Search

This study sought to appraise 7-year and 9-year-old Cedrela odorata for pulp and paper making. Sectioning and maceration processes were adopted. Data were subjected to statistical analysis using SPSS version 17.00. Cell characteristics for all ages and tree positions appeared similar but quantitatively, cells in 9-year-old generally exhibited some significant (p < .05) variations. Age and wood position generally had some significant influence on cell characteristics. Fibre lengths were generally short (<1.6 mm or 1600 µm) with variations in fibre morphology being significant axially than radially. In appraising the wood for paper production, derived fibre indices/values viz; Runkel ratio (ranging from 0.19 to 0.28), flexibility coefficient (ranging from 0.78 to 0.83), and slenderness ratio (ranging from 38.98 to 51.72) appeared to provide some positive indications. The species therefore, has potential for pulp and paper production, but further studies on its chemical consumption levels and other properties need to be ascertained towards a well-informed decision. [ABSTRACT FROM AUTHOR]

Aging behavior occurs in the storage process of paper archives, which accelerates the aging process of the paper. Therefore, it is important for paper archives management to explore the aging behavior of acidified paper (AP) and to delay or prevent its further aging. The aging behavior of the commonly used university archives paper with artificial acidification were studied by measuring pH value, electrical conductivity, mechanical properties and whiteness. The results show that the pH value, conductivity, mechanical properties and whiteness of AP change significantly compared with the non-acidified raw paper (P). After dry-heat aging treatment, the pH value of AP decreased more obviously than P, which shows more obvious aging degradation and further acidification of AP. During the aging process of AP, the molecular and structural degradation are promoted by the presence of acidic substances, which increase the electrical conductivity of the system. The microstructures of the paper are changed by acidification and aging treatment, and more fiber fracture, etching and microscopic holes are found in the surface SEM images. The reductions of the tensile index and whiteness of AP are also more significant because of the degradation acceleration of the acid. [ABSTRACT FROM AUTHOR]

As an important substrate of traditional Chinese cultural relics in museums, paper is the material with highly light sensitivity, which is susceptible to irreversible lighting damage. To provide high-quality viewing, it is vital to study the parameters of light sources in consideration of paper substrates' long-term conservation. As an important factor affecting both conservation and viewing, there are some issues concerning correlated color temperature (CCT) in the relevant standards, namely, the inconsistent recommended values. In this research, paper samples were subjected to accelerated irradiation experiments for 1440 h by 10 narrow-band lights in the visible range, and the infrared spectra were measured periodically. The calculated oxidation index was used to obtain the damage response function to different spectral wavelengths and exposures. Subsequently, using the method of exhaustion, 9477 spectra with a CCT range of 2650–4150 K that met the viewing requirements were screened, and lighting damage to paper substrates was calculated using this function. Based on that, the correlation between CCT and lighting damage to paper substrates and their standard deviations was obtained. Combining the previous research on recommended for CCT pigments, a preliminary recommended CCT of 3100–3200 K in selecting light sources for traditional Chinese paper relics was proposed. It is worth emphasizing that it is still necessary to use the spectral power distribution of light sources, as the underlying independent variable that leads to damage, to further calculate the lighting damage using the function mentioned above to achieve protective lighting. [ABSTRACT FROM AUTHOR]

Transforming Pulp and Paper (P&P) mills into Integrated Forest Biorefineries (IFBR) is a prominent solution to save Canadian P&P industry that has been facing decline of conventional paper demand. We propose a comprehensive decision model for the design of IFBR value chains by taking the uncertain demand of bioproducts into consideration. In particular, we propose a multi-stage stochastic programming model to obtain the optimal investment plan over a long-term planning horizon in the presence of various market trends. We also develop a Monte-Carlo simulation platform to validate the proposed model and to compare its performance with alternative decision models. The model is applied to a realistic case study inspired from P&P companies in Canada, where the value of incorporating the dynamic nature of uncertain demand has been estimated. Further, we elaborate on the value of considering flexibility in terms of adjusting the investment plan in response to changes in the demand. Our results indicate that the demand for bioproducts has a substantial impact on the profitability of the IFBR. We also demonstrated the significant value of explicitly incorporating the uncertainty in IFBR network design as well as adapting the investment plan to the changes in the demand. [ABSTRACT FROM AUTHOR]

Copyright of Journal of Natural Fibers is the property of Taylor & Francis Ltd and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

