Search

The tensile strength, elognation and microstructure of alloy are respectively tested and observed after annealing treatment. The results show that the working rate the larger, the initial recrystallization temperature the lesser. The proper middle annealing process of Cu-Ag alloy with 80% deformation is 405°C×5h.

The tensile strength, elongation and microstructure of alloy are respectively tested and observed after annealing treatment. The results show that the working rate the larger, the initial recrystallization temperature the lesser. The proper middle annealing process of HSn88-1 alloy with 80% deformation is 460°C×5h.

Concrete pavement joints are an important part of the cement concrete pavement, and joints are the weak link of the concrete pavement. It is also one of the main causes of early diseases and failure of cement concrete pavement. This paper summarizes the outcome of the predecessors, introduces the research status of the joints, and analysis the joint destruction and its cause from the point of view of the stress.

The corrosion properties of Mg-Al-Sr alloy was characterized with comparison to AZ91D alloy. With the addition of Mg-Sr master alloy, the grain size of Mg alloy refined and the corrosion resistance was improved. The experimental results indicated that the formation of small amount of Al4Sr phase was favorable to improve the corrosion resistance. However, with the increase of Al4Sr stripy phase, the area ratio of cathode to anode will increase, resulting in the decrease of corrosion resistance potential.

Mg-Sr alloy was prepared by the vacuum synchronous reduction method at a temperature of 1100°C. The phase composition of the reaction product and slag was analyzed by XRD. Results showed that Mg17Sr2 and α-Mg were formed in the product while Ca2SiO4 and Sr2SiO4 existed in the slag. DSC-TG curves obtained from thermal analysis of the reduction process indicated that vacuum was an essential condition in the preparation of Mg-Sr alloy by synchronous thermal reduction method when temperature was below 1200°C.