Search

Metal–organic frameworks (MOFs) have unique potential in the field of gas sensing due to their ultra-high specific surface area and abundant mesoporous structure. In this paper, a mesoporous Co3O4 hollow polyhedron structure with high specific surface area (141.6 m2 g−1) was synthesized by annealing at the optimum temperature. The gas response of the mesoporous Co3O4 hollow polyhedron structure to volatile organic compounds such as xylene, ethanol, methanol and acetone was systematically tested. The experimental results show that the mesoporous Co3O4 hollow polyhedron structure has the highest sensitivity (21.33) and excellent stability for xylene gas, and the detection limit is low (1 ppm). The excellent sensing performance benefits from large surface area, high oxygen defect concentration and mesoporous structure. [ABSTRACT FROM AUTHOR]

A europium-functionalized, dual-emissive, metal–organic framework-based fluorescence sensor (EuUCNDA) was constructed via post-synthetic modification of an UiO-66-type precursor through coordination interactions. EuUCNDA exhibited extremely high selectivity and sensitivity for malachite green (MG) with a low detection limit of 13.01 nM, a wide linear concentration range (0.05–50 μM), excellent anti-interference properties, a rapid response (<1 min), and the possibility of recycling. The good sensing performance of EuUCNDA enables the practical detection of MG in fish pond water and grass carp with good recoveries. Moreover, EuUCNDA can be reused for sensing MG and over 90% of fluorescence intensity can be restored after 7 cycles. Furthermore, EuUCNDA-embedded paper-based sensors combined with smartphone imaging afford portable and visual monitoring of MG in real samples. Notably, besides good sensing performance, EuUCNDA could efficiently remove MG from water. Hence, this work provides a recyclable and sensitive fluorescence sensor for portable, visual, rapid detection and efficient removal of MG. [ABSTRACT FROM AUTHOR]

The development of sensors with high sensitivity, selectivity, long-term stability and other excellent performances is still the focus of current research on gas sensors. In this paper, biomorphic zinc oxide composite reduced graphene oxide nanomaterials (C–Z–ZnO–rGO) based on a metal–organic framework are synthesized by an impregnation calcination method using cotton as a biological template. The microscopic morphologies and structural composition of the composites are characterized. The response value of C–Z–ZnO–rGO to acetic acid gas is much higher than that of other gas sensors. At an operating temperature of 350 °C, the C–Z–ZnO–rGO gas-sensitive sensors have a response value of 410 for 100 ppm acetic acid, a response time of 43 s, and a recovery time of 18 s, and have good repeatability and long-term stability. The response value of 2.614 for 1 ppm of acetic acid gas further indicates that the C–Z–ZnO–rGO sensor has a low detection limit. The hollow structure of the C–Z–ZnO–rGO composites has the advantages of high specific surface area, multiple pores, diverse structures and abundant active sites, which improves the adsorption performance on acetic acid gas. [ABSTRACT FROM AUTHOR]

The development of a rapid and selective method for the identification of dipicolinic acid (DPA), a specific biomarker in Bacillus anthracis spores, is of great importance for the avoidance of anthrax infection. Herein, a chain-based EuIII metal–organic framework with the formula {[Eu3(BTDB)3(μ3-OH)3(H2O)]·solvents}n (JXUST-38, H2BTDB = (benzo[c][1,2,5]thiadiazole-4,7-diyl)dibenzoic acid) was obtained using 2-fluorobenzoic acid as the pH regulator. JXUST-38 exhibits good chemical and thermal stability and can specifically recognize DPA in N,N-dimethylformamide solution through luminescence enhancement and blue-shift effects with a detection limit of 0.05 μM. Furthermore, the significant luminescence enhancement and blue shift under UV lamps are obviously observable by the naked eye. The luminescence sensing mechanism is attributed to absorbance-induced enhancement between JXUST-38 and DPA. Test paper and mixed-matrix membrane based on JXUST-38 are designed for DPA detection. In addition, the feasibility of using JXUST-38 in biosensing is discussed in detail. [ABSTRACT FROM AUTHOR]

