Search

A highly efficient, nanostructured, solar-responsive zinc-oxide (SRZO) photoanode has been achieved by utilization of a versatile solution precursor plasma spray (SPPS) deposition technique. For the first time, it is demonstrated that a front-illumination type SRZO photo-anode fabricated with a ZnO/stainless steel (SS-304) configuration can generate an enhanced photo-electrochemical (PEC) current of 390 μA cm -2 , under solar radiation from a solar simulator with an AM1.5 global filter (∼1 sun). The SRZO electrode displayed a solar-to-hydrogen (STH) conversion efficiency of 2.32% when investigated for H 2 evolution in a PEC cell. These electrodes exhibited a maximum peak efficiency of 86% using 320 nm photons during incident photon-to-current conversion efficiency measurement. Interestingly, the film lattice of SRZO showed a significant red-shift of 0.37 eV in the ZnO band gap thereby providing solar photon absorptivity to SRZO. Further, an enhanced charge transport property by virtue of increased donor density (∼4.11 × 10 17 cm -3 ) has been observed, which is higher by an order of magnitude than that of its bulk counterpart. Efficient optical absorption of solar photons and higher donor-density of SRZO have been thus attributed to its superior PEC performance., Competing Interests: There are no conflicts to declare., (This journal is © The Royal Society of Chemistry.)

To improve the limited efficiency and stability of CdS photoanodes in a photoelectrochemical (PEC) cell, the nanostructured CdS photoanode was modified with Ni(OH)2, NiO, Co(OH)2, and Co3O4 water-oxidation-nano co-catalysts (WOC). Co(OH)2 nanorice and Ni(OH)2 nanosheet co-catalysts were obtained by a simple chemical precipitation method. Modification by the co-catalysts gives longer stability (>8 h) to CdS electrodes, and facilitates impulsive H2 evolution in PEC cells. Nano-NiO modification yields a two-fold increase in photocurrent density and the highest H2 evolution of 2.5 mmol h(-1). A dual role for Ni related co-catalysts over CdS surface, that is forming a p-n junction and acting as an effective co-catalyst, improves the photocurrent and hydrogen evolution rate, respectively. Improvement in stability was measured using X-ray photoelectron spectroscopy and prolong chronoamperometry measurements. The present report focuses on exploration of chemically synthesized earth-abundant and cost-effective co-catalysts for PEC H2 generation.

A bulk heterojunction photocatalyst of interfacing CaFe(2)O(4) and MgFe(2)O(4) nanoparticles is highly active for oxidative degradation of isopropyl alcohol and hydrogen production from water under visible light, because the exciton easily reaches the interface and dissociates to minimize recombination.

Nitrogen-doped perovskite type materials, Sr2Nb2O7-xNx (0, 1.5 < x < 2.8), have been studied as visible light-active photocatalysts for hydrogen production from methanol-water mixtures. Nitrogen doping in Sr2Nb2O7 red-shifted the light absorption edge into the visible light range and induced visible light photocatalytic activity. There existed an optimum amount of nitrogen doping that showed the maximum rate of hydrogen production. Among the potential variables that might cause this activity variation, the crystal structure appeared to be the most important. Thus, as the extent of N-doping increased, the original orthorhombic structure of the layered perovskite was transformed into an unlayered cubic oxynitride structure. The most active catalytic phase was an intermediate phase still maintaining the original layered perovskite structure, but with a part of its oxygen replaced by nitrogen and oxygen vacancy to adjust the charge difference between oxygen and doped nitrogen. These experimental observations were explained by density functional theory calculations. Thus, in Sr2Nb2O7-xNx, N2p orbital was the main contributor to the top of the valence band, causing band gap narrowing while the bottom of conduction band due to Nb 4d orbital remained almost unchanged.