Search

The Sidi Ifni region in southwest Morocco is mainly composed of crystalline rocks with limited groundwater storage capacity. These water resources drain in particular fault zones with high fracture permeability. The main objective of this study is to describe the geological structure of the region to optimize future drilling locations. The gravity data were processed using various techniques, such as total horizontal gradient, tilt derivative, and Euler deconvolution, in conjunction with the interpretation of the geological data, to create a new structural map. This map confirms the presence of many previously identified or inferred faults and identifies significant new faults with their respective trends and depths. Analysis of this map shows that major faults are oriented NNE-SSW and NE-SW, while minor faults are oriented E-W, NW-SE, and NNW-SSE. The superposition of the hydrogeological data and the structural map reveals that the high groundwater flow values in the boreholes are located in the vicinity of the major faults and talwegs. The structures deduced from the filtering and interpretation of the gravity data suggest that the hydrogeological system of the Ifni Inlier is controlled by its structures. To confirm this impact, a high-resolution electrical resistivity map (7200 Hz) was used, with penetration depths ranging from 84 to 187 m. Negative boreholes, located in high resistivity ranges corresponding to sound basement formations without fault crossings, showed high resistivity values. The positive holes, located in anomalies with low linear resistivity, revealed the impact of fault crossings, which drain water and tend to decrease the resistivity values of the formations. Therefore, these new structural maps will assist in planning future hydrogeological studies in this area.

Groundwater from alluvial aquifers is a critical source of water supply for rural agriculture, particularly in semi-arid and arid regions. Effective management of these aquifers requires an understanding of the factors that influence their water resources. In this study, we present a case study of the Tata watershed in southeastern Morocco, where the economy is heavily dependent on agriculture and relies exclusively on groundwater. We demonstrate the importance of integrating geological, hydrogeological, and geophysical methods to characterize the aquifer and evaluate groundwater productivity. Analysis of 64 data wells tapping into the aquifer revealed significant disparities in flow yields, ranging from 0.05 to 15.50 L per second. The highest yields were found between depths of 12 and 43 m, which correspond to the alluvium and the altered and fractured part of its substrate. The maximum alluvial thickness of 57 m was determined using geo-electrical prospecting. A piezometric map was created to define the recharge zones, which correspond to the lateral contributions of the bordering Georgian limestones, and infiltration of both rain and surface water along the Tata wadi. Since 1987, there has been a continuous drop in groundwater level, which can be attributed to the increase in irrigated areas following financial incentives provided by the Moroccan government to the agricultural sector. A proposal has been made for the construction of a recharge dam to enable the recharge of the alluvial aquifer. This development is expected to serve a dual purpose by mitigating the deleterious impacts of flooding and facilitating the gradual water infiltration of the alluvial aquifer. This case study provides insights into the hydrodynamics of the aquifer and establishes a simplified model of its functioning. These findings have important implications for the management of alluvial aquifers in similar regions.

This study aimed to evaluate the extent and severity of water erosion in the Toudgha river catchment in the Central High Atlas of Morocco using two different erosion models, the Erosion Potential Model (EPM) and the Priority Actions Programme/Regional Activity Centre (PAP/RAC) model. From the modeling results, the catchment was affected by varying degrees of erosion, ranging from “very slight” to “excessive”, with different locations identified under each model. The very high erosion areas were located in the extreme northwest of the catchment area for both of the applied models, covering 9.65% (according to PAP/RAC) and 8.56% (EPM) of the total area primarily driven by factors such as intense rainfall events, limited vegetation cover, high soil erodibility due to low organic matter content and coarser soil texture, and human activities such as overgrazing and land use changes, which exacerbate the effects of these natural factors on water erosion in these semi-arid areas. The study’s findings suggest that erosion is a significant concern in these environmental areas and provide valuable information for designing effective erosion control measures and guiding soil and environmental management practices. Both models effectively simulated the erosion phenomenon and provided useful tools for soil and environmental management. The EPM model can be used to design effective erosion control measures, while the PAP/RAC model can be used to develop a comprehensive strategy for the sustainable management of the catchment area. These results have implications for the implementation of effective erosion control measures in mountainous watersheds and highlight the need for further research in this area.