A novel three-dimensional Eu3+-based metal–organic framework with the formula {[(CH3)2NH2][Eu(BTDI)]·H2O·DMF}n (JXUST-25) was prepared by solvothermal method based on Eu3+ and 5,5′-(benzothiadiazole-4,7-diyl)diisophthalic acid (H4BTDI) with benzothiadiazole (BTD) luminescent groups. Due to the presence of Eu3+ and organic fluorescence ligand, JXUST-25 displays turn-on and blue-shift fluorescence toward Cr3+, Al3+ and Ga3+ with limits of detection (LOD) of 0.073, 0.006 and 0.030 ppm, respectively. Interestingly, the alkaline environment can change the fluorescence of JXUST-25 toward Cr3+/Al3+/Ga3+ and the addition of HCl solution realizes the reversible change of the fluorescence of JXUST-25 toward Cr3+/Al3+/Ga3+. It is noteworthy that the fluorescent test paper and light-emitting diode lamp based on JXUST-25 can effectively detect Cr3+, Al3+ and Ga3+ by the visual changes. In addition, the turn-on and blue-shift fluorescence between JXUST-25 and M3+ ions may be caused by the host–guest interaction and the absorbance caused enhancement mechanism. [ABSTRACT FROM AUTHOR]

A novel water-stable CdII-based metal–organic framework, namely {[Cd(BIBT)(TDC)]·2H2O}n (JXUST-28, BIBT = 4,7-bi(1H-imidazol-1-yl)benzo-[2,1,3]thiadiazole and H2TDC = 2,5-thiophenedicarboxylic acid), was synthesized using a mixed-ligand strategy. Structural analysis demonstrates that JXUST-28 exhibits a two-dimensional layer structure with 4-connected sql topology. Intriguingly, JXUST-28 presents good stability in boiling water (at least 5 days), common organic solvents and aqueous solutions with different pH values of 2–12 (more than 24 hours). Furthermore, fluorescence experiments revealed that JXUST-28 could sense Hg2+ ions in aqueous solution via a quenching effect with a detection limit of 0.097 μM. Meanwhile, JXUST-28 can also be regenerated at least 5 times to detect Hg2+ ions. In addition, light-emitting diode lamps, luminescent films, and test papers of JXUST-28 have been successfully developed for practical applications. [ABSTRACT FROM AUTHOR]

The current luminescent metal-organic framework (MOF) based fluorescence detection mostly focuses on achiral molecules. The stereospecific recognition and determination of MOF-based detection remain challenging. A novel luminescent terbium-based MOF (Tb-MOF) based biosensing system with excellent performance for stereoselective detection of D-amino acids (D-AAs) was introduced in this paper. D-Amino acid oxidase catalyzes stereospecific oxidative deamination of D-AAs, producing H2O2. The generated H2O2 effectively quenches the fluorescence of Tb-MOF. Under optimum conditions, the D-AAs were detected with excellent efficiency. The linear working range was 0.5-100 mM for D-Alanine (D-Ala) and 0. 5-5 mM for D-Proline (D-Pro), respectively. The limit of detection (Ksv detection) for D-Ala and D-Pro was 0.09 mM and 0.14 mM, respectively. The detection can be performed within 30 min with high selectivity and long-term stability. The fluorescent sensing platform required simple fabrication and operation and was free from complicated reaction processes and expensive reagents. The present sensing system was successfully applied in D-AA detection in human serum with good recovery, indicating its potential application in detection in biological samples. [ABSTRACT FROM AUTHOR]

A new water-stable three-dimensional (3D) Eu(III) metal–organic framework with the formula of {[Eu3(BTDC)4(HCOO)(H2O)2]·solvents}n (JXUST-9) was successfully obtained by the solvothermal reaction of 2,1,3-benzothiadiazole-4,7-dicarboxylic acid (H2BTDC) and Eu(NO3)3·6H2O. The PXRD patterns indicate that JXUST-9 exhibits good stability when soaked in boiling water for at least 24 h. The fluorescence experiments indicate that JXUST-9 could be considered as a good multi-responsive sensing material for detecting Fe3+, MnO4− and Cr2O72− in aqueous solutions via the turn-off effect, and the detection limits are 0.94 μM, 1.23 μM and 1.23 μM, respectively. JXUST-9 can also be regenerated at least five times for sensing Fe3+, MnO4− and Cr2O72−. Moreover, a rapid detection test paper incorporated with JXUST-9 has been produced, which is helpful for carrying out visual detection of Fe3+, MnO4− and Cr2O72− in daily applications. [ABSTRACT FROM AUTHOR]

