Search

Microbial lipids are a valuable source of potential biofuels and essential polyunsaturated fatty acids. The optimization of the fermentation conditions is a strategy that affects the total lipid concentration. The genus Nigrospora sp. has been the target of investigations based on its potential bioherbicidal action. Therefore, this study developed a strategy to maximize the biomass concentration and lipid accumulation by Nigrospora sp. in submerged fermentation. Different media compositions and process variables were investigated in shaken flasks and bioreactor in batch and fed-batch modes. Maximum biomass concentration and lipid accumulations were 40.17 g/L and 21.32 wt% in the bioreactor, which was 2.1 and 5.4 times higher than the same condition in shaken flasks, respectively. This study presents relevant information to the production of fungal lipids since few investigations are exploring the fed-batch strategy to increase the yield of fungi lipids, as well as few studies investigating Nigrospora sp. to produce lipids. [ABSTRACT FROM AUTHOR]

This study describes the use of spray drying technology to obtain a powder containing biomolecules with herbicidal activity produced by submerged fermentation using Diaporthe schini. The efficiency of the bioherbicide was tested for the post-emergence control of Bidens pilosa L., Amaranthus viridis L., Echinochloa crusgalli (L.) Beauv., and Lolium multiflorum Lam. In the first step, different additives were used and lactose was the most suitable one because it resulted in high herbicidal activity and weed suppression. In the second step, process variables were investigated, including inlet air temperature, drying air flow rate, and feed flow rate. The highest herbicidal activity was obtained with an inlet air temperature of 100°C, and air and feed flow rates of 1.4 m3/min and 0.22 L/h, respectively. Maximum herbicidal activities were 38, 45, 21 and 18%, while weed heights reduction were 69.0, 74.3, 20.4 and 24.8% for B. pilosa, A. viridis, E. crusgalli and L. multiflorum, respectively. The bioherbicide was effective to suppress weed growth and spray drying is a promising technology for the production of solid formulations of bioherbicides. [ABSTRACT FROM AUTHOR]

Weed control is a critical factor to ensure productivity and quality for food production. Chemical control is the main method used worldwide, but the demand for healthier food and the farmers' health and environment concerns have led to an increase in the search for alternative control methods. In this way, the use of biomolecules produced by microorganisms that present phytotoxic activity against weeds, such as exopolysaccharides, is attracting attention. For this purpose, this work compared two techniques (solid-state and submerged fermentation) for bioherbicide production by Diaporthe schini. Physicochemical characterization of both fermented broth and evaluation of bioherbicidal effect in post-emergence of Amaranthus viridis, Bidens pilosa, Echinocloa crusgalli, and Lollium multiflorum were performed. Fungal broth obtained by submerged fermentation presented better physicochemical characteristics in terms of viscosity, density, and surface tension. Overall, it was more effective than the broth obtained by solid-state fermentation for weed control because it presented an average inhibition of 40% of weed growth and 45% lower surface tension if compared to the control test. Also, reductions of 1.4–4.2 times of root dry mass, 2.9–5.8 times of shoot dry mass and 1.2–3.9 times of weeds heights, if compared to the control test, were achieved. [ABSTRACT FROM AUTHOR]

The natural ability of microorganisms to secrete high levels of bioactive compounds make them attractive hosts for producing novel compounds. Microbial biopolymers have potential applications in most of the sectors of the world economy. According to the physicochemical properties, they present some advantages, such as biodegradability, reproducibility, and stability. Based on this context, the objective of this work was to evaluate different methods for concentration and characterisation of extracellular biopolymers produced by Phoma sp. Extracellular biopolymers were produced by submerged fermentation and were concentrated by hollow fibre membranes and by adsorption. The structural characterisation of purified biopolymers was determined by Fourier Transform Infrared spectroscopy. Phytotoxic effects were assessed through absorption assays in detached leaves of Cucumis sativus and evaluated on the seventh day after application. The surface tension was evaluated for each sample. Hollow-fibre microfiltration membrane presented a higher purification factor than hollow-fibre ultrafiltration membrane. Extracellular biopolymers were identified in the permeate and retentate fractions, but in higher concentration in the retentate fractions. The adsorption process was efficient for recovering more than 88% of extracellular biopolymers from cell-free fermented broth. The best performance was obtained by using silica and activated carbon as adsorbent, with a recovery higher than 93%. The herbicidal activity was proportional to the concentration of biopolymers and the results are very promising for future applications because a concentrated solution of biopolymers can increase weed control. Membrane processes can be used to develop a liquid formulation of bioherbicide, whereas adsorption can be used to develop a solid formula. [ABSTRACT FROM AUTHOR]

