Search

As of 2022, breast cancer continues to be the most diagnosed cancer worldwide. This problem persists within the United States as well, as the American Cancer Society has reported that ∼12.5% of women will be diagnosed with invasive breast cancer over the course of their lifetime. Therefore, a clinical need continues to exist to address this disease from a treatment and therapeutic perspective. Current treatments for breast cancer and cancers more broadly include surgery, radiation, and chemotherapy. Adjuncts to these methods have been developed to improve the clinical outcomes for patients. One such adjunctive treatment is mild hyperthermia therapy (MHTh), which has been shown to be successful in the treatment of cancers by increasing effectiveness and reduced dosage requirements for radiation and chemotherapies. MHTh-assisted treatments can be performed with invasive thermal devices, noninvasive microwave induction, heating and recirculation of extracted patient blood, or whole-body hyperthermia with hot blankets.One common method for inducing MHTh is by using microwave for heat induction and magnetic resonance imaging for temperature monitoring. However, this leads to a complex, expensive, and inaccessible therapy platform. Therefore, in this work we aim to show the feasibility of a novel all-acoustic MHTh system that uses focused ultrasound (US) to induce heating while also using US tomography (UST) to provide temperature estimates. Changes in sound speed (SS) have been shown to be strongly correlated with temperature changes and can therefore be used to indirectly monitor heating throughout the therapy. Additionally, these SS estimates allow for heterogeneous SS-corrected phase delays when heating complex and heterogeneous tissue structures.Feasibility to induce localized heat in tissue was investigated in silico with a simulated breast model, including an embedded tumor using continuous wave US. Here, both heterogenous acoustic and thermal properties were modeled in addition to blood perfusion. We further demonstrate, with ex vivo tissue phantoms, the feasibility of using ring-based UST to monitor temperature by tracking changes in SS. Two phantoms (lamb tissue and human abdominal fat) with latex tubes containing varied temperature flowing water were imaged. The measured SS of the water at each temperature were compared against values that are reported in literature.Results from ex vivo tissue studies indicate successful tracking of temperature under various phantom configurations and ranges of water temperature. The results of in silico studies show that the proposed system can heat an acoustically and thermally heterogenous breast model to the clinically relevant temperature of 42°C while accounting for a reasonable time needed to image the current cross section (200 ms). Further, we have performed an initial in silico study demonstrating the feasibility of adjusting the transmit waveform frequency to modify the effective heating height at the focused region. Lastly, we have shown in a simpler 2D breast model that MHTh level temperatures can be maintained by adjusting the transmit pressure intensity of the US ring.This work has demonstrated the feasibility of using a 256-element ring array transducer for temperature monitoring; however, future work will investigate minimizing the difference between measured SS and the values shown in literature. A hypothesis attributes this bias to potential volumetric average artifacts from the ray-based SS inversion algorithm that was used, and that moving to a waveform-based SS inversion algorithm will greatly improve the SS estimates. Additionally, we have shown that an all-acoustic MHTh system is feasible via in silico studies. These studies have indicated that the proposed system can heat a tumor within a heterogenous breast model to 42°C within a narrow time frame. This holds great promise for increasing the accessibility and reducing the complexity of a future all-acoustic MHTh system.

Purpose: High breast density, as measured by mammography, is associated with increased breast cancer risk, but standard methods of assessment have limitations including 2D representation of breast tissue, distortion due to breast compression, and use of ionizing radiation. Ultrasound tomography (UST) is a novel imaging method that averts these limitations and uses sound speed measures rather than x-ray imaging to estimate breast density. The authors evaluated the reproducibility of measures of speed of sound and changes in this parameter using UST. Methods: One experienced and five newly trained raters measured sound speed in serial UST scans for 22 women (two scans per person) to assess inter-rater reliability. Intrarater reliability was assessed for four raters. A random effects model was used to calculate the percent variation in sound speed and change in sound speed attributable to subject, scan, rater, and repeat reads. The authors estimated the intraclass correlation coefficients (ICCs) for these measures based on data from the authors’ experienced rater. Results: Median (range) time between baseline and follow-up UST scans was five (1–13) months. Contributions of factors to sound speed variance were differences between subjects (86.0%), baseline versus follow-up scans (7.5%), inter-rater evaluations (1.1%), and intrarater reproducibility (∼0%). When evaluatingmore » change in sound speed between scans, 2.7% and ∼0% of variation were attributed to inter- and intrarater variation, respectively. For the experienced rater’s repeat reads, agreement for sound speed was excellent (ICC = 93.4%) and for change in sound speed substantial (ICC = 70.4%), indicating very good reproducibility of these measures. Conclusions: UST provided highly reproducible sound speed measurements, which reflect breast density, suggesting that UST has utility in sensitively assessing change in density.« less