Dipicolinic acid (DPA) is an anthrax biomarker. Its serious consequences make its detection a great need. In this paper, three novel metal–organic frameworks (MOFs) with different coordination modes were synthesized by a simple solvothermal method, which can be used as highly efficient fluorescence sensors for the highly selective and sensitive trace detection of DPA. MOFs 1–3 showed rapid responses to DPA (<30 s), and the limits of detection (LODs) were calculated to be 1.01 × 10−6 M−1 (MOF 1), 1.17 × 10−6 M−1 (MOF 2) and 2.07 × 10−6 M−1 (MOF 3). DPA detection based on MOFs 1–3 in fetal bovine serum is highly reliable based on the high recovery rates (90% to 115%). Hence, the three MOF-based sensors can be used in the real-time detection of DPA. [ABSTRACT FROM AUTHOR]

A fluorescent probe based on single metal–organic framework material without additional fluorophores and active sites can significantly improve the stability of the probe for detection, and has very important application value in environmental analysis and detection. In this paper, a simple and rapid fluorescence detection method was established with Zn-MOF, which realized the highly sensitive detection of tetracycline antibiotics and NH4+ in water. The prepared Zn-MOF has abundant pores and can exist stably in water. When tetracycline antibiotics are present in Zn-MOF aqueous solution, based on the unique coordination ability between Zn and N, tetracycline antibiotics rich in N will be adsorbed into the pore canals of MOF, and aggregation-induced luminescence will occur. The original non-fluorescent Zn-MOF will immediately produce yellow fluorescence, realizing the detection of tetracycline antibiotics in water, with the limit of detection reaching 0.017 μM in a linear range of 0.02–13 μM. Zn-MOF is further used for the detection of tetracycline antibiotics in actual samples of milk and honey. Oxytetracycline (OTC) with the best fluorescence response of tetracycline antibiotics was coated on Zn-MOF to synthesize OTC@Zn-MOF fluorescent probe. NH4+ will replace the original ligand of Zn-MOF, which will disintegrate MOF and release OTC, resulting in a fluorescence decrease. Therefore, NH4+ can be detected with low limit of detection (0.038 μM) in a linear range of 0 to 3 mM. The probe is expected to be able to detect ammonia in the environment. [ABSTRACT FROM AUTHOR]

In this paper, PS (polystyrene)/Au/ZIF-8 (zeolite imidazole framework-8) hybrid structures were synthesized for the first time as novel SERS active substrates. A series of substrates were successfully prepared by changing the Au sputtering time (5 min, 8 min, 10 min, 15 min and 20 min). When the sputtering time of Au was 10 min, the 4-mercaptobenzoic acid (4-MBA) molecules on the PS/Au/ZIF-8 substrate exhibited the maximum SERS enhancement. Meanwhile, the hybrid SERS substrate exhibited good SERS reproducibility, and we successfully obtained an ultrahigh enhancement factor of 1.67 × 106. Probe molecules can be easily enriched on the surface of the PS/Au/ZIF-8 composite due to their large pore volume and the high surface area of metal organic framework (MOF) materials. ZIF-8 also guides the probe molecules to the "hot-spots" to enhance the SERS signals. Moreover, the detection limit of R6G molecules achieved was 10−12 M when PS/Au(10 min)/ZIF-8 was used as a highly sensitive SERS sensor. This strategy has brought new insights to SERS research, and has also provided a new idea for the application and development of SERS in MOF-based SERS materials and ultra-sensitive analyses. [ABSTRACT FROM AUTHOR]

Ratiometric fluorescent nanosensors were developed to detect mercury ions (Hg2+) using enhanced dual emissions from glutathione stabilized gold nanoclusters/indium-based metal–organic frameworks modified with cysteine (AuNCs/MIL-68(In)-NH2/Cys). The nanosensors exhibited bright pink fluorescence with AuNCs evenly distributed on MIL-68(In)-NH2. Under 370 nm excitation, the obtained sensor presented double fluorescence emission around 438 nm and 668 nm, which was attributed to MIL-68(In)-NH2 and GSH-AuNCs, respectively. The fluorescence emission was remarkably enhanced after modification with Cys. In the presence of Hg2+, the red fluorescence peak at 668 nm was quenched, while the blue fluorescence peak at 438 nm was slightly altered. The prepared AuNCs/MIL-68(In)-NH2/Cys nanosensors exhibited two linear ranges for the detection of Hg2+, namely from 20 pM to 0.2 μM and 0.2 μM to 60 μM, with a detection limit of 6.7 pM. They also presented high selectivity towards other ions and good performance in real water samples. Moreover, a radial star-shaped microfluidic paper-based analytical device (μPAD), as a straightforward and convenient platform, was successfully fabricated for the visual detection of Hg2+ with a wide detection range from 5 nM to 50 μM. [ABSTRACT FROM AUTHOR]