Search

The aim of this study was to explore the correlations of detectability and the semi-quantification for hot spot imaging with positron emitters in positron emission tomography (PET) and with a positron coincidence detection system (PCD). Phantom study results for the measurement of the lesion-to-background (L/B) ratio ranged from 2.0 to 30.3, and detectability for hot spot lesion of PET and PCD were performed to correspond to clinical conditions. The detectability and semi-quantitative evaluation of hot spots from 4.4 mm to 36.9 mm in diameter were performed from the PET and PCD images. There were strong correlations between the L/B ratios derived from PET and PCD hot spot images and actual L/B ratios; but the L/B ratio derived from PET was higher than that from PCD with a significant difference of 10% to 54.8%. The detectability of hot spot imaging of PCD was lower than that of PET at 64.8% (PCD) versus 77.8% (PET). Even the actual L/B ratio was 8.0, hot spots more than 10.6 mm in diameter could be clearly identified with PCD imaging. The same identification could be achieved with PET imaging even when the actual L/B ratio was 4.0. This detailed investigation indicated that FDG PCD yielded results comparable to FDG PET on visual analysis and semi-quantitative analysis in detecting hot spots in phantoms, but semi-quantitative analysis of the L/B ratio with FDG PCD was inferior to that with FDG PET and the detectability of PCD in smaller hot spots was significantly poor. [ABSTRACT FROM AUTHOR]

The purpose of this study was to investigate the detectability of small hot lesions with the 3-dimensional transmission/emission (3D T/E) acquisition mode in FDG-PET scan. The correlation of target detectability, target size, target to non-target uptake ratio (T/N ratio) and standardized uptake value (SUV) were studied. Small hot lesions ranged from 4.4 mm to 36.9 mm in diameter were located in cylindrical phantom. The images of phantoms with a T/N ratio of 2.0, 4.0, 6.0, 8.0, 9.6, 13.2, 17.5, 23.8 and 30.3 were obtained with 2-dimensional transmission/emission (2D T/E) scan and 3D T/E scans. Targets in diameter more than 10.6 mm in diameter with an actual T/N ratio ranged from 6.0 to 30.3 could be identified on the images obtained with all the 2D T/E and 3D T/E acquisition modes. The detectability efficiency of small hot target in 2D T/E and 3D T/E scans was as same (77.8%). The T/N ratio of targets from 2D T/E images was 30% to 48.4% different to that from 3D T/E image, and the SUV of the target from the 2D T/E images was almost the same as that from 3D T/E images. This study revealed that 3D T/E scanning had similar hot spot detectability to 2D T/E scanning; 3D T/E and 2D T/E scanning had the same faculty for semiquantitative analysis using SUV. These findings may be helpful for the diagnosis and understanding of 3D T/E FDG-PET in hot lesion detection. [ABSTRACT FROM AUTHOR]

The performance of a high resolution positron emission tomography (PET) system SHR-2000 for animal studies was re-evaluated six years after its installation. The system employs a detector array consisting of BGO crystals that are 1.7 mm (transaxially) by 10 mm (axially) by 30 mm (deep). A block detector, which is a position-sensitive photomultiplier tube (PMT) coupled to 4 arrays of BGO crystals has been adopted to the system. There are 15 block detectors positioned to form a 35 cm diameter ring with a field of view (FOV) of 17 cm by 4.6 cm axially, giving the system a 7 slice imaging capability. For six year workload in spatial resolution (FWHM), there were approximately a 2.6% increase at tangential FOV and a 7.5% increase at radial FOV. In axial resolution (FWHM) there was almost no change. The count rate loss for the true count rate increased 1.3% at 200 kBq/ ml. The average slice sensitivity showed a decrease of approximately 4.1%, and in scatters it showed an increase of approximately 1.4%. In animal experiments, the bones of guinea pigs were clearly identified with 18F fluoride ion. These experiments show that after a six year workload, the system also maintains good performance and has good stability. [ABSTRACT FROM AUTHOR]