Purpose: To explore the feasibility of improving cross-sectional reflection imaging of the breast using refractive and attenuation corrections derived from ultrasound tomography data. Methods: The authors have adapted the planar Kirchhoff migration method, commonly used in geophysics to reconstruct reflection images, for use in ultrasound tomography imaging of the breast. Furthermore, the authors extended this method to allow for refractive and attenuative corrections. Using clinical data obtained with a breast imaging prototype, the authors applied this method to generate cross-sectional reflection images of the breast that were corrected using known distributions of sound speed and attenuation obtained from the same data. Results: A comparison of imagesreconstructed with and without the corrections showed varying degrees of improvement. The sound speed correction resulted in sharpening of detail, while the attenuation correction reduced the central darkening caused by path length dependent losses. The improvements appeared to be greatest when dense tissue was involved and the least for fatty tissue. These results are consistent with the expectation that denser tissues lead to both greater refractive effects and greater attenuation. Conclusions: Although conventional ultrasound techniques use time-gain control to correct for attenuation gradients, these corrections lead to artifacts because the true attenuation distribution is not known. The use of constant sound speed leads to additional artifacts that arise from not knowing the sound speed distribution. The authors show that in the context of ultrasound tomography, it is possible to construct reflection images of the breast that correct for inhomogeneous distributions of both sound speed and attenuation.

Although mammography is the gold standard for breast imaging, its limitations result in a high rate of biopsies of benign lesions and a significant false negative rate for women with dense breasts. In response to this imaging performance gap we have been developing a clinical breast imaging methodology based on the principles of ultrasound tomography. The Computed Ultrasound Risk Evaluation (CURE) system has been designed with the clinical goals of whole breast, operator-independent imaging, and differentiation of breast masses. This paper describes the first clinical prototype, summarizes our initial image reconstruction techniques, and presents phantom and preliminary in vivo results. In an initial assessment of its in vivo performance, we have examined 50 women with the CURE prototype and obtained the following results. (1) Tomographic imaging of breast architecture is demonstrated in both CURE modes of reflection and transmission imaging. (2) In-plane spatial resolution of 0.5 mm in reflection and 4 mm in transmission is achieved. (3) Masses > 15 mm in size are routinely detected. (4) Reflection, sound speed, and attenuation imaging of breast masses are demonstrated. These initial results indicate that operator-independent, whole-breast imaging and the detection of breast masses are feasible. Future studies will focus on improved detection and differentiation of masses in support of our long-term goal of increasing the specificity of breast exams, thereby reducing the number of biopsies of benign masses.

Women with high mammographic breast density have a four- to fivefold increased risk of developing breast cancer compared to women with fatty breasts. Many preventative strategies have attempted to correlate changes in breast density with response to interventions including drugs and diet. The purpose of this work is to investigate the feasibility of assessing breast density with acoustic velocity measurements with ultrasoundtomography, and to compare the results with existing measures of mammographic breast density. An anthropomorphic breast tissue phantom was first imaged with our computed ultrasoundtomography clinical prototype. Strong positive correlations were observed between sound speed and material density, and sound speed and computed tomography number (Pearson correlation coefficients = 0.87 and 0.91, respectively). A cohort of 48 women was then imaged. Whole breast acoustic velocity was determined by creating image stacks and evaluating the sound speed frequency distribution. The acoustic measures of breast density were evaluated by comparing these results to two mammographic density measures: (1) qualitative estimates determined by a certified radiologist using the BI-RADS Categorical Assessment based on a 1 (fatty) to 4 (dense) scale, and (2) quantitative measurements via digitization and computerized analysis of archival mammograms. A one-way analysis of variance showed that a significant difference existed between the mean values of sound speed according to BI-RADS category, while post hoc analyses using the Scheffe criterion for significance indicated that BI-RADS 4 (dense) patients had a significantly higher sound speed than BI-RADS 1, 2, and 3 at an alpha level of 0.05. Using quantitative measures of breast density, a direct correlation between the mean acoustic velocity and calculated mammographic percent breast density was demonstrated with correlation coefficients ranging from 0.75 to 0.89. The results presented here support the hypothesis that sound speed can be used as an indicator of breast tissue density. Noninvasive, nonionizing monitoring of dietary and chemoprevention interventions that affect breast density are now possible.

Continued improvements in existing low frequency radio interferometers are expected, but limits of sensitivity, angular resolution, and frequency range impose fundamental restrictions which cannot easily be overcome. This has inspired the development of the Low Frequency ARray (LOFAR) which will provide significantly increased imaging power over present low frequency systems. In light of advantages offered by recent low frequency observations of the Galactic center, we consider how LOFAR might impact the field by the end of this decade.