Search

To further elucidate the mechanism of energy-conserving conveying in horizontal pneumatic conveying with the dune model, the high-speed particle image velocimetry is applied to measure particle fluctuation velocity near the minimum conveying velocity of the conventional pneumatic conveying. This study focuses on the effect of mounting dune models on the horizontal pneumatic conveying in terms of power spectrum, autocorrelation coefficients, two-point correlation coefficients, fluctuation intensity of particle velocity, skewness factor, and probability density function. It is found that the power spectrum peaks with the dune model are larger than those of the nondune system, suggesting the acceleration and suspending efficiency of the dune model, especially dune models mounted at the bottom of the pipe. Meanwhile, the profiles of particle fluctuation velocity intensity indicate that the large particle fluctuating energy is generated due to mounting the dune model so that the particles are more easily accelerated and suspended. This is one of the important reasons why the mounted dune model results in a low pressure drop and low minimum conveying velocity. Based on the distribution of skewness factor and probability density function, it is found that the particle fluctuation velocities of all cases follow the Gaussian distribution in the lower and middle parts of the pipe. The particle fluctuation velocities in the case of the dune models mounted at the bottom of the pipe obey the Gaussian-type fluctuation more. [ABSTRACT FROM AUTHOR]

A horizontal dilute-phase pneumatic conveying system using vertically oscillating soft fins at the inlet of the gas–particle mixture was studied to reduce the power consumption and conveying velocity in the conveying process. The effect of different fin lengths on horizontal pneumatic conveying was studied in terms of the pressure drop, conveying velocity, power consumption, particle velocity, and intensity of particle fluctuation velocity for the case of a low solid mass flow rate. The conveying pipeline consisted of a horizontal smooth acrylic tube with an inner diameter of 80 mm and a length of approximately 5 m. Two types of polyethylene particles with diameters of 2.3 and 3.3 mm were used as conveying materials. The superficial air velocity was varied from 10 to 17 m/s, and the solid mass flow rates were 0.25 and 0.20 kg/s. Compared with conventional pneumatic conveying, the pressure drop, MPD (minimum pressure drop), critical velocities, and power consumption can be reduced by using soft fins in a lower air velocity range, and the efficiency of fins becomes more evident when increasing the length of fins or touching particles stream by the long fins. The maximum reduction rates of the MPD velocity and power consumption when using soft fins are approximately 15% and 26%, respectively. The magnitude of the vertical particle velocity for different lengths of fins is clearly lower than that of the vertical particle velocity for a non-fin conveying system near the bottom of the pipeline, indicating that the particles are easily suspended. The intensities of particle fluctuation velocity of using fins are larger than that of non-fin. The high particle fluctuation energy implies that particles are easily suspended and are easily conveyed and accelerated. [ABSTRACT FROM PUBLISHER]