Search

A high-efficiency proton recoil telescope was developed to determine neutron fluences in neutron fields using the 3H(d,n)4He reaction. A 2-mm thick plastic scintillation detector was employed as a radiator to increase the detection efficiency and compensate for the energy loss of the recoil proton within. Two silicon detectors were employed as the ΔE and E detectors. The distance between the radiator and the E detector was varied between 50 and 150 mm. The telescope had detection efficiencies of 3.5 × 10-3 and 7.1 × 10-4 cm2 for distances of 50 and 100 mm, respectively, which were high enough to determine the neutron fluence in 14.8-MeV neutron fields, with a few thousand cm-2 s-1 fluence rate, within a few hours.

The ambient dose equivalents H*(10) of photons mixed in the 144, 250 and 565 keV monoenergetic neutron fields were evaluated using measurements from an NaI(Tl) detector and calculations done using the MCNP-ANT code. It was found that H*(10) of the photons produced in the target assembly dominates the dose, particularly near the target. The H*(10) of the photons produced in other materials in the field increases with the increase in distance from the target and could not be neglected at a large distance from the target. The ratios of the H*(10) of the mixed photons to that of the monoenergetic neutrons for 144, 250 and 565 keV neutron fields, were evaluated to be below 5.5, 6.9 and 1.5 %, respectively. The ratios were calculated at calibration points between 100 and 500 cm from the target.

An attempt to decrease the anisotropic emissions of neutrons from a cylindrical (241)Am-Be-encapsulated X3 source was conducted with Monte Carlo calculations and experiments. The influence of metal materials and shapes of the external casing to the anisotropy factor were focussed on. Results obtained by calculations using MCNP4C implied that a light and spherical-shaped external casing decreases the anisotropic emission of neutrons. Experimental results using the spherical-shaped aluminium protection case also revealed that the anisotropy factor was close to 1.0 with wide zenith angle ranges.

The 8 and 27 keV monoenergetic neutron calibration fields have been developed by using (45)Sc(p, n)(45)Ti reaction. Protons from a 4-MV Pelletron accelerator are used to bombard a thin scandium target evaporated onto a platinum disc. The proton energies are finely adjusted to the resonance to generate the 8 and 27 keV neutrons by applying a high voltage to the target assemblies. The neutron energies were measured using the time-of-flight method with a lithium glass scintillation detector. The neutron fluences at a calibration point located at 50 cm from the target were evaluated using Bonner spheres. A long counter was placed at 2.2 m from the target and at 60 degrees to the direction of the proton beam in order to monitor the fluence at the calibration point. Fluence and dose equivalent rates at the calibration point are sufficient to calibrate many types of the neutron survey metres.

The ambient/personal dose equivalent per fluence for D(2)O moderated (252)Cf neutron source was determined by measurement. An appropriate subtraction of the scattered neutrons is required for the accurate measurement of direct neutrons. A cubic shadow object was used for the subtraction of the scattered neutrons from the surroundings. The scattered neutrons to be subtracted vary with the position of the shadow object due to the large volume of the source. Using the Monte Carlo code MCNP-4C, the optimum positions of the shadow object were surveyed for subtracting the scattered neutrons. The energy spectra of direct neutrons were measured in the optimum position. The dosimetric parameters for the D(2)O moderated (252)Cf neutron source were reasonable, taking into account the uncertainties of the parameters.

Several intercomparison exercises were organised by the International Atomic Energy Agency (IAEA) on the determination of operational quantities at the regional or interregional basis. In East Asia region, a third phase of the intercomparison finished in mid 2004. It was organised within the frame of the Regional Cooperation Agreement (RCA) as a follow-up to previous exercises carried out during 1990-1992 and 1995-1996. The results of this intercomparison for the determination of operational quantities were satisfactory for all Member States. The laboratories demonstrated a good performance in quantities tested. The purpose of this paper is to present the results of the RCA/IAEA intercomparison and the future of RCA activities in support of assessment of occupational exposure by organising intercomparison runs.

Glow curves of LiF TLDs (TLD-100) were measured for 10-40 keV monoenergetic photons from synchrotron radiation, and the energy and dose responses were evaluated based on the glow curve data. The ratio of measured to calculated energy response was almost unity for the lower temperature region of the glow curve including the main peak, and was about 2.0 for the higher one. Dose responses to 10 keV 30 keV X rays, and 60 Co gamma rays showed different supralinearity. The maximum value of supralinearity decreased with decreasing photon energy, that is, with increasing the average linear energy transfer of incident photons