Search

Abstract The recent multi-analytical study carried out on the Van Eyck’s Ghent Altarpiece showed the simultaneous presence of several kinds of metal carboxylates in oil-rich glaze layers. This outcome raised the question whether these carboxylates had already formed during the preparation of the oil binder by the artists. In the case of early-stage formation, they may have had an impact on the drying rate of the resulting oil, as well as on its handling properties. This hypothesis was investigated using a model system of in-house-prepared linseed oil containing incremental concentrations (2–5–10 wt.%) of relevant metal carboxylates (i.e. Ca-, Zn-, Cu-, and Pb oleates and stearates). This paper describes the influence of these type of molecules on the drying rate of linseed oil and, to an extent, on its viscosity. The drying time of the linseed oil, to which one or more metal carboxylates were added, was measured with a drying recorder while the viscosity was assessed with a rheometer. When introduced together, some of these metal carboxylates act in synergy to shorten the drying time with respect to the situation when the same metal carboxylates were added separately to linseed oil. Mixtures of Ca- and Zn-oleates proved to have a larger effect than other binary combinations. Addition of two metal oleates (combination of Ca/Zn/Cu/Pb) reduced the drying time even more. On the other hand, specific combinations of three metal stearates and/or oleates also demonstrated a significant synergistic effect towards increasing the viscosity of the binder. Especially combinations of Ca/Zn/Cu and Ca/Zn/Pb stearates and oleates gave rise to the highest level of linseed oil viscosity increase, when compared to the situation in which the same metal carboxylates were added separately.

Abstract Metal soaps, the organic salts resulting from the interaction of fatty acids and metal cations, arouse interest in the scientific field because of their versatility in a great range of chemical applications as well as because of the mechanism of their formation during degradation processes. This article presents a review of the synthetic pathways used to produce metal soaps, their relevant physico-chemical properties, and how these reflect in their applications. Common industrial uses of metal soaps are reported, with a particular focus on those applications, such as cosmetics, paints, and coatings, that have an impact on the cultural heritage field. In addition, the occurrence of metal soaps in cultural heritage studies is presented, ranging from archaeological and ethnographic artefacts to fine art objects, and discussed per class of materials. An overview of the presence or absence of metal soaps in historical artefacts due to the interaction of metal parts or mineral pigments with fatty acids is given herein. This collection shows a variety of situations in which metal soaps—particularly lead, zinc and copper soaps—can form on composite objects made of different materials such as wood, leather and fatty-acid-containing materials (e.g., waxes), in the presence of metal, metal alloys or pigments.

Abstract This article presents an overview of Liu Kang’s (1911–2004) canvas painting supports from his early artistic phases, Paris (1929–1932) and Shanghai (1932–1937). The research was conducted on 55 artworks from the collections of the National Gallery Singapore and Liu family. The technical examination of the paintings was supplemented with archival photographs of the artist at work to elucidate his practice of preparation of painting supports. The analyses conducted with light microscopy, SEM–EDS, and FTIR allowed us to characterise the structure of the canvases and identify the natural fibres and formulation of the grounds. In addition, references to contemporary colourmen catalogues, in relation to certain materials, were made. The obtained results suggest that, in both locations, Liu Kang employed commercially prepared canvases purchased by the roll or by the metre, together with bare strainers or stretchers of standard sizes. In Paris, the artist commonly used linen canvases, while in Shanghai he preferred cotton canvases, with linen used sporadically. The identified grounds from the Paris and Shanghai canvases are white and single-layered, but their formulations vary significantly between the two locations. Hence, grounds composed predominantly of lead white with extenders and drying oil as a binder are considered as exclusive to the Paris phase. However, semi-absorbent or absorbent grounds based on chalk are typical for Shanghai phase. This research contributes to the knowledge of Liu Kang’s painting materials and working practices during the pre-war period in Paris and Shanghai.