Fungal biopolymers have gained considerable attention from the scientific community for various applications due to their biological and physicochemical properties. The wide applications in several areas, especially in the food industry as a bioemulsifier and in the agricultural area as a biosurfactant, have expanded the knowledge on the production of fungal biopolymers to keep up with developments on this subject area. Recent scientific studies have disclosed novel routes, optimized parameters, increased yields, and other related approaches in order to produce and apply fungal bioemulsifiers and biosurfactants. However, there is a need to gather important information in order to provide a way forward. Therefore, this review presents an overview of properties, applications, and perspectives for encouraging further projects and investments in the near future by most categories of investors. The selection of culture media, the definition of cultivation parameters, extraction, recovery, and purification are the initial steps to indicate the conditions for scale-up. Indeed, scale-up is still one of the challenges in this biotechnological field, which could be solved by expanding the tests and operational productions in both pilot and industrial plants. [ABSTRACT FROM AUTHOR]

Exopolysaccharides are secondary metabolites produced by microorganisms and are a subject of research in many fields of science and industry due to some of their confirmed properties, especially in the pharmaceutical and agrochemical areas. In this context, the objectives of this work were to evaluate the potential of Fusarium fujikuroi for producing exopolysaccharides and to concentrate such compounds in order to increase the herbicidal activity. Exopolysaccharides were produced by submerged fermentation and different concentration methods (membranes, lyophilization, and evaporation) were evaluated. The phytotoxic effects were assessed through absorption assays in detached leaves of Cucumis sativus and evaluated on the seventh day after application. The surface tension was evaluated for each concentration method. The production of exopolysaccharides in the crude broth without concentration was 5.94 g/L. When using the lyophilization method, a maximum yield of exopolysaccharides of 10.64 g/L was obtained. The membranes also presented satisfactory results of exopolysaccharides: 9.60 g/L. The increase of bioherbicidal activity and the lower surface tension are proportionally related to the increase of the concentration of exopolysaccharides. [ABSTRACT FROM AUTHOR]

This study is focused on the concentration of fermented broth from Phoma sp. to increase its herbicidal activity. For this purpose, biomolecules produced by submerged fermentation using Phoma sp. were concentrated by hollow fiber microfiltration membranes. The membrane feed was separated into two streams (retentate and permeate) and the crude broth was concentrated to 10, 30, 50, 70 and 90% (relative to the initial volume). The retentate samples were submitted to bioassays (triplicate) for evaluating their phytotoxic effects on five young leaves of species of Cucumis sativus and also on pre-emergence of weeds as Bidens pilosa and Amaranthus retroflexus. The highest herbicidal activity was 80.7% obtained for a concentration of 30% in the retentate fraction. At this condition, the bioherbicide presented severe damage symptoms on the detached leaves of Cucumis sativus if compared to the crude fermented broth. In the pre-emergence of B. pilosa and A. retroflexus, 100% control was obtained for assays performed in a germination chamber. For greenhouse assays using the substrate, the control rate of A. retroflexus was dependent of concentration of bioherbicide. The promising results achieved in the research with membrane separation process allow us to propose and develop further studies for evaluating this technology in the concentration of other metabolites produced by fermentation which also have bioherbicidal activity. [ABSTRACT FROM AUTHOR]

This work was motivated by a real problem of comparing binary diagnostic tests based upon a gold standard, where the collected data showed that the large majority of classifications were incomplete and the feedback received from the medical doctors allowed us to consider the missingness as non-informative. Taking into account the degree of data incompleteness, we used a Bayesian approach via MCMC methods for drawing inferences of interest on accuracy measures. Its direct implementation by well-known software demonstrated serious problems of chain convergence. The difficulties were overcome by the proposal of a simple, efficient and easily adaptable data augmentation algorithm, performed through an ad hoc computer program. [ABSTRACT FROM AUTHOR]

