Search

A mathematical formulation is given of nonlinear axisymmetric buckling problems for plates and shells in the two-phase zones of austenite-to-martensite transformation. Numerical solutions of the direct-and inverse-transformation problems are used to construct hysteresis loops for thermomechanically cycled, pressure-loaded circular plates and shallow spherical domes of titanium nickelide (NiTi) alloy. It is shown that dynamic instability of the dome deformation process can occur during transformation under loads notably lower than the upper critical values for the isothermal states of the material outside the transformation zone. A theoretical analysis gives external loads below which the dome remains stable in the thermally cycled material with phase transformations. [ABSTRACT FROM AUTHOR]

The axisymmetric strain problem for a shell in the direct phase transformation interval is formulated approximately as a nonlinear boundary-value thermoelastic problem with an implicit temperature dependence (through a phase parameter simulating the volume fraction of the new-phase crystals). The buckling problems for a circular plate and a shallow spherical dome of TiNi alloy loaded by normal pressure in the direct phase transformation interval are solved numerically. The branches of buckled equilibrium states are obtained for various values of the loading and phase parameters. It is found that the deflections increase abruptly with an increase in the phase parameter for a fixed value of the loading parameter. The evolution of the buckling modes and the phase-strain distribution along the meridian are studied. [ABSTRACT FROM AUTHOR]

The problem of a rod and a plate subjected to plane strain in the interval of the direct phase transformation is formulated as a nonlinear boundary-value thermoelastic problem with an implicit dependence on temperature (through a phase parameter simulating the volume fraction of new-phase crystals). An analytical solution of the problem of a rod bent into a ring and a plate bent into a tube as a result of phase strains under the action of a small end bending moment is given. A numerical analysis of the buckling problem of a titanium nickelide (alloy) rod (plate) under longitudinal compression in the interval of the direct phase transformation shows that buckling becomes possible if the compressive load is much lower than the Euler critical load calculated before the transformation. Branches of buckled equilibrium states corresponding to loads lower than the Euler load are plotted as functions of the phase parameter. In all cases considered, the deflections increase abruptly in the neighborhood of the critical points. The evolution of buckling modes is studied, and the phase-strain distributions along the rod (plate) are shown. [ABSTRACT FROM AUTHOR]