Search

The development of a high-performance solid-lubricating composite with excellent self-lubricity over a broad temperature range in vacuum is significant to solve the frictional problems of spatial mechanisms. In this study, the vacuum tribological behaviors of nickel-matrix/Ag/(Ca, Ba)F2/graphite (0–2 wt%) composites were studied from 25 to 800 °C. The results show that the synergistic effects of solid lubricants can significantly improve the tribological properties of the composites in vacuum, with the graphite content contributing considerably. For 2 wt% graphite, a low friction coefficient (0.14–0.25) and the lowest wear rate ((0.12−4.78)×10−5 mm3·N−1·m−1) were observed in vacuum over the entire testing temperature range. Moreover, the wear mechanisms were clarified via analysis of the chemical composition and morphologies of the sliding surfaces. [ABSTRACT FROM AUTHOR]

In this paper, we reported the tribological behavior of TiAlC disk sliding against SiC ball from room temperature (RT) to 1,000 °C. The tribological properties are highly dependent of testing temperature. At RT, the coefficient of friction (CoF) is as low as 0.34 in the steady state, but the wear rate is relative high (4.26 × 10 mm/Nm). At 200 and 400 °C, the CoF is as high as 1.21, and the wear rates are very high, about on the order of 10 mm/Nm. From 600 to 1,000 °C, however, TiAlC exhibits quite low wear rate on the order of 10 mm/Nm and relative moderate CoF, 0.60-0.80. The compacted continuous oxide layer at 600 °C and above might be responsible for the outstanding wear resistance. [ABSTRACT FROM AUTHOR]

It is a challenge to design self-lubricating materials that exhibit and maintain reduced friction coefficient as well as high strength over a wide range of temperatures. A high-temperature self-lubricating nickel-alloy-based composite was created using the hot pressing technique. The composite exhibited high relative density, and simultaneously superior lubricating properties, average friction coefficient below 0.25 from room temperature to 800 °C, and high strength, 470 MPa of tensile strength and 1500 MPa of compressive strength. The composite was very promising in high-temperature tribology. [ABSTRACT FROM AUTHOR]