Search

Pool water disinfection is vital to prevent microbial pathogens. However, potentially hazardous disinfection by-products (DBP) are formed from the reaction between disinfectants and organic/inorganic precursors. The aim of this study was to evaluate the presence of DBPs in various swimming pool types in Brisbane, Australia, including outdoor, indoor and baby pools, and the dynamics after a complete water renewal. Chemical analysis of 36 regulated and commonly found DBPs and total adsorbable organic halogens as well as in vitro bioassays targeting cytotoxicity, oxidative stress and genotoxicity were used to evaluate swimming pool water quality. Dichloroacetic acid and trichloroacetic acid dominated in the pool water samples with higher levels (up to 2600 μg/L) than the health guideline values set by the Australian Drinking Water Guidelines (100 μg/L). Chlorinated DBPs occurred at higher concentrations compared to tap water, while brominated DBPs decreased gradually with increasing pool water age. Biological effects were expressed as chloroacetic acid equivalent concentrations and compared to predicted effects from chemical analysis and biological characterisation of haloacetic acids. The quantified haloacetic acids explained 35-118% of the absorbable organic halogens but less than 4% of the observed non-specific toxicity (cytotoxicity), and less than 1% of the observed oxidative stress response and genotoxicity. While the DBP concentrations in Australian pools found in this study are not likely to cause any adverse health effect, they are higher than in other countries and could be reduced by better hygiene of pool users, such as thorough showering prior to entering the pool and avoiding urination during swimming., (Copyright © 2014 Elsevier Ltd. All rights reserved.)

The traditional burning process is used to recover copper from scrapped PC board (printed circuit board) but it causes serious environmental problems. In this research a new process was developed which not only prevents pollution problems, but also maximizes the utility of all the materials on the waste board. First, the scrapped PC board was crushed and grounded, then placed in the NH3/NH5CO3 solution with aeration in order to dissolve copper. After distilling the copper NH3/NH5CO3 solution and then heating the distilled residue of copper carbonate, pure copper oxide was obtained with particle size of about 0.2 microm and the shape elliptical. The remaining solid residue after copper removal was then leached with 6N hydrochloric acid to remove tin and lead. The last residue was used as a filler in PVC plastics. The PVC plastics with PC board powder as filling material was found to have the same tensile strength as unfilled plastics, but had higher elastic modulus, higher abrasion resistance, and was cheaper.