Search

Simple, low-cost and portable microfluidic paper-based analytical devices (μPADs) for determination of creatinine in urine samples were developed. The methodology was based on Jaffé reaction between the creatinine and picric acid in alkaline conditions, generating a colorimetric creatinine-alkaline picrate complex. The product exhibits an orange color that is clearly visible on the μPADs. The color intensity of the complex, which is indicative of the concentration of creatinine, is then quantitatively determined using ImageJ software. Various experimental parameters were optimized to achieve the best performance of the μPADs. Under the optimum conditions, a wide linear range was obtained in the range of 0.2 - 1 mM with a limit of detection and limit of quantitation of 0.08 and 0.26 mM, respectively. The accuracy of the proposed method was in good agreement with the standard Jaffé method. Finally, the developed devices were successfully applied for the determination of creatinine in urine samples.

Lung cancer is one of the most of cancer type founds and a leading cause of death worldwide. Through the development of new candidate compound (3,4,5-tribenzyloxybenzoic acid (GAOBn)) and a drug delivery system of our design of quaternized chitosan-gallic acid-folic acid stabilized gold nanoparticles (Au@QCS-GA-FA) as the targeted nanocarrier for treatment of lung cancer, we have found that GAOBn not only showed high cytotoxicity against lung cancer cells (CHAGO) with more than tenfold than cisplatin, but also showed low toxicity against normal cells (CRL-1947). The combination Au@QCS-GA-FA/GAOBn showed highly efficient cellular uptake and localization of gold nanoparticles via the active targeting of cancer cells. This established the potential of Au@QCS-GA-FA as a nanocarrier for anticancer agent-targeted delivery for treatment of lung cancer.

This work presents a new colorimetric method that is simple, rapid and cost effective for the determination of arsenic(III) in water samples. The method is based on changes in the absorbance of difluoroboron-curcumin (BF2-curcumin), prepared by the reaction of borontrifluoride diethyletherate ((C2H5)2OBF3) and curcumin. The BF2-curcumin was dissolved in 60% ethanol, which yielded an orange solution with the maximum absorbance at 509 nm. Upon the addition of arsenic(III), the color of the BF2-curcumin solution changed from orange to blue and the absorbance was measured by UV-visible spectrometry at 632 nm. The BF2-curcumin was applicable in both solution and coated resin. Under the optimal conditions, the detection limits achieved by means of UV-visible spectrometry, naked-eye detection with BF2-curcumin solution and naked-eye detection with BF2-curcumin-coated resin were found to be 0.26, 25 and 30 μM, respectively.

Sustained release mucoadhesive amoxicillin tablets with tolerance to acid degradation in the stomach were studied. The sustained-release tablets of amoxicillin were prepared from amoxicillin coated with ethyl cellulose (EC) and then formulated into tablets using chitosan (CS) or a mixture of CS and beta-cyclodextrin (CD) as the retard polymer. The effects of various (w/w) ratios of EC/amoxicillin, the particle sized of EC coated amoxicillin and the different (w/w) ratios of CS/CD for the retard polymer, on the amoxicillin release profile were investigated. The physicochemical properties of the EC coated amoxicillin particles and tablets were determined by scanning electron microscopy, Fourier-transform infrared spectroscopy, X-ray diffraction, and differential scanning calorimetry. The result showed that the release profiles of amoxicillin were greatly improved upon coating with EC, while the inclusion of CD to the CS retardant additionally prolonged the release of the drug slightly. Overall, a sustained release of amoxicillin was achieved using amoxicillin coated with EC at a (w/w) ratio of 1:1 and a particle size of 75-100 μm. Therefore, the tablet formulation of amoxicillin may be an advantageous alternative as an orally administered sustained-release formulation for the treatment of peptic ulcers., (© 2010 American Association of Pharmaceutical Scientists)

This study reports on the preparation of chitosan (CS)/polyethylene glycol (PEG) hydrogel beads using sodium diclofenac (DFNa) as a model drug. Following the optimization of the polymer to drug ratio, the chitosan beads were modified by ionic crosslinking with sodium tripolyphosphate (TPP). The CS/PEG/DFNa beads obtained from a (w/w/w) ratio of 1/0.5/0.5 with crosslinking in 10% (w/v) TPP at pH 6.0 for 30 min yielded excellent DFNa encapsulation levels with over 90% loading efficiency. The dissolution profile of DFNa from CS/PEG/DFNa beads demonstrated that this formulation was able to maintain a prolonged drug release for approximately 8 h. Among the formulations tested, the CS/PEG/DFNa (1/0.5/1 (w/w/w)) beads crosslinked with a combination of TPP (10% (w/v) for 30 min) and glutaraldehyde (GD) (5% (w/v)) were able to provide minimal DFNa release in the gastric and duodenal simulated fluids (pH 1.2 and 6.8, respectively) allowing for a principally gradual drug release over 24 h in the intestinal (jejunum and ileum) simulated fluid (pH 7.4). Thus, overall the CS/PEG beads crosslinked with TPP and GD look to be a promising and novel alternative gastrointestinal drug release system.

Ethyl cellulose microcapsules were developed for use as a drug-delivery device for protecting folic acid from release and degradation in the undesirable environmental conditions of the stomach, whilst allowing its release in the intestinal tract to make it available for absorption. The controlled release folic acid-loaded ethyl cellulose microcapsules were prepared by oil-in-oil emulsion solvent evaporation using a mixed solvent system, consisting of a 9:1 (v/v) ratio of acetone:methanol and light liquid paraffin as the dispersed and continuous phase. Span 80 was used as the surfactant to stabilize the emulsion. Scanning electron microscopy revealed that the microcapsules had a spherical shape. However, the particulate properties and in vitro release profile depended on the concentrations of the ethyl cellulose, Span 80 emulsifier, sucrose (pore inducer), and folic acid. The average diameter of the microcapsules increased from 300 to 448 microm, whilst the folic acid release rate decreased from 52% to 40%, as the ethyl cellulose concentration was increased from 2.5% to 7.5% (w/v). Increasing the Span 80 concentration from 1% to 4% (v/v) decreased the average diameter of microcapsules from 300 to 141 microm and increased the folic acid release rate from 52% to 79%. The addition of 2.5-7.5% (w/v) of sucrose improved the folic acid release from the microcapsules. The entrapment efficiency was improved from 64% to 88% when the initial folic acid concentration was increased from 1 to 3 mg/ml.

The polyelectrolyte complex (PEC) hydrogel beads based on chitosan (CS) and carrageenan (CR) have been studied as a controlled release device to deliver sodium diclofenac (DFNa) in the simulated gastrointestinal condition. Various factors potentially influencing the drug release (ie, CS/CR proportion, DFNa content, types and amount of cross-linking agents) were also investigated. The optimal formulation was obtained with CS/CR proportion of 2/1 and 5% (wt/vol) DFNa. The controlled release of the drug from this formulation was superior to other formulations and was able to maintain the release for approximately 8 hours. Upon cross-linking with glutaric acid and glutaraldehyde, the resulting beads were found to be more efficient for prolonged drug release than their non-cross-linking counterparts. The bead cross-linked with glutaraldehyde was able to control the release of the drug over 24 hours. The difference in the drug release behavior can be attributed to the differences in ionic interaction between the oppositely charged ions and to the concentrations of the drug within the beads, which depends on the compositions of the formulation and the pH of the dissolution medium. The release of drug was controlled by the mechanism of the dissolution of DFNa in the dissolution medium and the diffusion of DFNa through the hydrogel beads.