Abstract During a routine condition survey in 2007 at the Georgia O’Keeffe Museum in Santa Fe, micro-protrusions were found scattered across the surfaces of the artist’s oil paintings produced between 1920 and 1950. In many of her works, including Pedernal (1941) and A Man from the Desert (1941), lead soaps were found aggregated at the painting surface, forcing the surrounding paint to deform into pin-sized protrusions. The structure and composition of the protrusions was analyzed to determine why they formed. Microsamples were removed from four of O’Keeffe’s paintings and investigated using a combination of SEM–EDX, GC–MS, and FT-IR. The combined GC–MS and FT-IR results indicate that the protrusions contain primarily lead carboxylates. The results obtained for a series of ground samples removed from four different paintings were then compared with samples collected from a commercially pre-primed canvas roll found in the artist’s house in Ghost Ranch, NM. We identified two different types of canvases: i) a commercially pre-primed canvas and ii) artist primed canvas. This commercially pre-primed canvas roll has a similar morphology to the ground layers in her paintings that contain protrusions additionally these grounds were found to contain an excess of free fatty acids and metal carboxylates (lead soaps) based on a comparison to canvases the artist primed herself. Based on the analytical results from the four paintings and the commercial pre-primed canvas, we concluded that the artist’s use of this particular commercially pre-primed canvas between 1920 and 1950 play an important role in the observed micro-protrusions.

Abstract Paintings and painted objects are quite susceptible to degradation, as paint layers are usually composed of complex mixtures of materials that can participate in chemical degradation processes. The identification of the constituent materials in paint (including binders, pigments, and fillers) and the degradation products within paint layers is of particular importance to ensuring the conservation of paintings, by providing important information both about their material history as well as their state of conservation. Metal fatty acid salts (metal soaps) are degradation products that can form in situ from interactions between inorganic pigments and free fatty acids in oil-based binding media, and can cause significant condition issues in paintings. Fourier transform infrared (FTIR) spectroscopy is one of the leading analytical techniques for the study of metal soaps. In this article, the materials analysis of several cross-sections from paintings and painted objects from works in Canadian collections is presented. Recent results on the use of external reflection FTIR (R-FTIR) spectroscopy to identify and map the distribution of paint components and metal soap degradation products is presented. In particular, zinc, lead, calcium, and copper fatty acid salts were all readily identified in paint cross-sections by R-FTIR spectroscopy, along with several pigments and the oil binding medium. The results shown here are among the first detailed examinations of these metal soaps in paint cross-sections using R-FTIR spectroscopy. The use of highly polished samples in which specular reflection is dominant allowed for spectral transformations to be applied to generate transmission/absorption-like spectra which facilitated identification of these species. The distribution of these species across the cross-sections was mapped by integrating characteristic absorption features in the R-FTIR spectra. Attenuated total internal reflection (ATR) FTIR spectroscopy was also performed on several samples, which provided additional compositional details at the interface of paint layers and degradation products.

Abstract Metal soaps and resinates are known to be spontaneously formed in artistic paintings, as a product of the reaction between aliphatic and terpenoid acids released by hydrolysis and oxidation of the organic media and certain cations contained in some inorganic pigments. In this paper we present an optimization and the validation of a GC/MS method for the qualitative and quantitative analysis of mixtures of terpenoid acids and aliphatic mono and dicarboxylic acids and metal carboxylates of terpenoid and aliphatic mono and dicarboxylic acids in the same paint microsample. This is based on a two-step analytical approach entailing the subsequent use of two silylating agents, N,O-bis(trimethylsilyl)trifluoroacetamide for the analysis of free acids and metal carboxylates, and 1,1,1,3,3,3-hexamethyldisilazane for the analysis of free acids. The application of this approach is possible because of the good stability at room temperature of the TMS derivatives of aliphatic and terpenoid species, characterized by high boiling points and relatively low vapour pressures. The method was then applied to the characterization of samples collected from two reference paint layers aged for 20 years, a paint sample taken from a pulpit, and sample of the varnish coating of a wooden writing desk, both from the second half of the seventeenth century.