Search

An innovative method for utilizing synthetic calcium fluoride (CaF2), recovered from fluoride-containing semiconductor wastewater, and waste sulfuric acid (H2SO4) to produce hydrofluoric acid (HF) was investigated. The research was set to study the low-temperature production of HF via reaction of synthetic CaF2 and waste H2SO4. The impact of four factors, including H2SO4 concentration, total volume (H2SO4 + H2O)/CaF2 ratio, drying temperature of synthetic CaF2, and reaction carried out under different temperature, on HF productivity was investigated in this study. HF yield increased with increasing H2SO4 concentration and total volume/CaF2 ratio under room temperature. Generally, reactions carried out under low-temperature (< 100 °C) had a positive impact on HF yield. The higher temperature led to an increase in absorbed-HF but a decrease in total-HF. The reaction of commercial CaF2 and 70% H2SO4 had a higher absorbed-HF yield of 61.7% than synthetic CaF2 and 70% waste H2SO4, which had a yield of 36%. This was due to the higher purity of the commercial CaF2 and fewer interference ions in H2SO4. HF productivity was lowered by CaSO4, which hindered the reaction of reactants and also the generation of fluorosulfuric acid. [ABSTRACT FROM AUTHOR]

In this study, the dielectric barrier discharge (DBD) induced by nonthermal plasma (NTP) technology was used for isopropanol (IPA) degradation. IPA, intermediate, final product, and ozone concentrations were analyzed using GC-MS, carbon dioxide detector, and ozone detector. The experimental flow rate and concentration were fixed to 1 L/min and 1200 ppm ± 10%, respectively. Different reaction procedures were proposed for self-made metal catalyst combined with a plasma system (plasma alone and γ-Al2O3 combined with plasma, Cu (5 wt%)/γ-Al2O3 combined with plasma, Mn (3 wt%)-Cu (5 wt%)/γ-Al2O3 combined with plasma). In addition, the effect of the carrier gas oxygen content (0%, 20%, and 100%) on IPA conversion and intermediate and carbon dioxide selectivity was also investigated. The results revealed that the Mn (F)-Cu/γ-Al2O3 combined with plasma exhibited more efficient IPA conversion. In the 100% oxygen environment, the IPA conversion rate increased from 79.32 to 99.99%, and carbon dioxide selectivity increased from 3.82 to 50.23%. IPA was completely converted after 60 min of plasma treatment with the acetone selectivity, carbon dioxide selectivity, and tail ozone concentration of 26.71% ± 1.27%, 50.23% ± 0.56%, and 1761 ± 11 ppm, respectively. This study proved that the current single planar DBD configuration is an effective advanced treatment technology for the decomposition of VOCs. [ABSTRACT FROM AUTHOR]