Search

An ultrasound extraction procedure for Ca, K and Mg from in vitro plant cultures is proposed, comparing cultures of different embryogenic levels of Citrus sinensis and Citrus limonia, employing ultrasound energy. Parameters related to metals extraction, such as plant material sampling, acid concentration and sonication time were investigated. For accuracy check, the proposed ultrasound extraction procedure was compared with a microwave-assisted digestion procedure and no differences in the results were verified at 95% of the confidence level. With this simple and accurate extraction procedure, it was possible to determine differences in Ca, K and Mg concentrations during Citrus embryo formation/development and between cultures (embryogenic and non-embryogenic). Finally, the ultrasound extraction method demonstrated to be an excellent alternative for handless sampling and operational costs.

Vermicompost (humic material) samples were submitted to characterization by infrared spectroscopy, X-ray diffractometry, thermogravimetric analysis, electron microscopy etc. In addition, its cation exchange capacity (CEC) was determined. Factorial experiments were designed in order to elucidate the interaction mechanisms between Cd2+ and the adsorptive sites of vermicompost. The maximum adsorptive capacity for cadmium was evaluated by a Langmuir isotherm. The characterization revealed that vermicompost exhibits high CEC values (ca. 72.9 meq per 100 g), high surface area (porous material), chelating groups and a maximum adsorptive capacity for Cd (38.6 mg g-1) at pH 5.0. This potential application was exploited in the analysis of synthetic and real (mineral water) samples with Cd concentrations of ca 5 mug L-1, requiring a preconcentration step. An enrichment factor of 100 was attained.

This work describes a factorial design for the optimization of pyrolysis and atomization temperatures in ETAAS. As examples, Cd and Pb were determined using lower pyrolysis and atomization temperatures and Al and Mo with higher pyrolysis and atomization temperatures. Good results were obtained for Cd employing Rh (m o = 1.4 pg) as a permanent modifier with pyrolysis and atomization temperatures of 640 and 1500 °C, respectively. For Zr, W or Zr+W, the Cd pyrolysis and atomization temperatures were 500 and 1500 °C, respectively, with m o = 1.4 pg using Zr or W and 1.5 pg using Zr+W. The best results for Pb were those using Rh, Zr, W and Zr+Rh, obtaining characteristic masses of 42, 37, 34 and 36 pg, respectively. Pyrolysis and atomization temperatures of 910 and 1850 °C, respectively, were achieved for this metal. For Al, the best results were obtained when Zr or Zr+W were used. Mo was also tested as a possible permanent modifier for Al, but the results were not satisfactory. The results obtained for Mo without modifier were similar to those with conventional modifiers (Mg or Pd+Mg) and the results obtained using permanent chemical modifiers were not satisfactory. In all situations, the experiments were performed faster than those using the univariate procedure.

Optimisation conditions for obtaining maximum cavitation intensity in ultrasonic baths are proposed using a simple and fast method. Parameters such as water volume, temperature, detergent concentration, horizontal and vertical positions, number of tubes in the bath, sonication time and bath water substitution were studied. The results obtained for both baths studied (Neytech and Cole-Parmer) lead to the following conditions for maximum cavitation intensity: 1 L of water at room temperature, 0.2 % (v/v) of detergent, central position on the bottom of the tank. Only one tube at a time should be used inside the bath during the ultrasound application. The cavitation intensity was linear with the sonication time up to 10 minutes and the water substitution during the sonication improved reproducibility. This system using continuous water change makes possible the sonication of 6 consecutive samples, without changes in the water volume.

An experimental procedure for direct sediment analysis was developed. Using this procedure, copper, zinc and lead were determined and quantitative recoveries for these metals were accomplished at a low cost and with minimal sample manipulation. The influence of the nitric acid concentration on the slurry preparation, as well as the sediment particle size was investigated. Sediment slurries were treated with 6.0 mol L-1 nitric acid and 2% (m/v) ammonium chloride, and sonicated for 15 minutes in an ultrasonic bath before quantification by flame atomic absorption spectrometry. Using these conditions for a certified reference material, the percentage of recovery for copper, zinc and lead were 96.4 ± 4.9, 97.0 ± 4.0 and 99.7 ± 4.0, respectively.

Two new flavones, 5 -hydroxy -7,5' -dimethoxy -3',4' -methylenedioxyflavone and 5 -hydroxy -7,3',5' -trimethoxy -4' -(3,3 -dimethylallyloxy) flavone, as well as three known flavones: 5,6,7,3',4',5' -hexamethoxyflavone, 5 -hydroxy -8,3',4' -trimethoxy -2'',2'' -dimethylpyrano (5",6":6,7) -flavone and 5 -hydroxy -8,3',4',5' -tetramethoxy -2'',2'' -dimethylpyrano (5",6":6,7) -flavone were isolated from the leaves of Ficus gomelleira. Their structures were elucidated by spectroscopic methods and comparison with literature data.

Slurry sampling in combination with flame atomic absorption spectrometry was employed for the direct determination of four essential trace elements, namely Cu, Fe, Mn and Zn in Antarctic krill. The effect of instrumental operating conditions and slurry sampling preparation on the analytical signal was investigated. For the determination of Cu, Fe and Zn, samples were suspended in a solution containing 2 mol L-1 HNO3. In the case of Mn, 4 mol L-1 HNO3 was necessary for the preparation of the slurry. The precision between sample replicates was better than 5%. The method was applied to the direct determination of Cu, Fe, Mn and Zn in Antarctic krill samples using aqueous reference solutions to prepare the calibration curves. The results obtained were in good agreement with those achieved by FAAS and ICP-AES after microwave-assisted wet digestion of the krill samples. The detection limits were 4.5, 1.0, 4.9 and 8.4 mug L-1 for Cu, Zn, Mn and Fe, respectively.

A new coumarin, 5,6-methylenedioxy-7,8-dimethoxycoumarin has been isolated from the stems of Metrodorea flavida, as well as known coumarins and alkaloids. The structures of the new and the known compounds were established by spectral data and by comparison with the literature data.