Search

Catalytic hydrotreatment is a promising technology to convert pyrolysis liquids into intermediates with improved properties. Here, we report a catalyst screening study on the catalytic hydrotreatment of pyrolysis liquids using bi- and tri-metallic nickel-based catalysts in a batch autoclave (initial hydrogen pressure of 140 bar, 350 °C, 4 h). The catalysts are characterized by a high nickel metal loading (41 to 57 wt%), promoted by Cu, Pd, Mo, and/or combination thereof, in a SiO2, SiO2-ZrO2, or SiO2-Al2O3 matrix. The hydrotreatment results were compared with a benchmark Ru/C catalyst. The results revealed that the monometallic Ni catalyst is the least active and that particularly the use of Mo as the promoter is favored when considering activity and product properties. For Mo promotion, a product oil with improved properties viz. the highest H/C molar ratio and the lowest coking tendency was obtained. A drawback when using Mo as the promoter is the relatively high methane yield, which is close to that for Ru/C. 1H, 13C-NMR, heteronuclear single quantum coherence (HSQC), and two-dimensional gas chromatography (GC × GC) of the product oils reveal that representative component classes of the sugar fraction of pyrolysis liquids like carbonyl compounds (aldehydes and ketones and carbohydrates) are converted to a large extent. The pyrolytic lignin fraction is less reactive, though some degree of hydrocracking is observed.

High metal loading NiCu-based catalyst of Picula™ series produced by sol–gel technique was applied to furfural hydrogenation in the presence of hydrogen. This reaction represents the stabilization of pyrolysis oil that involves the selective reduction of aldehydes and ketones to alcohols and unsaturated C–C double bonds of pyrolysis oils components. The catalysts were pre-reduced at 250 and 300 °C. According to XRD analysis results, copper is mainly in the metallic state, and Ni is mostly in the form of oxide and silicate. XPS measurements reveal that hydrogen treatment at 250 °C leads to the partial reduction of Ni to the metallic state (6 %) while further reduction at 300 °C leads to an increase in this proportion up to 39 %. A 100 % selectivity towards furfuryl alcohol was achieved at 130 °C and 5 MPa of hydrogen in a batch reactor using decyl alcohol as a solvent. In the experiments with i-propanol as a solvent at 110–170 °C the main product was furfuryl alcohol, but minor components traced back were tetrahydrofurfuryl alcohol, 2-methylfuran and isopropyl furfuryl ether. The lower catalyst reduction temperature promotes the formation of isopropyl ester, while a higher reduction temperature favors further furfuryl alcohol hydrogenation.