Fungi are considered the most damaging microorganisms in agriculture. The indiscriminate use of chemical treatments in agricultural products causes the development of pest resistance and affects human health. An alternative to synthetic fungicides is the use of natural products such as plant extracts for the management of fungal diseases in plants. Extracts from different parts of Lupinus albescens (roots, stalks, leaves, and flowers) were obtained by extraction using supercritical carbon dioxide (CO2) or compressed liquefied petroleum gas (LPG). Thereafter, the antioxidant activity of each extract was measured, and the antifungal activity in vitro of extracts was evaluated against Fusarium oxysporum and Fusarium verticillioides. For a concentration of 5000 mg/L, the half maximal inhibitory concentration (IC50) ranged from 29.25 μg/mL to 192.96 μg/mL. Antifungal tests showed that all matrices presented inhibitory effect against both fungi tested. The extracts obtained from roots by CO2 and LPG presented 70.1% and 65.1% inhibition against F. oxysporum, and 67.8% and 61.2% inhibition against F. verticillioides, respectively. These results suggest that the extracts obtained from L. albescens by extractions using supercritical CO2 and compressed LPG might be a potential source of antioxidants and natural fungicides. [ABSTRACT FROM AUTHOR]

The separation ofJatropha curcasoil from azeotropes of ethyl alcohol–n-hexane and isopropyl alcohol–n-hexane using ceramic membranes with different cutoffs (5, 10 and 20 kDa) is presented. The mass ratios of oil:azeotropes (O:S) studied were 1:3 for feeding pressures of 0.1, 0.2 and 0.3 MPa, and 1:1 for the feeding pressure of 0.1 MPa. Isopropyl alcohol was the best solvent for the membranes conditioning to permeaten-hexane (240 kg/m2 h). In the separation ofJ. curcasoil and azeotropes of solvents, both membranes showed oil retention and total flux decreases with time. Overall, the lowest decrease in the retentions was reached in the 5 kDa membrane, while the lowest decrease in the total flux was reached in the 20 kDa. In the separation of oil and ethyl alcohol–n-hexane azeotrope, the best retention at 60 min of the process was equal to 17.3 wt% in the 20 kDa membrane at 0.3 MPa and O:S ratio equalled to 1:3. In this condition, the total permeate flux was 17.5 kg/m2 h. Different retentions and permeabilities are provided when changing the O:S ratio, the feeding pressure and the molecular weight cutoff of membranes. [ABSTRACT FROM PUBLISHER]

This work focuses on the immobilization of a crude inulinase extract obtained by solid-state fermentation using spray-drying technology. Maltodextrin and arabic gum were used as immobilizing agents. The effects of inlet air temperature, maltodextrin/arabic gum ratio and mass fraction of crude enzyme extract on the activity of immobilized inulinase were assessed using a central composite rotatable design (CCRD) (23). The optimum operational conditions for the immobilization of inulinase by spray-drying was obtained at an inlet air temperature of 200°C, mass fraction of crude enzyme extract of 0.5 wt% and using only arabic gum as immobilizing agent. The immobilized enzyme had good thermostability, comparable with other inulinases obtained from different microorganisms. The method used gave good enzyme activity after immobilization and could be applied to other enzymes which have good thermal stability. [ABSTRACT FROM AUTHOR]

There has been some interest in survival models with additive hazard function (e.g., the Aalen's linear model), which is considered an alternative or supplementary model to the most common Cox model in analysis of censored data. One advantage of the Aalen's model is to allow the influence of each covariate to vary separately over time. In this article, an additive survival model, based on counting processes, is presented introducing additive frailties into the intensity in order to account for the heterogeneity of the data due to unobserved risk factors or dependence among individuals in study. The additive frailty model is analyzed under a Bayesian point of view and illustrated by two well-known data sets. [ABSTRACT FROM AUTHOR]

Abstract.The choice of the censoring mechanism is very important when we are analyzing survival data because, in some practical situations, there is a dependence between the failure and censoring times, contradicting the assumption of non informative censoring. The present article proposes a censored-data regression in the presence of informative censoring based on the generalized odd log-logistic family of distributions under two systematic components. The proposed model is based on the assumption that failure and censoring times are conditionally independent given a frailty. The choice of the widespread odd log-logistic family for failure and censoring times is justified by the fact that it generalizes some distributions already consolidated in the area of survival and, concomitantly, by the fact that it offers great flexibility in data modeling in practice, in addition to the capacity to present various forms of the risk function, among them, bimodal. The maximum likelihood method is used to estimate the model parameters. For different parameter configurations and sample sizes, some simulations are performed to analyze the behavior of the maximum likelihood estimates. Two real data applications illustrate the usefulness of the proposed survival regression with informative censoring. [ABSTRACT FROM AUTHOR]