Search

[EN] Passing is one of the most complex driving maneuvers performed on two-lane rural roads and has important effects on road safety and traffic operation. Passing is affected by driving behavior, road geometry, traffic volume, and traffic composition as well as external factors. Research was developed to compare the passing process under daytime and nighttime conditions. An experimental method was designed to collect video data of passing maneuvers on a two-lane rural road segment located near Valencia, Spain. Two methods were used: (a) external observations of four passing zones with six video cameras and (b) an instrumented vehicle equipped with video cameras and laser rangefinders, driven slightly below the operating speed along a segment of the same road so it would be passed by other vehicles. A total of 291 maneuvers were observed, up to 20% of which were at night. Macroscopic analysis results indicated that approximately 17% of passes were at night, even though passing frequency and passing demand decreased at night. Also, the behaviors of individual drivers who passed other vehicles were different at night and during the day. Maneuvers limited by the presence of an opposing vehicle were performed more quickly at night, even if the accepted gaps were longer. In this case, a more difficult perception of distances to opposing vehicles and of vehicle speeds explained the differences. In contrast, maneuvers limited by sight distance (without a visible opposing vehicle) were slower at night. This observation matched a traditional hypothesis: passing at night is safer because the headlights of an opposing vehicle allow a driver to anticipate the vehicle's position before it becomes visible., The authors thank the Spanish Ministry of Economy and Competitiveness for subsidizing the research project as well as the Spanish Ministry of Public Works and the Spanish General Traffic Directorate for collaboration during the field study.

The occurrence of road crashes depends on several factors, with design consistency (i.e., conformance of highway geometry to drivers' expectations) being one of the most important. A new consistency model for evaluating the performance of tangent-to-curve transitions on two-lane rural roads was developed. This model was based on the inertial consistency index (ICI) defined for each transition. The ICI was calculated at the beginning point of the curve as the difference between the average operating speed on the previous 1-km road segment (inertial operating speed) and the actual operating speed at this point. For the calibration of the ICI and its thresholds, 88 road segments, which included 1,686 tangent-to-curve transitions, were studied. The relationship between those results and the crash rate associated with each transition was analyzed. The results showed that the higher the ICI was, the higher the crash rate; thus, the probability of accidents increased. Similar results were obtained from the study of the relationship between the ICI and the weighted average crash rate of the corresponding group of transitions. A graphical and statistical analysis established that road consistency might be considered good when the ICI was lower than 10 km/h, poor when the ICI was higher than 20 km/h, and fair otherwise. A validation process that considered 20 road segments was performed. The ICI values obtained were highly correlated to the number of crashes that had occurred at the analyzed transitions. Thus, the ICI and its consistency thresholds resulted in a new approach for evaluation of consistency., The authors thank the Center for Studies and Experimentation of Public Works of the Spanish Ministry of Public Works, which partially subsidized the data collection, for obtaining the empirical operating speed profiles used in the validation process. The authors also thank the General Directorate of Public Works of the Infrastructure and Transportation Department of the Valencian government, the Valencian Province Council, and the General Directorate of Traffic of the Ministry of the Interior of the Government of Spain for their cooperation in data gathering.

Most studies on two-lane highway operations have focused on the percentage of following vehicles or the adjustment of the Highway Capacity Manual (HCM) procedure to local data. The HCM proposes the length of no-passing zones as a model parameter; however, the distribution and characteristics of passing zones are not addressed. In fact, only a few studies on the expected number of passes in a passing zone have been carried out. This research presents an analysis of the effectiveness of passing zones in terms of their length and traffic volume. Data were collected from four passing zones on a rural highway in Spain. The two-way traffic volumes ranged from 100 to 900 vehicles per hour (vph), and the passing zone lengths ranged from 265 to 1,270 m. More than 1,600 passing maneuvers were recorded. The operational effectiveness of the passing zones was obtained from the passing frequency and the passing rate. The results indicated that the longer the passing zone, the higher the passing frequency; however, the results stabilized with lengths above 1,100 m. Balanced flows with two-way traffic volumes between 600 and 700 vph optimized the number of passes. Nevertheless, the increase in the passing frequency with the traffic volume was lower than with the increase in following vehicles. The results were validated with data from another 12 passing zones. Finally, HCM adjustments based on the percentage of no-passing zones did not reliably represent the effectiveness of passing zones. Therefore, the effectiveness of every passing zone should be considered, and adjustment factors should be modified to maximize the passing opportunities for traffic volumes between 600 and 700 vph., The authors thank the Spanish Ministry of Science and Innovation, which subsidized the research project, and the Spanish Ministry of Public Works for its collaboration during the field study.