In semi-arid regions such as the southwestern zone of Morocco, better management of water resources is crucial due to the frequent flooding phenomena. In this context, the use of hydrological models is becoming increasingly important, specifically in the Aguenza watershed. A multitude of hydrological models are available to make very efficient modeling, and from this perspective, a comparative approach was adopted using two models with different characteristics. Streamflow simulations were carried out continuously at daily time steps using GR4J and ATHYS (2002–2011). The latter was used also to simulate rainfall-runoff events (1984–2014). Simulation results using the distributed model are very efficient compared to those obtained by the lumped model “GR4J”, which shows the disadvantages of neglecting the hydrological processes during a hydrological study. However, a remarkable improvement was observed in the general appearance of the resulting hydrographs and the performance parameters after using the distributed model ((Calibration: NSE, RSR, and PBIAS increased successively by 8%, 6%, and 45.2%); (Validation: NSE, RSR, and PBIAS increased successively by 6%, 4%, and 8.9%)). In terms of flood event simulations, a good concordance between observed and simulated discharge was observed (NSEmedian = 0.7), indicating its great reliability for simulating rainfall-runoff events in semi-arid and data-scarce regions. This research highlights the importance of using hydrological models, specifically the distributed model ATHYS, for the better management of water resources in semi-arid regions with frequent flooding events.

An assessment of potential groundwater areas in the Ifni basin, located in the western Anti-Atlas range of Morocco, was conducted based on a multicriteria analytical approach that integrated a set of geomorphological and hydroclimatic factors influencing the availability of this resource. This approach involved the use of geographic information systems (GIS) and hierarchical analytical process (AHP) models. Different factors were classified and weighted according to their contribution to and impact on groundwater reserves. Their normalized weights were evaluated using a pairwise comparison matrix. Four classes of potentiality emerged: very high, high, moderate, and low, occupying 15.22%, 20.17%, 30.96%, and 33.65%, respectively, of the basin’s area. A groundwater potential map (GWPA) was validated by comparison with data from 134 existing water points using a receiver operating characteristic (ROC) curve. The AUC was calculated at 80%, indicating the good predictive accuracy of the AHP method. These results will enable water operators to select favorable sites with a high groundwater potential.

Copper mineralization in the Lower Paleozoic sedimentary cover of the Anti-Atlas (Morocco) is continually being revised not only to improve its mining capacity, but also to determine its origin, which remains a matter of debate. As evidenced by the various models proposed, the related research is fragmented, localized, and confusing. The origin of the Anti-Atlas Lower Paleozoic copper mineralization is shared between synergistic and epigenetic processes or a superposition of the two processes. Based on new tectono-magmatic data and a reinterpretation of the ore structural arrangement, we propose a link between the last concentration of copper deposits and the Late Triassic–Early Liassic CAMP (Central Atlantic Magmatic Province) tectono-thermal event, as evidenced by the significant concentration of copper mineralization in the three NE–SW corridors affected by extensional faults, some of which are filled with dolerite CAMP magma. The heat flow generated by the mafic dykes within these reactivated corridors causes mineralized fluids to up well into the sedimentary layers, depositing material rich in juvenile or leached copper, or even a mixture of the two. In some cases, these fluids are trapped by fracture systems that accompany passive folds initiated on normal faults. In other cases, these fluids can infiltrate bedding planes, and even karst caves, formed during carbonate exhumation. Notably, extensive NE–SW faults systematically cover the early Hercynian structures, suggesting that they belong to a post-Hercynian extensional episode. During the Late Triassic, the global fragmentation of the Pangaea supercontinent was manifested by the stretching of the continental crust at the margin of northwest Africa, with the simultaneous opening of the Central Atlantic Ocean and emplacement of CAMP magmatism. This last and often overlooked tectonothermal event must be considered in the remobilization and reconcentration of copper mineralization and other mineralization in Morocco.