Search

XMM, ESA's X-Ray Multi-Mirror satellite, due for launch at the end of 1999 will be the first ESA scientific spacecraft to implement the ESA packet telecommand and telemetry standards and will be the first ESOC-controlled science mission to take advantage of the new flight control system infrastructure development (based on object-oriented design and distributed-system architecture) due for deployment in 1995. The implementation of the packet standards is well defined at packet transport level. However, the standard relevant to the application level (the ESA Packet Utilization Standard) covers a wide range of on-board 'services' applicable in varying degrees to the needs of XMM. In defining which parts of the ESA PUS to implement, the XMM project first considered the mission objectives and the derived operations concept and went on to identify a minimum set of packet definitions compatible with these aspects. This paper sets the scene as above and then describes the services needed for XMM and the telecommand and telemetry packet types necessary to support each service.

In February 1990, ESA began reactivation of the Giotto spacecraft, which had been dormant for the previous four years, via the omnidirectional low-gain antenna mounted atop the Giotto. By the end of April 1990, spacecraft temperatures had been reduced to levels at which the experiments could be activated; of the original complement of ten experiment modules, the magnetometer, energetic particle analyzer, and optical probe experiment were fully functional, and an additional three instruments were partly damaged but usable. A mission that targetted Comet Grigg-Skjellerup 214 million km from the earth was then put into effect.

Lunar orbiter velocity control system design, discussing interface problems between actuator electronics and flight control system

Lunar orbiter velocity control system design, discussing interface problems between actuator electronics and flight control system