microscopy revealed an important role played by the dopants in inhibiting the grain growth. Dielectric constants and the Curie temperature of the ceramics were found to decrease and increase, respectively, with increase in x. The increase in Curie temperature with increase in x was attributed to the decrease in the tolerance factor. The specific composition (x = 0.3) of the SNBT ceramics exhibited improved piezo- and ferroelectric properties associated with a higher Curie temperature (569 K). The piezoelectric coefficient (d(33)) and the planar electromechanical coupling coefficient (k(p)) of SNBT(x = 0.3) were enhanced by 25% and 42%, respectively, as compared to the undoped ceramics.

Nanocrystalline powders of Ba1-xMgxZr0.1Ti0.9O3 (x = 0.025-0.1) were synthesized via citrate assisted sol-gel method. Interestingly, the one with x = 0.05 in the system Ba1-xMgxZr0.1Ti0.9O3 exhibited fairly good piezoelectric response aside from the other physical properties. The phase and structural confirmation of synthesized powder was established by X-ray powder diffraction (XRD) and Raman Spectroscopic techniques. Two distinct Raman bands i.e., 303 and 723 cm(-1) characteristic of tetragonal phase were observed. Thermogravimetric analysis (TGA) was performed to evaluate the phase decomposition of the as-synthesized Ba0.95Mg0.05Zr0.1Ti0.9O3 sample as a function of temperature. The average crystallite size associated with Ba0.95Mg0.05Zr0.1Ti0.9O3 was calculated using Scherrer formula based on the XRD data and was found to be 25 nm. However, Scanning and Transmission Electron Microscopy studies revealed the average crystallite size to be in the range of 30-40 nm, respectively. Kubelka-Munk function was employed to determine the optical band gap of these nanocrystallites. A piezoelectric response of 26 pm/V was observed for Ba0.95Mg0.05Zr0.1Ti0.9O3 nanocrystal by Piezoresponse Force Microscopy (PFM) technique. Photoluminescence (PL) study carried out on these nanocrystals exhibited a blue emission (470 nm) at room temperature.

Poly(N-isopropylacrylamide) (PNIPAM) hydrogels were simply prepared by free radical polymerization in different methanol–water mixture. A scanning electron microscopy study revealed that the freeze-dried hydrogels were macroporous. The swelling ratios in water at 20°C of the resulting hydrogels followed the order: X0.43>X0.21>X0.76 ≈ X0.57>X0.31>X0.13>X0.06>X0, where Xm denotes a gel prepared in a methanol–water mixture with m mole fraction of methanol (xm). Below the lower critical solution temperature, the swelling ratio values of all of the hydrogels gradually decreased with the increase in the temperature. The complete collapse of the PNIPAM chain of all the gels occurred at about 38°C, whereas the same was observed at about 35°C for the conventional gel prepared in water. The swelling ratio values of all the PNIPAM gels in the methanol–water mixtures with different xm values at 20°C passed through a minimum in the cononsolvency zone. The deswelling rates of the hydrogels decreased in the following order: X0.43> X0.31> X0.21> X0.57> X0.76 ≈ X0.13> X0.06> X0. The reswelling rates of these hydrogels decreased in the following order: X0> X0.31> X0.06 ≈ X0.13 > X0.76> X0.57> X0.21> X0.43. The release rates of the Tramadol Hydrochloride drug at 37°C from the drug-loaded hydrogels were almost same for all of the hydrogels. © 2012 Wiley Periodicals, Inc. J Appl Polym Sci, 2012