Search

Al–TiO2–C–La2O3 refiners were synthesized by the in-situ exothermic dispersion method using TiO2, C, Al and La2O3 powders as raw materials. Scanning electron microscopy equipped with energy dispersive X-ray spectrometry and X-ray diffraction were used to investigate the microstructures of the Al–TiO2–C–La2O3 refiners. Commercial pure aluminum was refined by the Al–TiO2–C–La2O3 refiners, aimed at investigating refining performance and the resistance to recession. The results show that the Al–TiO2– C–La2O3 refiner with 0.2% La2O3 is composed of α-Al, blocky Al3Ti, dispersive Al2O3 and TiC, which has a better refining effect on commercial pure aluminum than the Al– TiO2–C refiner. The average grain size refined by the above refiner is about 80 μm and it performs better and has a longer refining effect. The grain structure refined by Al–TiO2– C–La2O3 becomes finer within 5 min and remains the same after 120 min, while refined by the Al–TiO2–C refiner the equivalent times are 10 min and 30 min respectively.

Near-eutectic Al-Si alloys have low strength and high brittleness because of the presence of many eutectic b-Si flakes, needle-like Al-Fe-Si intermetallics, and coarse α-Al grains. This study disclosed the effects of cerium-rich RE (rare earth) element modification on orientation characters of crystals, formation of Al-Ce compounds, and microstructural refinement to improve the microstructure and mechanical properties of the alloys. The RE addition depressed preferential growth along the close-packed and/or sub-closepacked planes and promoted growth along the non-closepacked planes, in which La and other elements were dissolved into needle-like Al11Ce3 phase. When the temperature decreased, Al11Ce3 was preferentially crystallized from the melts and then devitrified by attaching to the surface of β-Al5FeSi needles. Moreover, many small Al11Ce3 particles were precipitated in the matrix and on the Si surface by a T6 heat treatment. Eutectic β-Si phases were constructed into discontinuous networks, short rods, and even particles by RE additions, which were further transformed into fine nodules following the T6 treatment. α-Al grains and primary β-Al5FeSi needles were simultaneously refined. The addition of 1.0 wt.% REs and subsequent T6 treatment yielded the highest tensile strength, elongation, and hardness of the alloy.