Search

The Refill Friction Stir Spot Welding (RFSSW) process—an alternative solid-state joining technology—has gained momentum in the last decade for the welding of aluminum and magnesium alloys. Previous studies have addressed the influence of the RFSSW process on the microstructural and mechanical properties of the AA6061-T6 alloy. However, there is a lack of knowledge on how the tool wear influences the welding mechanical behavior for this alloy. The present work intended to evaluate and understand the influence of RFSSW tool wear on the mechanical performance of AA6061-T6 welds. Firstly, the welding parameters were optimized through the Designing of Experiments (DoE), to maximize the obtained ultimate lap shear force (ULSF) response. Following the statistical analysis, an optimized condition was found that reached a ULSF of 8.45 ± 0.08 kN. Secondly, the optimized set of welding parameters were applied to evaluate the wear undergone by the tool. The loss of worn-out material was systematically investigated by digital microscopy and the assessment of tool weight loss. Tool-wear-related microstructural and local mechanical property changes were assessed and compared with the yielded ULSF, and showed a correlation. Further investigations demonstrated the influence of tool wear on the height of the hook, which was located at the interface between the welded plates and, consequently, its effects on the observed fracture mechanisms and ULSF. These results support the understanding of tool wear mechanisms and helped to evaluate the tool lifespan for the selected commercial RFSSW tool which is used for aluminum alloys.

The present research work aimed to study the effects of cutting environments and conditions on tool wear and residual stresses induced by orthogonal cutting of AA6061-T6. Cutting environments included dry- and flood-coolant modes and cutting conditions consisted of cutting speed and feed rate. A 2D finite element (FE) model was developed to predict tool wear and residual stresses and was validated by experimental measurements including machining forces, tool wear, and residual stresses. This was obtained by exploring various magnitudes of the shear friction factor and heat transfer coefficient and choosing proper coefficients using the calibration of the predicted results with the measured ones. The experimental results showed that the effect of cutting environment including dry and flood-coolant modes was negligible on machining forces. The experimental investigation also demonstrated that increasing feed rate raised machining forces, tool wear and residual stresses in both cutting environments. Low Speed Cutting (LSC) led to the highest value of tool wear and High Speed Cutting (HSC) provided the lowest values of resultant machining forces and residual stresses in both modes. Flood-coolant mode reduced tool wear and slightly decreased tensile residual stresses in comparison with dry mode. As a result, low feed rate and high-speed cutting under flood-coolant mode were proposed in order to improve tool wear and residual stress in orthogonal cutting of AA6061-T6.