Search

Diesel emissions contain high levels of particulate matter (PM) which can have a severe effect on the airways. Diesel PM can be effectively reduced with the substitution of diesel fuel with a biofuel such as vegetable oil. Unfortunately, very little is known about the cellular effects of these alternative diesel emissions on the airways. The aim of this study was to test whether coconut oil substitution in diesel fuel reduces the adverse effect of diesel emission exposure on human bronchial epithelial cells. Human bronchial epithelial cells were cultured at air-liquid interface for 7 days and exposed to diesel engine emissions from conventional diesel fuel or diesel fuel blended with raw coconut oil at low (10%), moderate (15%) and high (20%) proportions. Cell viability, inflammation, antioxidant production and xenobiotic metabolism were measured. Compared to conventional diesel, low fractional coconut oil substitution (10% and 15%) reduced inflammation and increased antioxidant expression, whereas higher fractional coconut oil (20%) reduced cell viability and increased inflammation. Therefore, cellular responses after exposure to alternative diesel emission are dependent on fuel composition.

Volatile organic compounds (VOCs) in the headspace of bubble chambers containing branches of live coral in filtered reef seawater were analysed using gas chromatography with mass spectrometry (GC-MS). When the coral released mucus it was a source of dimethyl sulfide (DMS) and isoprene; however, these VOCs were not emitted to the chamber headspace from mucus-free coral. This finding, which suggests that coral is an intermittent source of DMS and isoprene, was supported by the observation of occasional large pulses of atmospheric DMS (DMSa) over Heron Island reef on the southern Great Barrier Reef (GBR), Australia, in the austral winter. The highest DMSa pulse (320 ppt) was three orders of magnitude less than the DMS mixing ratio (460 ppb) measured in the headspace of a dynamically purged bubble chamber containing a mucus-coated branch of Acropora aspera indicating that coral reefs can be strong point sources of DMSa. Static headspace GC-MS analysis of coral fragments identified mainly DMS and seven other minor reduced sulfur compounds including dimethyl disulfide, methyl mercaptan, and carbon disulfide, while coral reef seawater was an indicated source of methylene chloride, acetone, and methyl ethyl ketone. The VOCs emitted by coral and reef seawater are capable of producing new atmospheric particles < 15 nm diameter as observed at Heron Island reef. DMS and isoprene are known to play a role in low-level cloud formation, so aerosol precursors such as these could influence regional climate through a sea surface temperature regulation mechanism hypothesized to operate over the GBR.

The disposal of waste rubber and scrap tyres is a significant issue globally; disposal into stockpiles and landfill poses a serious threat to the environment, in addition to creating ecological problems. Fuel production from tyre waste could form part of the solution to this global issue. Therefore, this paper studies the potential of fuels derived from waste tyres as alternatives to diesel. Production methods and the influence of reactor operating parameters (such as reactor temperature and catalyst type) on oil yield are outlined. These have a major effect on the performance and emission characteristics of diesel engines when using tyre derived fuels. In general, tyre derived fuels increase the brake specific fuel consumption and decrease the brake thermal efficiency. The majority of studies indicate that NOx emissions increase with waste tyre derived fuels; however, a few studies have reported the opposite trend. A similar increasing trend has been observed for CO and CO2 emissions. Although most studies reported an increase in HC emission owing to lower cetane number and higher density, some studies have reported reduced HC emissions. It has been found that the higher aromatic content in such fuels can lead to increased particulate matter emissions.

The effect of non-thermal plasma technology for particulate matter removal and nitrogen oxide emission reduction from diesel exhaust has been investigated. A sample of exhaust was cooled to the ambient temperature and passed through a dielectric barrier discharge reactor. This reactor was employed for producing plasma inside the diesel exhaust. A range of discharge powers by varying the applied voltage from 7.5 to 13.5 kV (peak–peak) at a frequency of 50 Hz has been evaluated during the experiments. Regarding the NOx emission concentration, the maximum removal efficiency has been achieved at energy density of 27 J/L. Soot, soluble organic fraction and sulphate components of diesel particulate matter have been analysed separately, and the consequence of plasma exposure on particle size distribution on both the nucleation and accumulation modes has been studied. Plasma was found to be very effective for soot removal, and it could approach complete removal efficiency for accumulation mode particles. However, when applied voltage approached 12 kV, the total number of nucleation mode particles increased by a factor of 50 times higher than the total particle numbers at the reactor inlet. This increase in nucleation mode particles increased even more when applied voltage was set at 13.5 kV.

Photoacoustic properties of amorphous Fe81B13Si4C2 ribbons were investigated. The amplitude and phase photoacoustic spectra were measured as a function of the modulation frequency of an He–Ne laser beam. Thermal diffusivity was determined by comparison of obtained experimental results and calculated theoretical photoacoustic spectra for a non-annealed Fe81B13Si4C2 sample and an Fe81B13Si4C2 sample annealed at 600 °C. © 1998 Chapman & Hall