Search

Mathematical models for the simulation of the operation of various projectile-throwing systems are continuously modified, simultaneously with the development of propellants. For these models, properly determined values of energetic ballistic characteristics of propellants are very important. This paper presents an original test and the results of closed vessel comparative investigations. The study analyses specific combustion characteristics of single-base propellants using conventional black powder ignition, plasma ignition, and gas ignition. The results of the study indicate the need to take into account—in the calculation of the burning rate—not only the dynamics of gas pressure changes but also the real (experimental) form function, which differs from the theoretical one resulting from the assumed geometric burning model. The obtained results allow for a critical analysis of the existing methods used for the determination of values of ballistic characteristics of propellants. Further, it will allow for creating pyrostatic test conditions that would reflect the condition of instantaneous ignition of propellant grains over their entire surface in the most realistic way.

The combustible cartridge case has become an integral part of many modern weapons systems. The energetic and burning characteristics of the combustible case can have a significant impact on shot parameters. This paper describes Closed Vessel Tests (CVTs) performed on combustible cartridge case material and presents a method of determining the physical burning law and the linear burning rate of the tested material. The method was verified on the basis of the results of CVT of the felted combustible cartridge case material of a 120 mm tank round. It is shown that, in the case of porous combustible materials, the standard methods of determining the burning rate fail. The porosity of combustible materials greatly increases the burning surface and heat feedback from the burning zone to the unburned structure. These effects significantly increase the burning rate of porous materials. The results of analysis show the strong dependence of the burning rate on pressure. The results of this study can be applied in the modeling of gun propellant systems that contain combustible case elements.

This paper presents the method of determining the burning rate of fine-grained propellants based on the results of closed vessel tests. It is shown that in the case of fine-grained propellants, the standard methods of determining the burning rate fail. There are two reasons for this: imperfections of the grain shapes and the prolonged process of ignition due to a more developed surface than that of coarse grains at the same mass of the propellant. The value of the exponent in the burning law is estimated by the use of the so-called experimental form–function. The upper and lower limits of the value of the coefficient in the burning law are estimated. The accuracy of the proposed method is analyzed. Its validity is assessed by comparing the results of closed vessel tests analysis with accessible literature data.

This paper presents the results of a comparative investigation into the effects of the ignition method on the ballistic properties of three types of propellants: a single-base propellant, a double-base propellant and a low vulnerability (LOVA) propellant, as determined via closed vessel tests (CVT). Conventional gunpowder ignition and plasma jet ignition methods were used. The influence of the ignition method on the values of the propellant characteristics obtained in CVT was analysed. It was found that the method of ignition has an influence on the values of propellant characteristics, determined in CVT. An analysis of the experimental form functions showed that plasma ignition is not a solution to the problems inherent to the process of determining the ballistic properties of propellants in which the burning process deviates from the geometric burning law.