Conventional multi-cylinder drying of paper and board involves a mixture of conductive drying from steam-heated dryer cylinders and convective drying by the flow of heated air over the surface of the paper web in the pockets. Pocket ventilation is a critical component in assisting heat and mass transfer during the drying process but is the primary contributor toward removing evaporated water from the web. Air temperature, velocity, and humidity are critical parameters involved in the convective drying process. This paper covers an experimental study involving the design and development of a small lab-scale setup for convective drying of various grades of paper and board, monitoring multiple parameters like paper temperature, moisture content, air humidity, temperature, and velocity measured in situ as the drying proceeds with continuous and accurate sampling capabilities for all parameters in the sample and the system. Instantaneous drying rates, heat, and mass transfer coefficients were also deduced for every time step till the paper completely dried. Furthermore, the coefficients obtained were also reported in the form of dimensionless correlations, and the results were compared against traditional correlations used in the modeling of paper drying. This data will be useful in process development, modeling, design, and the paper drying process simulation. [ABSTRACT FROM AUTHOR]

Medication prescription procedures were reviewed at psychiatric residential treatment centers (RTC), and a quality improvement project was conducted in order to implement integrated electronic medical records (EMR) and computerized provider order entry (CPOE). To assess the impact of preexisting prescribing practices on RTCs, surveys were sent anonymously to current and past providers of regional and local RTCs. The surveys assessed the impact of the prescribing protocol on workflow, the frequency of medication errors, the impact such errors had on patient care, the overall provider satisfaction, and the discrepancies between electronic and paper charts. Current providers were then re-surveyed after implementing the integrated CPOE system in May 2020, during the COVID-19 pandemic. The first round of provider survey results revealed that the majority of staff (n = 10, 70%) observed frequent medication errors and were largely dissatisfied with the current medication ordering and administration process (n = 10; 70%). Incident Response Improvement System (IRIS) reports revealed the most common medication errors were omissions, incorrect dosing, and incorrect medications administered. After the initiation and implementation of the CPOE, staff satisfaction increased with the process (n = 14; 50%) noting that medication errors were less frequent than before (n = 14; 50%). [ABSTRACT FROM AUTHOR]

Cellulose nanofibrils (CNF) can be modified to be used as a coating on food paper packaging. Previous research on PVA/CNF composites showed a low viscosity, which impacted their performance on the coating paper process. To overcome this problem, a thickening agent, such as carboxymethyl cellulose (CMC), is needed. In this work, the effect of CMC on PVA/CMC/CNF nanocomposites was investigated by varying the concentrations of CMC with PVA/CMC and CNF ratio of 80:20 and 90:10. The nanocomposites were characterized by their physical and tensile properties which could affect their coating performance. Moreover, the coating process was conducted on paper and the performances of the coated paper were studied. The results showed that the increase in CMC concentration led to an increasing viscosity and good zeta potential, suggesting good dispersion. Moreover, the addition of CMC improved the tensile properties of PVA/CMC/CNF nanocomposites. However, SEM analysis of PVA/CMC-1:CNF (80:20) revealed the occurrence of agglomeration which might influence the performance of the coated paper. Interestingly, PVA/CMC-1:CNF (80:20) had an excellent water resistance, with the lowest Cobb60. Moreover, the addition of CMC 1 wt% increased WVTR, which remained lower than the blank sample. Meanwhile, PVA/CMC-2:CNF (80:20) demonstrated the best performance in the oil absorption and tearing resistance test. In summary, the addition of CMC can effectively improve the physical and tensile properties of the PVA/CMC/CNF, as well as the barrier properties and tear strength of the PVA/CMC/CNF coated paper. The results demonstrate the potency of this material as a coating for food packaging paper. [ABSTRACT FROM AUTHOR]

Predictive maintenance strategies are becoming increasingly more important with the increased needs for automation and digitalization within pulp and paper manufacturing sector. Hence, this study contributes to examine the most efficient pre-processing approaches for predicting sensory data trends based on Gated Recurrent Unit (GRU) neural networks. To validate the model, the data from two paper pulp presses with several pre-processing methods are utilized for predicting the units' conditions. The results of validation criteria show that pre-processing data using a LOWESS in combination with the Elimination of discrepant data filter achieves more stable results, the prediction error decreases, and the predicted values are easier to interpret. The model can anticipate future values with MAPE, RMSE and MAE of 1.2, 0.27 and 0.30 respectively. The errors are below the significance level. Moreover, it is identified that the best hyperparameters found for each paper pulp press must be different. [ABSTRACT FROM AUTHOR]

The Journal of Critical Realism has issued a call for papers for a special issue on "critical realism and the self." The concept of the self is seen as crucial for social change and emancipatory theorizing. The special issue aims to explore various aspects of the self, including subjectivity, reflexivity, authenticity, personhood, and identity. Submissions can be theoretical or applied, and can engage with critical realism or critique it. The deadline for submissions is May 31, 2024, and the final papers are required by November 19, 2024. [Extracted from the article]