Search

Boom clay, a stiff clay, has been selected as a potential host formation for the geological disposal of radioactive waste in Belgium. The underground research facility HADES has been constructed to enable various in situ experiments to be performed on Boom clay so as to study the feasibility of high-level radioactive waste disposal, and to provide reliable data on the performance of Boom clay as a host formation. Among the various laboratory studies performed on samples extracted from the HADES facility to investigate the thermo-hydro-mechanical behaviour of Boom clay, relatively few were devoted to the time-dependent behaviour, limiting any relevant analysis of the long-term behaviour of the disposal facility. The present work aims at investigating the time-dependent behaviour of Boom clay under both thermal and mechanical loading. High-pressure triaxial tests at controlled temperatures were carried out for this purpose. The tests started with constant-rate thermal and/or mechanical consolidation and ended with isobar heating and/or isothermal compression at a constant stress rate or by step loading. The results obtained confirmed the effect of the overconsolidation ratio (OCR) on the thermal volume changes (i.e. thermal dilation under high OCRs and thermal contraction with OCR close to unity). Significant effects of temperature as well as of compression and heating rates were also observed on the volume change behaviour. After being loaded to a stress lower than the preconsolidation pressure (5 MPa) at a low temperature of 25°C and at a rate lower than 0.2 kPa/min, the sample volume changes seemed to be quite small, suggesting a full dissipation of pore water pressure. By contrast, after being subjected to high loading and heating rates (including step loading or step heating), the volume changes appeared to be significant, particularly in the case of stresses much higher than the preconsolidation pressure. Because of its low permeability, full consolidation of Boom clay required a long period of time, and it was difficult to distinguish consolidation and creep from the total volume change with time. [ABSTRACT FROM AUTHOR]

The research and development programme on geological disposal for high-level and long-lived waste (HLW) in Belgium was initiated in 1974. A deep tertiary clay formation, the Boom Clay, present under the Mol-Dessel nuclear site, was selected as a reference host formation for experimental purposes. The construction of the underground laboratory HADES (at a depth of 223 m, initiated in 1980 and extended in 2002) allowed the building of a valuable geotechnical database, and led to the development of improved excavation techniques that significantly reduce the excavation-damaged zone (EDZ). Since the operational start of HADES about 25 years ago, many geotechnical measurements have been performed around excavations. Comparison between in situ measurements and modelling results allowed a continuous improvement of our knowledge on the Boom Clay behaviour. Important issues for interpreting the measurements correctly are good control of the excavation parameters and the boundary conditions. An extensive characterisation of the hydromechanical response of Boom Clay around an excavation for short- and long-term conditions has been performed. One important finding was the occurrence of measurable hydraulic effects at a distance of about 60 m (12.5 tunnel diameters) ahead of the tunnel excavation. [ABSTRACT FROM AUTHOR]