Search

Soft robot arms possess such characteristics as light weight, simple structure and good adaptability to the environment, among others. On the other hand, robust control of soft robot arms presents many difficulties. Based on these reasons, this paper presents a novel design and modeling of a fuzzy active disturbance rejection control (FADRC) controller for a soft PAM arm. The soft arm comprises three contractile and one extensor PAMs, which can vary its stiffness independently of its position in space. Force analysis for the soft arm is conducted, and stiffness model of the arm is established based on the relational model of contractile and extensor PAM. The accuracy of stiffness model for the soft arm was verified through experiments. Associated to this, a controller based on the fuzzy adaptive theory and active disturbance rejection control (ADRC), FADRC, has been designed to control the arm. The fuzzy adaptive theory is used to adjust the parameters of the ADRC, the control algorithm has the ability to control stiffness and position of the soft arm. In this paper, FADRC was further verified through comparative experiments on the soft arm. This paper reinforces the hypothesis that FADRC control, as an algorithm, indeed possesses good robustness and adaptive abilities. [ABSTRACT FROM AUTHOR]

McKibben muscles have been shown to have improved stiffness characteristics when operating hydraulically. However when operating pneumatically, they are compliant and so have potential for safer physical human–robot interaction. This paper presents a method for rapidly switching between pneumatic and hydraulic modes of operation without the need to remove all hydraulic fluid from the actuator. A compliant and potentially safe pneumatic mode is demonstrated and compared with a much stiffer hydraulic mode. The paper also explores a combined pneumatic/hydraulic mode of operation which allows both the position of the joint and the speed at which it reacts to a disturbance force to be controlled. [ABSTRACT FROM AUTHOR]

This paper proposes a new type of circular ring traveling wave linear ultrasonic motor with incomplete teeth. The motor's movable slider is pressed against the end face of the tooth structure on the outer surface of the circular ring vibrator under a certain pre-pressure, four piezoelectric ceramic plates are evenly distributed at 90° intervals on the inner side of the circular structure, and four sets of driving teeth are arranged at 45° intervals from the position of the piezoelectric ceramic plates.When the motor is in operation, only one driving tooth works, and the life of the ultrasonic motor can be increased by rotating the different working teeth. The motor operates in two in-plane third-order bending modes that are orthogonal to each other at the same frequency. The dynamic design and simulation of the vibrator was carried out using ANSYS finite element software to analyze the effect of the structure on the mode. The principle prototype was fabricated, and the operating mode of the vibrator was measured using a laser Doppler vibrometer (LDV), and the vibration characteristics and output performance of the prototype were tested. Experimental results show that the motor runs smoothly at the excitation voltage of 240 V peak-to-peak, the excitation frequency of 30.459 kHz and the pre-pressure of 0.6 N, with the maximum output force of 90 mN and the motor no-load speed of 102 mm/s. [ABSTRACT FROM AUTHOR]